Question about Nissan Cars & Trucks

Open Question

WHERE IS THE FUEL CUTOFF BUTTON ON THE NISSAN INTERSTAR

THE VEHICLE WONT START FOR SOME UNKNOWN REASON, WHERE IS THE FUEL CUTOFF BUTTON LOCATED ON THE NISSAN INTERSTAR

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75797 Answers

SOURCE: 93 Probe with the fuel cutoff light on

  • Replace the fuel cut-off switch and make sure the connector to it is not melted looking.

Posted on Nov 23, 2008

  • 2 Answers

SOURCE: 1998 nissan sentra cranks but wont start parks but no fuel.

Just had the same problem. replaced cap rotor, plugs wires..etc. still would crank no start. i got really angry with this so i went old skool on it, and treated it like my 1975 chevy one ton.  I hammered the gas and cranked it till it sputtered and eventually started. note: by pressing the gas to the floor and cranking will put computer in recovery mode and not let new fuel in to the engine. now it is able to try to burn all the left over fuel sitting in each cylinder. after about 45sec. to a min of cranking she started to come to life again. one other problem did come up. after blowing out all the extra fuel and ****, it did blow my pre-cat o2 sensor. no big deal $45.00 at checker. hope this helps

Posted on Jan 20, 2009

mcgyver468
  • 710 Answers

SOURCE: whe is the fuel cutoff valve , located on my 2004

THE TWO MOST COMMON LOCATIONS ARE ON THE PASSENGER SIDE FRONT KICKPLATE UNDER THE GLOVEBOX. OR IN THE REAR OF THE VEHICLE NEXT TO THE JACK AND TIRETOOL. I HOPE THIS HELPS YOU. PLEASE KEEP ME POSTED. THANKS FOR AN HONEST RATING AND FOR USING FIX-YA. GOOD LUCK

Posted on May 19, 2009

  • 1348 Answers

SOURCE: 2000 nissan xterra won't start

is there spark and fuel pressure?.....disconnect one spark plug and put a spark tester to verify.,if there is spark,then remove the air intake hose from the throttle body and spray fuel into the throttle body,if the engine starts,then dies,you have a fuel delivery problem.if you have hit something,check the wiring to the fuel pump,which is in the fuel tank.if you have 200000km,chances are the fuel pump is no good.sometimes banging on the tank will get it to start up again.you can also disconnect the inlet to the fuel filter using what is called a line wrench .if fuel sprays out,there is pressure there.wear glasses,fuel is under quite a bit of pressure.

Posted on May 22, 2009

Outofworkjoe
  • 216 Answers

SOURCE: no start,getting spark no fuel,pump replaced 1992

Frist check your fuses.

Posted on Sep 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 ford Aerostar fuel pump comes on with key and immediately goes off. Vehicle will not start ?


Fuel pumps only come on for a second to pressurize the system. Not uncommon to here it for a second before engine starts. I've got a Nissan that does it that way. Not saying they all are that way, but it doesn't mean the pump is bad.

Apr 19, 2017 | Ford Cars & Trucks

1 Answer

How can i bypass the computerbox on my Nissan Interstar 2008 model


Sorry but the vehicle won't work with out Engine computer .

Oct 26, 2016 | Nissan Cars & Trucks

1 Answer

Nissan Civilian CO sensors


think this is about air quailty

cant find the listing for co sensors on the nissan civilain

these sensors fit the nissan interstar bus 2006

Sensors NISSAN INTERSTAR Bus X70 dCi 150 107 KW 145 PS from 2006 Electrics
26220085-rbhpigkjbg41n3t3ajiek4my-1-0.jpg

Jun 17, 2016 | Nissan Cars & Trucks

1 Answer

Nissan terstar dci 120 not starting flashing red stop light


no year, now that makes for a long story, huh?
what is a terstar?
you ment , INTERSTAR (so says google.)??????
a VAN.
ouch wiki is only in German....
2003-10 (transated)
Analogous to the revision of the Renault Master II / Opel Movano I also received the Interstar 2003 a revision of the body, engines and interior. Since then, an automated manual transmission (Interstar X70) was for the revised model now available and optional ESP (vehicle dynamics control) available. Also belonged from now a Brake Assist besides the previously installed anti-lock braking system standard on all models. Since then, the Interstar has been delivered as a minibus with up to 16 seats. 2010, the Interstar was replaced by the Nissan NV400.

