Question about Cars & Trucks
Sometimes when I start the minivan, sometimes when is running, Brake/ABS Light On and HVAC Stop working, but with the motor running if I move the key, like trying to start the van again, i hear some relays and everything start working again.
Shoot some wd40 into the ignition switch and work it around with the key-Denny
Posted on Nov 28, 2013
Testimonial: "Hi Denny i try that but still doing the same. the weird thing is that after 20 or 30 minutes the engine running is more difficult to keep the air condition running, because stop working more often. looks like the switch/relay gets hot or something like that. thanks for your post"
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Vehicle speed sensor located on top of the rear diff at the brake line clamp a single bolt with a wiring harness. replacement from NAPA comes with a new extension harness. use grease on the terminals before assembly.
Posted on Apr 11, 2009
My 97 T&C has 180K and has the exact problem. One can remove the cluster and try resoldering the connections in the back side around the middle of the back panel. Another site reported two people were successful with this approach. I'm going to give it a try. If it doesn't work, I'll try the second hand cluster from a junk yard.
Posted on May 19, 2009
I have a 2005 Chrysler T&C. The turn signal would not work at all or activate incorrect side. The switch is easy to remove as described by dukecityman.
Once the switch is of, it has four screws holding it together.I took this apart to find that there was a circuit-board which was contaminated with dirt. wiped it of, put it back together, working fine.
If you take it apart use caution. there are parts on the "top" which will fall out. ( they go right back in) The circuit-board is on the "bottom" half. You really only need to take this part off. (less moving parts)
Your going to replace it anyway, whats the harm?
Posted on Jan 28, 2010
remove tire remove center pin and nut if needed and any othe bolts then pull straight off. Make sure parking brake is released or drum will not come off.
Posted on Apr 16, 2010
Tips for a great answer:
Jan 14, 2016 | Chrysler Cars & Trucks
Jul 23, 2014 | 2008 Chrysler Town & Country
Jan 26, 2014 | 1998 Chrysler Town & Country
Apr 21, 2011 | 2005 Chrysler Town & Country
Apr 16, 2010 | 2005 Chrysler Town & Country
Jun 06, 2009 | 2002 Chrysler Town & Country
Sep 07, 2008 | 2001 Chrysler Town & Country
82 people viewed this question
Usually answered in minutes!