Question about Cars & Trucks

Open Question

Replace fuel sender unit. Ford s-max - Cars & Trucks

Posted by on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 178 Answers

SOURCE: fuel sender unit

hello first thing get a flat block of wood 2x6 or 2x12and a floor jack get car ramps under the rear tires use jack stands for safety get the jack under your tank with a piece of wood snug dont crush the tank remove your straps that support the tank also the clamp at your filling tube work the tank down while letting the jack down better off with a helper much easier now at the top[ of the tank you need to remove fuel lines (make sure there is no pressure release at the fuel rail from your shrader valve) emmision lines, wires now take your tank out its easier to pour the gas out of the tank into pails its more managerable to work on at the top there is a lock ring it has flat spots that lock under 3 or 4 ears you want to tap the ring off so the small stops are going away from the ear use a copper or brass flat edged chisel or punch spray some wd40 on ring to help once the ring is removed your sending unit fuel pump assembly lifts straight up dont bend the float arm take it out on a angle that works now once you go to reassemble get your area clean where the rubber gasket sits on dont drop dirt or rust in your tank take some blue grease or lithium grease on the rubber so ithelps with the friction now insert unit back in tank install lock ring push down and get it started under the flat ears make sure all the sides are under now tap it to the locking position till it bottoms out on the stops reinstall all lines hoses jack back up install your straps take jack out leave on ramps have somone put the key to on position check for leaks and fuel pump sound if okay then drop down goodluck please rate

Posted on Oct 02, 2008

Landyman
  • 89 Answers

SOURCE: fuel guage sender unit

Check fuse 14 in the facia fuse box,this is the instrument panel fuse.Also check you have a good earth on the connector under the left rear trim panel.

Posted on Nov 30, 2008

chromapr
  • 267 Answers

SOURCE: Ford f150 98 fuel gauge show full all time

you must have a bad ground some where in that circuit

Posted on May 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuel sending unit test and replace


Checking and replacing a fuel sender unit ' How a Car Works

www.howacarworks.com/fuel.../checking-and-replacing-a-fuel-sender-u...
Learn how to check and replace a fuel gauge sender unit, and how to check a fueltank. ... Fuel pipe Sender lead Breather pipe Sender unit Petrol tank Filter Float arm Float Mounting flange Filler .... Test by quickly removing the filler cap.

How to test a Fuel Sender - YouTube

? 2:01
https://www.youtube.com/watch?v=hHzeOOzQKR8
Dec 1, 2012 - Uploaded by TheyMightBeRacing
This video shows the basics of how to test a fuel sender to ensure that it is ... Trailblazer fuel gauge not working/sending unit test and replace ...

Trailblazer fuel gauge not working/sending unit test and ...

? 17:29
https://www.youtube.com/watch?v=aIMDauRGwFg
Sep 23, 2012 - Uploaded by MAY03LT
How to replace the fuel sending unit in the 02-03 Trailblazers. I also show how the fuel gauge works and how ...

Toyota Corolla Fuel Pump Removal Sending Unit Testing ...

? 6:17
https://www.youtube.com/watch?v=JtYMRrUpZr0
Oct 29, 2014 - Uploaded by richpin06a
Toyota Corolla Fuel Pump Removal Sending Unit Testing. ...Camry 1997 1998 1999 2000 2001 fuel pump replacement - Duration: 9:32.


Jan 13, 2016 | Cars & Trucks

1 Answer

Where is sender unit on 51 plate diesel mondeo 2.0 l


Hi sender unit is mostly situated in the fuel tank.
hope this was some help.

Mar 17, 2015 | Ford Mondeo Cars & Trucks

1 Answer

I need to find out what color the gas gauge wire is on a 98 ford f700 ?


Why do you need the colour? If the gas gauge isn't working, find the tank sender unit, sometimes its through a small panel in the floor. Pull off the sender unit wire and ground it with the ignition key in the run position. If the gauge maxes out, the sender is dead. If its a side mounted unit make sure you run the gas lower than the sender port!!
Remember to have a drain tray just in case and no guys standing around smoking! The release ring for the sender may require a special tool or something made up.

Jul 17, 2014 | Cars & Trucks

2 Answers

How to fix a fuel gage on a 72 ford thunderbird


Perhaps you might consider the sending unit in the gas tank.

Dec 23, 2010 | 1996 Ford Thunderbird LX

1 Answer

Fuel gauge does not work


Find a new sender unit, drop the gas tank, replace the sender unit, put the tank back in and you are on your way. good luck finding a new sender unit. Flush the tank and replace the screen while you are in there.

Nov 26, 2010 | 1982 Ford F 250

2 Answers

I have a 87 ford f-150 and gas gauage does not work. what would be the cause. thanks


ONE of 3 things
NO petrol
Fuse blown
Fuel tank sender needs replacing, or broken wire under dash or under chassis

Nov 24, 2010 | Ford F-150 Cars & Trucks

1 Answer

Fuel gauge on my 1995 ford galaxy goes to full all the time


stuck or faulty fuel sender unit.
hit the fuel tank with your foot or palm of your hand.
This should free off the float inside the tank, if not it could be a faulty fuel sender unit

Sep 22, 2009 | 1998 Ford Explorer

1 Answer

Fuel gauge reading zero and light on ?


Ford has lots of problems with the sender reliability. Typically, the sender (and expensive fuel pump) replacement resolves the issue. To test, you need to take the connection off of the sending unit, at the tank, turn on ignition, and then ground and un ground it and view results at the gauge. If the gauge responds, the sender needs to be replaced.

There are aftermarket senders that cost less than OEM.

Sep 16, 2009 | 2002 Ford F250 Super Duty SuperCab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...