NO START.
but to start any DIESEL engine,
IT MUST Crank first. does it?
if NOT, the the battery is dead, or bad. (or discharged)
DOes jumper cables used, (donor car) crank engine now?
if it DOES, crank, and robustly, then Id bet the glow plugs are bad.
if not glow plugs, lack of FUEL , ever change the filters per schedule>?

open glove box, extract the operators guide, I PROMISE
it tells you what the RED lamp means..
if lost , get one. from NISSAN , they are free.

Jul 04, 2014 | Cars & Trucks

1 Answer

No power to excite fuel pump relay 1987 300zx turbo


Check the fuel system inertial switch (collision cutoff switch), located in the trunk. It should have a reset button. Push it. If that does not work, try BYPASSING the switch to see if the pump works then. If it does, replace the switch.

Apr 11, 2014 | 1987 Nissan 300ZX

1 Answer

2005 JAGUAR S TYPE TURNS OVER BUT WONT START AFTER ACCIDENT DOES IT HAVE FUEL CUTOFF SWITCH AND WHERE IS IT LOCATED


You likely tripped the Fuel Shut-Off Inertia Switch.
The inertia switch is located behind the trim on the right-hand
side of the vehicle, forward of the front door post, below the
fascia. Pull open the small panel in the trim to reset the switch.
Resetting the switch
CAUTION !!!:
To avoid the possibility of fire or personal injury, do not
reset the inertia switch if you see or smell fuel.
If no fuel leak is apparent, reset the inertia switch as follows:
Press the button!
If the switch was activated by the accident, you should feel it "click" when you reset it by pushing it.

Happy Motoring!

Jan 24, 2014 | 2005 Jaguar S-Type

1 Answer

Nissan interstar wont start


There are hundreds of reasons why a car will not start, you need to give much more detail to your request

Sep 26, 2013 | 1986 Mitsubishi Montero

1 Answer

Where is located the fuel pump relay on ford windstar 2002


.Here's a picture of it.1999-2003 Reset Button location
The switch is located inside the jack storage compartment found at the right rear corner of the vehicle. Remove the cover and it is behind the thin "foam" covering inside the compartment towards the rear of the vehicle.

It has a red button on the top of the switch, make sure the button is fully depressed. If it is and the vehicle still won't start check fuel pressure at the rail (there is a port on the rail which is under the hood on the engine) with a fuel pressure gauge. If the pressure is ok (about 30 psi) the problem is most likely not fuel system related.
The emergency fuel pump cutoff switch, also known as the inertia switch, cuts power to the fuel pump in the event of an accident - even a slow speed one - any sudden "jolt" can trigger the switch.

Jan 14, 2013 | Cars & Trucks

2 Answers

Is there a reset button on this fuel pump


CHEVY DOESN'T USE A FUEL PUMP RESET/CUTOFF SWITCH, FORDS USE THIS FEATURE, ON A CHEVY IT IS DONE WITH THE OIL PRESSURE CUTOFF SWITCH, SO IF U LOOSE OIL PRESSURE THE FUEL PUMP CUTS OFF, THIS OIL PRESSURE FUEL PUMP CUTOFF SWITCH AND IT'S WIRING ARE NEAR THE OIL FUILTER UNDER THE TRUCK.

Apr 21, 2010 | 2000 Chevrolet Blazer

4 Answers

Hi i got a nissan interstar diesel 2007 mod when i start it hot or cold i need a small squirt of kwikstart the van olso cut out wile driving if i turn the key of and on again it emediatly start.


To me like some loose electrical connection is resposible for this problem. Check the battery terminals for tightness and the fuses to internal heater. There might be a halfblown fuse or loose connection which is insufficient to make it possible to start the engine, but once in motion the vibration of the var provides enough to keep the connection going to start the engine because after having started the engine, it has no active role to play until you swictch off the engine. On starting time its required. So check sor the loose connection to the heater and the compressor, both of which comes into play in starting the engine...sodeep

Aug 06, 2009 | Nissan Pathfinder Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...