Question about Daewoo Cars & Trucks

1 Answer

I drive deawoo matiz i bought it 1 week ago suddenly after 2 days when i switched to start the yellow engiine light came on with the word check in the middle, for few seconds and then gone, i thought it is normal but when i was driving home later on that day it appeared while driving for few seconds and gone. but know whenever i start the engine it comes up for few seconds and goes what should i do????

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Daewoo Master
  • 22,095 Answers

Sounds like the engine breather valve on the side of the engine at the back ,common fault i find on the car rental cars

Posted on Nov 27, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 512 Answers

SOURCE: 1995 Chrysler Concorde

the alarm is activating when he locks it and for some reason the key or fob isnt deactivating it..check the disarm switches in the door

Posted on Oct 01, 2008

ourhowse
  • 2007 Answers

SOURCE: engine skipping/misfiring, engine light flashing

Drive it into a dark place, or wait till dark. When it's running poorly, see if you can see any spark flying around. It sounds like plug wires.

Posted on Mar 04, 2009

  • 249 Answers

SOURCE: when i say its gone again i mean the drive shaft

is it the n/s drive shaft.
if so its the diff, there is a circlip that is not seated correct so punchs it of the gears in diff.
you normally loose a end bearing on shaft.
cant be that far out of align.
look when n/s shaft out into diff, look close for chips and circlip. u will understand how it should be when u look.

Posted on Aug 16, 2009

  • 1 Answer

SOURCE: Saab '02 9-3 "electrical"problem

Most likely it is the ABS module is going bad and needs to be replaced or rebuilt at www.bba-reman.com, hope this helps.

Posted on Jan 22, 2010

  • 289 Answers

SOURCE: 91 honda accord wagon, stick shift, wouldn't start

it sounds like distributor check for spark when it wont start if there ig no spark then its faulty

Posted on Jun 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need a fuse panal digram no cover


hi im having trouble with my deawoo matiz when im driving abit the imobiliser goes off and turns all electric off in car is there away i can disable the mobiliser

Sep 21, 2011 | Ford F-450 Cars & Trucks

1 Answer

Hello, I am having a 2001 3.2 CL Type S Acura car. Today while driving the engine check light suddenly started. I bought the car recently (2 weeks before). Just two days after I bought the car the...


I hate to say this, but sometimes they're all connected on a shared ground circuit; and in your case the shared circuit happens to be underneath the hood on the front of the left side fender. Now, there is another ground for the security hood switch. As far as the check engine lamp coming on, it may be a wsie choice to take the vehicle to have the ECM checked for any lingering codes. AutoZone has a free service for scanning engine codes.

Jul 07, 2011 | 2001 Acura 3.2CL

1 Answer

Suddenly, No tail lights, brake lights, turns signal or back up lights At 83000 miles, 6 months ago, replaced head gaskets. 1 week later, service engine soon light came on. Tech said it was an oxygen...


just look for the blackened/burned pin on the rear light plastic connector and sand it down to re-establish a good electrical connection and save yourself $800 big ones on replacing the multiswitch.

Jun 26, 2011 | 1999 Chevrolet Venture

1 Answer

6 months ago, replaced head gaskets. 1 week later, service engine soon light came on. Tech said it was an oxygen sensor. Cleared code. 3 weeks ago, got oil change, replaced headlights and replaced...


CHECK TURN SIGNAL FUSE.IT COULD BE BLOWED OR YOU HAVE FAULTY TURN SIGNAL SWITCH.BECAUSE BACK LIGHTS AND TAIL LIGHTS SHARE SAME CIRCUIT WITH TURN SIGNAL SWITCH.

Jun 26, 2011 | 1999 Chevrolet Venture

1 Answer

Hi I am having a few problems with my 2001 MR2 Spyder which i bought second hand about 6 months ago. I am being told I new a new engine by one mechanic and that it's just the rings by...


have you check the speed sensors? the check light wont be light if the sensor run off calibrate. try to visuallise the sensor if there is crack or something.

Nov 23, 2010 | 2001 Toyota MR2 Spyder

1 Answer

Stalls when car decelerats, then break light and all lights come


get the oxygen sensor checkde out and the maf sensor...sounds like a vacuum leak too...Stop driving it and get it looked at ..if you dont see any loose hose's that are small in dia.. .then check those 2 sensors i spoke of ....

May 18, 2009 | 1995 Subaru Impreza

1 Answer

1995 Chrysler Concorde


the alarm is activating when he locks it and for some reason the key or fob isnt deactivating it..check the disarm switches in the door

Aug 11, 2008 | 1995 Chrysler Concorde

1 Answer

1993 Honda Accord Timing belt


Tell us who made that belt so we can stay away from them.

Aug 06, 2008 | 1993 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...