Question about Honda CR-V

Open Question

Adjust idle speed honda crv

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 275 Answers

SOURCE: honda crv 2000 computer reset

Ok,
1. ensure ignition off
2 . bridge the 2 pin connector, Put a piece of wire across both terminals
3.switch ignition on
4. SRS lamp should illuminate for 6 seconds
5.disconnect the bridge wire within 4 seconds of the warning lamp extinguishing
6.SRS lamp should illuminate 2 times, Codes erased
7.switch ignition off
8 Wait 10 seconds. switch ignition on and check SRS warning lamp operation.
hope this helps

Posted on Feb 19, 2009

Ad
  • 19 Answers

SOURCE: Hi my 2004 honda crv idle speed is going up and

there is most likely a vacuum leak somewhere allowing unmetered air in .

Posted on Sep 01, 2009

csmock132
  • 4669 Answers

SOURCE: honda crv overheats when at

Check the cooling fan on the radiator. Sounds like it isn't working.

Posted on Aug 07, 2010

  • 34 Answers

SOURCE: what is the RMP for 2003 honda crv supposed to be when traveling between 60-80 mph

any car the rpm shouldn't exceed the 4000 round per minutes and you can check it from the sound of the car if it's so loud you should decrease the acceleration pad or give the next gear if it's manual
if it's automatic don't panic

Posted on Aug 23, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The owners manual says to inspect idle speed at 160,000 mi, how is it done 2003 Honda CRV


Are you having an idle issue ??
Vehicle equipped w/Tachometer ??
Cold engine idle speed ??
Warm engine idle speed ??
Warm engine idle speed @ A/C requested on ??

May 28, 2015 | 2003 Honda CR-V

1 Answer

2004 honda crv actuator


This generation CrV has problems with valve seats sinking into the cylinder head on higher mileage vehicles. Have your valve clearance checked. It may still be able to be adjusted out. If they have already sunk too far, the cylinder head will need to be replaced with updated unit. (Not cheap) Check with your local dealer, as Honda was extending warranties/helping owners with cost of repairs on these for a while. Not sure if they still are or not.

Apr 06, 2014 | 2004 Honda CR-V

1 Answer

Crv 2006 vibrates at any speed. slow down or speed up it goes away. your thoughts


i have honda crv 1999 it never speed up to 120km/h when it 120km/h sometime i feel shakeany help

May 06, 2012 | 2009 Honda CR-V

1 Answer

Hi my 2004 honda crv idle speed is going up and down can u pls help me what should i do


there is most likely a vacuum leak somewhere allowing unmetered air in .

Aug 07, 2009 | 2004 Honda CR-V

1 Answer

Idle is too low, car dies, engine runs fine


An IAC (idle air control) motor is designed to adjust the engine idle RPM speed by opening and closing an air bypass passage inside the throttle body. The car computer or ECM (electronic control module) receives information from various sensors and will output signals to adjust the IAC motor in or out to adjust engine idle speed by controlling engine idle air.
An IAC motor is highly susceptible to carbon and coking build up; if an IAC goes too long without cleaning it can cause stalling and poor idle quality. Some cars are designed with a large vacuum transfer hose that connects the intake manifold to the IAC (idle air control) motor. If a broken or dilapidated these vacuum lines can cause the engine to lose vacuum which will allow the engine to run rough and die. 
Inspect all engine and accessory vacuum lines to look for missing, torn or dilapidated lines and replace as needed. To check the IAC motor remove the unit, with the wires connected turn the key to the "on" position without starting the engine, the IAC should move in or out. 
If the IAC motor does nothing it has probably failed, replace it with a new unit and recheck system. Note: while the IAC motor is removed clean (use aerosol carburetor cleaner) the passages the IAC uses to control idle air speed.

Good luck and hope this helps

May 08, 2009 | Honda CR-V Cars & Trucks

1 Answer

CRV Not Idling Correctly


Hook it up to a computer to see what codes pop up. This will tell you whats going going on. possibly its a speed sensor that is on the air intake area. Get a bottle of Lucas Injector cleaner, this helps clean out the injectors and the crud they collect.

Jun 12, 2017 | 1999 Honda CR-V

3 Answers

Honda crv transmission?


if your trans fluid is full it may be an internal problem in the gearbox even in the converter its hard to diagnose without seeing the car but i can sure try to help if you can add any other noises or symptoms i will see if i can help you pinpoint the problem

May 16, 2008 | 2005 Honda CR-V

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...