Question about Cars & Trucks

Open Question

What does this code mean: FOA 900.00 ZT - Cars & Trucks

Posted by Anonymous on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How can I bay a Radiator foa a car 2002 Buick Century

go to a radiator shop
they have plenty available

Oct 25, 2017 | Buick Cars & Trucks

1 Answer

Rover 25 noisy engine start-up

Heat engine to operating temp, add a good oil flush for 30 mins at 1500rpm.
Drain oil and fit new filter. Add correct engine oil...good quality stuff.
Run car and repeat this every 4 months foa year

Apr 23, 2014 | 2004 Rover 25 2.0

1 Answer

Caldina zt

1az-fse engine p1653 scv fault .how to repair

Mar 31, 2014 | Toyota Corolla Cars & Trucks

1 Answer

Where is bonnett release located on mg tf

in the boot on the right as you look

Aug 02, 2012 | 2003 MG ZT-T

1 Answer

How to change shock absorbers on a mg zt

Rear shocks would be in the boot or back seat - just unbolt and replace, you will have to remove both wheels. Front shocks may need a spring compressor if the shocks are inside the road spring, DO NOT ATTEMPT FRONT SHOCKS WITHOUT A SPRING COMPRESSOR YOU WILL GET SERIOUSLY HURT!!!

Feb 11, 2012 | 2006 MG ZT CDTi

1 Answer

01 focus,2.0 DOHC ZT,Crapping out under acceleration or under load on hills,Changed fuel pump,Checked for vaccuum leaks,No codes no light,I have a streaming reader and everthing appears to read right.I am...

Under a load or uphill,would suggest that a high vacuum signal was involved. So think EGR Valve. I know you got no codes. This is an exercise in logic.
A misfire will present it'self going up hill or loading the engine. e.g. hard on the gas
What has no sensor or won't set a code easily. Vacuum leaks,air filter,all air intake ducting,MAF Sensor,Throttle Position Sensor and don't forget those really small EVAP Leaks,most people never heard of.
Is the converter partially blocked?
O2 Sensors switching properly?
Fuel pressure,under a load? New fuel filter?

May 28, 2010 | 2001 Ford Focus

1 Answer


There are speed sensors for the abs in the front wheel bearing assemblies. Rust builds up and changes the air gap between the speed sensor and the reluctor ring inside of the hub. The rust needs to be cleaned away to restore the proper air gap it fix the problem.

Sep 03, 2008 | 1997 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79123 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

13723 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides