Question about 1993 Cadillac DeVille

Open Question

How to change license plate lights on a 1993 cadillac deville

Change the license plate lights

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: licence light replacement 1996 Cadillac Deville

remove your license and behind it you will find i think two screws then remove that panel and you should be able to get to it.

Posted on Jan 29, 2009

landsend
  • 1066 Answers

SOURCE: bulb burnt out on license plate

you need the remove the lighting fixture first to access the bulbs.

Posted on Mar 22, 2009

SUPERMAN_B_1
  • 294 Answers

SOURCE: fuel filter replacement 1993 Cadillac Deville

hello. it should be located under your car on a line that's coming off your fuel tank and yes you can do this your self very easy to do ,you'll need a few box/open ended wrenches that's it you'll need to check the fitting or the nut on each side of the filter to see what the sizes are,befor removing the filter you'll want to take off your gas cap and remove your neg battery cable ,not when you find the filter it'll have nut on each side all you have to do it loosen them but make sure that you don't break the fuel line or kink it and after you have both sides loose then just finish turning them off and there you go the filter is off, nope no removing the gas tank some newer models you do and the filter is attached to your fuel pump and don't need replaced but for your car and year you wont need to remove the tank. good luck

Posted on Mar 25, 2009

  • 2 Answers

SOURCE: problem with 1993 cadillac deville sss light comes

This problem only exists on cars with the electronic suspension option. Service SSS light comes on when the valving motor in the strut fails to move as commanded. This is usually signs of a failing strut. If you clear the code, it may function OK for a time but its days are probably numbered. New replacements are only available through GM and may run in excess of $500 each. Cadillac service bulletin # 00-03-11-001A has details of replacing these with standard struts and disabling the SSS computer.

Posted on Feb 02, 2010

adegboyega
  • 158 Answers

SOURCE: replace the license plate light bulb-'99 cad

Hello,

Please follow the instructions below carefully to change the bulbs in the licence plate of your cad deville;
1.All you have to do is put a flat blade screw driver on the right side of the bulb housing and gently push to the left. This will release the catch holding it in and it will drop out and down on the end of its wiring connector.

2.1/4 turn the bulb and remove. Replace the bulb and just put the housing back into the opening left side first, then just push up on the right side till you hear a click. Takes about 1 min per light. Works for all Deville types from 99-08

Good luck.

Posted on Aug 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i replace the license plate light bulb on a 2003 cadillac deville


To get at it, you will need to pull the license plate bezel by removing the retaining nuts inside the trunk.

Mar 31, 2015 | 2003 Cadillac Deville

1 Answer

How to install front license plate 2001 deville


First you need a license plate bracket that mounts to the bumper, and then you screw the license plate to the bracket.

Feb 24, 2015 | 2001 Cadillac DeVille

1 Answer

No ac no heat no power to the to or maybe from the dash control panel


There are 6 bolts that hold the rear trunk panel on the trunk itself: 4 behind the license plate on the outside of the trunk and two inside the trunk panel trim.
1. Remove the license place from the DeVille rear trunk panel.
2. Remove the 4 bolts located below the license plate.
3. Remove the trunk panel (felt) trim inside the trunk.
4. There is a small bolt on each side of inside trunk panel (4mm I believe). Remove them. Each will have a rubber washer on them so you'll know you are removing the correct bolt.
5. From the outside of the trunk, lift out the rear trunk panel. The license plate light (and reverse lights) are removed by turning the light assemblies counter clockwise.

Aug 27, 2013 | 1997 Cadillac DeVille

1 Answer

How to change a 94 cadillac deville licence plate light


Hello: First remove the license plate, Then remove the screws that hold the the plate that is behind where the license plate.

Nov 03, 2010 | 1994 Cadillac DeVille

1 Answer

License plate light 2003 Deville


You have to pry underneath the outer left plastic edge of the light with a small precision flat screwdriver to hit the tab thing on the left inside and push towards the right, then pull light housing outwards. You can see the tab through the clear lens. if you have a license plate frame, you will need to remove that first.

Sep 03, 2009 | 1995 Cadillac DeVille

1 Answer

Having problems getting access to my license plate bulbs to replace them


  • well for this you will have to remove the whole license plate holder, first you will need to remove the licence plate and locate & remove the four screws that are holding the part after that you will have to locate about five other screws located inside the trunk then you can remove the part bottom first and you will have acces to the license plate lights and reverse lights.

Apr 26, 2009 | 1995 Cadillac DeVille

2 Answers

Bulb burnt out on license plate


you need the remove the lighting fixture first to access the bulbs.

Mar 19, 2009 | 2002 Cadillac Deville

2 Answers

License plate bulb on 1997 Cadillac deville


this is straight out of the book ok



  1. Open the rear compartment lid.
  2. Remove the rear compartment lid trim.
  3. Pull back on the rear compartment trim panel.
  4. Unplug the lamp connector from the rear compartment lid wiring harness.
  5. Press the grommet out of the rear compartment lid.
  6. Remove the nuts retaining the lamp assembly to the rear compartment lid.
  7. Remove the bulb.

Mar 07, 2009 | 1997 Cadillac DeVille

3 Answers

Licence light replacement 1996 Cadillac Deville


remove your license and behind it you will find i think two screws then remove that panel and you should be able to get to it.

Jan 22, 2009 | 1996 Cadillac DeVille

1 Answer

Licence light replacement


Remove license plate, remove screws and detach license plate pocket assembly. Rotate bulb holder, pull bulb straight out and replace.

Jan 22, 2009 | 1996 Cadillac DeVille

Not finding what you are looking for?
1993 Cadillac DeVille Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...