Question about Mercedes-Benz Mercedes E Class E320 Diecast Car
U need a data stream run-a scan w factory gear at a private shop--it shows values that a tech can figure--just a code scanner at a discount place wont doit-------------cud all be just a bad horn or security probs
Posted on Nov 27, 2013
There is obviously a short somewhere in the line. Need to locate the "horn relay" it is probably bad. Now if it happens again, I would simple snip or unplug one wire from the horn itself. You can then get to where you going, hoping you don't need a horn then get it fixed!
Posted on Nov 27, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Common causes for High-pitched noise from rear wheels are:
The wheel bearing: this is not usually dangerous in the short term, but I recommend contacting a mechanic and having it fixed. To test the wheel bearing, you lock front wheels, and jack up the car rear and spin the wheel (handbrake unlocked). If bearing is worn you hear a drone. When is the bearing, often car starts vibration above 40 mph.
Noise from bearing can be continuous, intermittent, only when steering, only when hot.
The brake pads: when brake pads are worn out they start making a squealing noise, in this case the noise is only when you brake or continuous. When you jack up the car the wheel may be a little stiff, but not necessarily.When brake pads are completely gone you also hear a scratching noise when braking. Inspect your brakes immediately.
Other suspension problems: Jack up the car as suggested above, check if the wheel has a slight play on the sides. Check all of the suspension components, suspension mounting points, and steering linkage for damage. Also, check the frame rail for wrinkles. It is very important that these components be in good condition, if you notice any problem here, go immediately to a mechanic.
Try doing the simple test above, reinstalling the wheel and working the tire back and forth. This is a common test for bad ball joints and wheel bearings.
Posted on Jul 17, 2008
just went thru the same think wit a s 430 it was the crank position sensor . 60 bucks at auto zone and it took me 5min. 2 install if u need help feel free to call me 918 808 9706 chris
Posted on May 15, 2009
Tips for a great answer:
Mar 01, 2015 | 1995 Toyota Tercel
Oct 10, 2014 | 2001 Isuzu Trooper
Nov 06, 2012 | 1986 Nissan Maxima
Nov 01, 2010 | 1998 Ford Explorer
Jul 03, 2010 | 1999 Oldsmobile 88
Oct 23, 2009 | 1997 Ford Escort
Jul 07, 2009 | 1996 Jeep Grand Cherokee
Jul 10, 2008 | 2008 Chevrolet Corvette
189 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: