Question about 1994 Lexus GS 300

1 Answer

Does the 1994 lexus cs 300 have a shut off system if the radiator has no water in it? the water hose broke and the radiotor is waterless it's a car we're considering buying

Doesthe94 lexus cs 300 have a shut off system if the radiator has no water in it? the water hose broke and the radiotor is waterless it's a car we're considering buying

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 413 Answers

Don't buy it, you don't know what happened after the hose broke.

Posted on May 09, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Radiator hose is soft when motor is warm


Without knowing if there has been any "Cooling System " work on car. (1) U could have a stuck thermostat, air in cooling system, water pump or impeller damaged. (2) top hose is coolant from engine TO radiator (3) bottom hose is coolant from radiator pulled into engine. (4) engine is WARM but is it RUNNING ? (5). Also, if radiator/coolant tank cap is left off , system is unable to pressurize , there fore "SOFT HOSES". all this is guessing without more info. bigAl

May 27, 2014 | 1998 Lexus ES 300

1 Answer

1995 lexus es 300 . I have replaced the water pump. the thermostat, the radiator and it runs at normal temperature, but when I shut the engine I hear it gargleing, like it`s a little hot. what do I do to...


Make sure your radiator cap is new as well. I sounds like you may have to bleed the air out of the system. There is a bleeder screw near the water inlet neck that is for this purpose.

Nov 08, 2011 | 1995 Lexus ES 300

1 Answer

Looking for detialed instructions to replace the water pump on a 1996 Lexus es 300


REPLACE WATER PUMP.DRAIN THE COOLING SYSTEM.DISCONNECT THE RADIATOR INLET HOSE FROM THE INLET PIPE. REMOVE TIMING BELT FROM THE WATER PUMP PULLEY.REMOVE THE WATER INLET HOUSING AND THERMOSTAT.REMOVE THE MOUNTING BOLTS AND STUDS. LIFT OUT THE WATER PUMP BY CAREFULLY PRYING BETWEEN THE PUMP AND THE CYLINDER HEAD.REMOVEOLD PACKING AND CLEAN THE MOUNTING SURFACES. INSTALL NEW SEAL PACKING TO THE WATER PUMP GROOVE AND NEW O - RING TO THE WATER BYPASS PIPE.INSTALL NEW WATER PUMP TORQUE BOLTS 14 FT LBS.

Sep 06, 2011 | 1996 Lexus ES 300

1 Answer

1994 Lexus ES300 overheats after a few miles and water pours out of the radiator coolant reserve tank. Radiator rebuilt 6 months ago. New radiator hoses and other water hoses within last year. Please...


a cracked block or bad gasket can result in compression bleeding into your cooling jacket causing the symptom you describe. a good shop has a tester to determine if there is compression residue in your coolant. that would be a place to start.

Jul 06, 2011 | 1994 Lexus Es 300

1 Answer

How do I change the thermostat on a 1994 LEXUS ES 300


On 1994 Lexus ES300 3.0L MFI DOHC 6cyl the Thermostat is located under hood, passenger side, upper engine area, engine end of upper radiator hose, mounted in coolant outlet housing, you need to take off this componentes to access this.

Hope helps.

Nov 22, 2010 | 1994 Lexus Es 300

2 Answers

Where is the thermostat located in a 93 lexus gs 300


The thermostat is located on the side of the engine block which follow the bottom radiator hose, it should have 2 nuts on it. You should also temporary remove the air intake hose for ease of access and remove the thermostat.

Nov 18, 2009 | 1994 Lexus GS 300

1 Answer

What is the cost of a 90000 mile service for a Lexus RX 300?


$700

timing belt
idler pulley
water pump
timing belt tensioner
valve cam gasket
coolant flush
spark plug
oil change
pcv valve
tranny oil change
differential fluid cahnge
drive belt
upper/lower radiator hose
brake system flush
air filter

good luck,i hope this help pls dont forget to rate me thanks

Jun 05, 2009 | 2001 Lexus RX 300

1 Answer

Over heating


What do you mean your top hose to the radiator is not comming to it? Are you saying that the hose is cool to the touch and not circulating fluid? If so, you're thermostat is probably stuck shut and needs replaced.

Jan 14, 2009 | 1993 Lexus Es 300

1 Answer

RADIATOR REPLACEMENT


  • At the time of installation, please refer to the following items.
  • Start the engine, and check for coolant and A/T fluid leaks.
  • Check the A/T fluid level.
  1. Drain engine coolant.
  2. Canada: Disconnect relay block (for daytime running light system) from battery hold-down clamp.
  3. Disconnect upper radiator hose from radiator.
  4. Disconnect lower radiator hose from water inlet pipe.
  5. Disconnect A/T oil cooler hoses from oil cooler pipes.
  6. Disconnect No.1 and No.2 cooling fan connectors.
  7. Disconnect No.1 Engine Coolant Temperature (ECT) switch wire connector.

  8. Remove radiator and cooling fans assembly.
    1. Remove the 2 bolts and 2 upper supports. Torque: 12.8 Nm (9 ft. lbs.)
    2. Lift out the radiator, and remove the radiator and cooling fans assembly.
    3. Remove the 2 lower supports.
  1. Remove A/T Oil cooler hoses from radiator.
  2. Remove lower radiator hose from radiator.
  3. Remove No.1 ECT switch.

  4. Remove No.1 cooling fan from radiator. Remove the 2 bolts and cooling fan. Torque: 5.0 Nm (44 inch lbs.)
  5. Remove No.2 cooling fan from radiator. Remove the 3 bolts and cooling fan. Torque: 5.0 Nm (44 inch lbs.)
INSTALLATION
Installation is in the reverse order of removal.

Nov 06, 2008 | 1992 Lexus Es 300

Not finding what you are looking for?
1994 Lexus GS 300 Logo

Related Topics:

220 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

874 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...