Turn the seat belt buzzer off

I would say no. There is a recommended weight for passengers for this reason. If there is an issue with your SRS system, I recommend getting to a qualified technician soon.

there is a TSB available if you're under 60,000 miles take it the dealer.

light occurs when:The center airbag sensor assembly receives an open circuit signal in the side squib (front passenger side) circuit for 2 seconds.

possible trouble areas include:Front seat airbag assembly RH (side squib (front passenger side)), Center airbag sensor assembly, & No. 2 floor wire.

Look for garbage in the drivers seat buckle.

Make sure there is no heavy weight in the passenger seat.

You likely need a seat buckle, but could be wiring.

you can not it part of the cars warning system

First check to ensure the window locks are not on. If they are on simply turn them off and that should resolve your problem. However, I know there are situations in which if you had the battery disconnect it will cause this. Consequently disconnecting the battery can also fix the situation and then follow the below instructions. Or try the passenger side window switch first.

1. Reconnect the battery terminal or fuse.
   
   
2. Turn ON the ignition switch.
   
   
3. Lower the window of each door halfway or more with the power window switch.
   
   
4. Then close the window fully with the power window switch.
   
   
5. Do not release the switch for at least 2 seconds after the window is fully closed.

Thanks

need to have a tech look at this air bags can be dangerous if not repaired correctly sorry

plug it in or keep stuff off of passenger side

the seat belt retracter is jammed need to be replaced unles you dropped something into it and it jammed, like change? give me a shout back. wish you the best.

thats cause that what the lock is for so it wont go down

Buzzer Reminder Cancel Mode Setting
1) Set the LCD on the combination meter to the ODO display.
2) Press and hold the TRIP meter reset knob for ten seconds or more within six seconds of turning the
ignition switch to the ON position. Fastening the drivers seat belt while holding the knob cancels the
buzzer reminder.
3) When this occurs, the LCD displays -OFF. The buzzer reminder can be switched between ON and
OFF each time the TRIP meter reset knob is pressed. The LCD displays -ON or -OFF according to the buzzer reminder ON/OFF status. The display changes to the ODO or TRIP meter if the knob
is not pressed for ten seconds.
4) Performing steps 1) and 2) again when the buzzer reminder is off exits cancel mode.
5) The cancel mode will also exit when the battery or combination meter connector is reconnected.