Question about 2008 Saturn Astra

Open Question

Replaced MFS on 2008 astra codes p1101 and p0068 keep coming back

Codes are reset comes back when reversing

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What is code p1101 for a Saturn astra

Intake air flow system performance

Apr 10, 2015 | Chevrolet Cars & Trucks

1 Answer

What do Fault codes P0068 mean?

P0068 means that the Throttle Position Sensor doesn't agree with the Manifold Absolute Pressure Sensor; the readings it gets from the two sensors don't make sense with each other. If someone has replaced one of those two sensors, they may have put the wrong one in. Otherwise, one of those two sensors is bad... in which case your car should have given you a second error code telling which of those sensors it thinks is bad.

Jul 26, 2014 | Vauxhall Astra Cars & Trucks

1 Answer

What codes mean

Hi. Vauxhall cars are prone for air mass sensor faults.air mass sensor is mounted between air box and throttle body. Try some one with a similar car and swap as they do not need coding and will reset adaption after a couple of drive cycles. These are not cheap. Good luck.

Jul 26, 2014 | Vauxhall Astra Cars & Trucks

1 Answer

P0068, P0171, and P0446 and new ones down below

-I hate to say that but absolutely NO. If you don't know much about car. All these codes are emission code.
P0068 Mean Throttle position sensor.
P0171 Mean system too lean.
P0446 Mean evaporator emission control system has not correct flow
P0507 Mean Idle air control is too hight.
P0116 Mean engine coolant temperature.

Need to have a mechanic to check one by one to determine which part is effect before replace it.

Good luck

Mai Lor

Mar 25, 2014 | 2006 Kia Rio

1 Answer

Remote keyless entry doesn't work

use a code reader to reset the CPU program as removing the battery from the system then restoring it some times corrupts the CPU program and creates problems rather than fixing them

Mar 02, 2014 | 2008 Saturn Astra

1 Answer

2007 dodge durango p0123 and p0068

Code P0123-THROTTLE POSITION SENSOR 1 CIRCUIT HIGH and code P0068-MANIFOLD PRESSURE/THROTTLE POSITION CORRELATION. Without having the vehicle to properly test, and based on the information I have it sounds like your throttle position sensor has kicked the bucket. Replacing the sensor with a new one should solve your problem.

Nov 07, 2013 | Cars & Trucks

1 Answer

Obd code p1101 2008 astra any solutions

P1101 MAF Sensor Out Of Self Test Range./ KOER Not Able To Complete KOER Aborted
nissan consult 3

Jan 01, 2013 | 2008 Saturn Astra

1 Answer

Reset error code on 2008 accord v6

Soft reset disconneting the negative battery cable few minutes; if the code come back again, its possible that you have some problem with the sensor, wires or harnesses connections.

Keep in mind that sometimes will need OBD scanner tool to reset or delete all stored codes.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Sep 04, 2012 | 2008 Honda Accord

1 Answer

What do computer codes P0068 & P0496 mean ?

P0068 MAP/MAF is Throttle Position Correlation.In this error code:--- From the error code P0068 you have its indicating a bad throttle body or throttle actuator controller.. The 2 tps sensors inside read each other and if they differ for a few seconds or milliseconds then you get a this error code with reduced power. In some cases the new connector and wiring to the throttle actuator is required and in some cases getting the throttle body cleaned helps.---------------
And code P0496 - "Evaporative Emission System High Purge Flow".------------In this error the purge valve needs to be replaced. The purge valve is mounted on the inlet manifold under the hood.Its on the top of the intake manifold, passenger side. Two hoses (one on each side) and a wire harness on the front of it. It has a red w/blue stripe and brown w/white stripe wire harness connected to it.Remove and replace this valve.-----------------This will help.Thanks.Helpmech.

Jan 20, 2011 | 2008 Saturn Astra

1 Answer

How do i adjst the handbreak

there is a cover on the back of the handbrake (rear seat) that comes off after you pull out the two plastic screws in the rear. i was then able from the back seat to reach a wrench into the opening to tighten the nut attached to the brake cable just below the parking brake. you may need to pull up on the parking brake slightly while you turn the nut to keep the cable tight.

Jan 24, 2010 | 2008 Saturn Astra

Not finding what you are looking for?
2008 Saturn Astra Logo

184 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts


Level 3 Expert

80263 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides