Question about Cars & Trucks
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
normally 110 nueton metres. use nut lock and once you have torqued you will feel if you have to tighten it a bit more.
Posted on Aug 15, 2008
1.Flywheel - 61 to 69 Foot Pounds
2.Pressure Plate - 25 to 33 Foot Pounds
3.Bell Housing - No specs found. I would say 25 to 35 foot pounds should be sufficient.
Bolts clean on ->flywheel to crank, ->pressure plate to flywheel, and ->bell housing to back of engine, I would use TWO drops of Loctite Red threadlocker, on ALL of these bolts.
Hope you have an alignment tool for your clutch disk when you install it. Auto parts stores sell the plastic one's cheap! Saves a LOT of headaches!
Tighten the pressure plate EVENLY! Snug the bolts down until they just TOUCH, then go in a criss-cross pattern when tightening. Do the tightening in incremental stages! You turn one bolt one thread, you go across to the opposite side, and turn that bolt one thread. Keep criss-crossing so the pressure plate goes down EVENLY. (YES, it's a pain in the keister!)
If NOT, you'll have a warped pressure plate, and it will be junk!
Thanks for letting me say that, I feel better.
Posted on Jul 07, 2009
I have the specs and diagrams. If you want me to send them to you, give me your email address. Outdoorsman592003@yahoo.com
Posted on Sep 05, 2009
Tips for a great answer:
Jan 24, 2017 | Dodge Sprinter Cars & Trucks
Dec 18, 2015 | Ford Cars & Trucks
Dec 18, 2015 | Cars & Trucks
Sep 30, 2015 | Nissan Cars & Trucks
May 02, 2014 | Cars & Trucks
May 14, 2012 | Jeep Wrangler Cars & Trucks
Sep 15, 2011 | Dodge Sprinter Cars & Trucks
Oct 03, 2010 | 1982 Chevrolet El Camino
Nov 16, 2009 | 1992 Mercedes-Benz Mercedes Benz 300 Class
Jul 17, 2018 | Cars & Trucks
447 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: