Question about 2006 Nissan Xterra

Open Question

2001 xterra jerks around the 40-50 mph / 2000 - 2500 rpm --- taken it to two mechanics and can not figure out the reason

Posted by on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: I have a 2000 Xterra and driving it. It started

COMPUTER ISSUE.. MY 2000 EXTERRA ALSO DID THIS HAD IT IN THE SHOP FOR 2 MONTHS THEY NEVER FIXED IT SO I HAD TO TRADE IT IN AND TAKE THE LOSS! :( NOW I SEE IT DRIVING AROUND TOWN!

GOOD LUCK

Posted on Aug 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 2001 Ford escape xls 4x4 2.0 4cylinder and when driving down interstate at 75 mph in 5th gear my rpms are running at 3500. Is this normal or what would be causing this? It sounds like it needs a...


That is a typical RPM at that speed for most 6-speed 4 cylinder engines. The reason for this is that they have a much lower power output at lower RPMs (due to lack of torque), and the engineers want for you to have SOME acceleration to get up little hills.

May 17, 2014 | Cars & Trucks

1 Answer

2001 Grand Prix jerks when driving mostly at higher speeds like 70-80 mph. It can do it at 40 mph too and it seems to be when I accellerate. Also, turns off the Cruise Control if its on when it jerks. ...


make a mixture 1 liter two table spoon of salt in bottle with spray
engine idle spray your mixture not too much and see if you have spark on wire ,coil you won't see it if too much mixture
and about spark plugs you could change it too
you have a misfire

Oct 08, 2013 | 2000 Pontiac Grand Prix

1 Answer

How do I stop my transmission from jerking non stop?


hi,

usually the auto trans has a filter in the pan. if the filters clogged it cant get enough pressure to shift. i recommend a new filter and gasket. cork gaskets are way easier to install than rubber gaskets. coat the cork gasket with form-a- gasket, you dont have to use an extreme amount, just enough so the gasket sticks to the pan.

jm

Jul 07, 2017 | 1998 Ford Windstar

1 Answer

I recently purchased a 2001 Mazda Millenia. It was a little jerky test driving it, but it was winter with snow and ice. Now it's spring, and it's still jerky. I took it out on the hwy doing about 70 mph...


Do you notice does the problem seem to worsen in rain or humid weather? Try checking the MAF sensor it may just need to cleaned it can cause problems like this. Be sure to use MAF cleaner nothing else. The sensor may also be bad but try cleaning it first, its cheap and only takes about ten minutes.

Apr 07, 2011 | 2001 Mazda Millenia

1 Answer

2000 nissan xterra~ feels like i got watery gas (checked, no) or running out of gas (not). sputters and jerks and loses power badly until can push gas pedal to floor and won't go above 5 mph. first time it...


Mass air flow sensor might be dirty or failing.
Clean sensor when cold with mass air sensor cleaner only.
that controls the throttle opening and closing.

Jun 22, 2017 | 2000 Nissan Xterra

1 Answer

Jerking from take off


It could be that you have some free play from wear and tear in the universal joints that are located at both ends of your main driveshaft. My 2001 ranger 4x4 does the same thing; it also starts to shake pretty hard if I go more than 65 mph. My U-joints definitely need replacing. I would have the universal joints on the main driveshaft checked or replaced. It could also be an excessively worn pressure plate ( automatic clutch). If it's idling higher than around 600 rpm after the engine is warmed up I would check the idle air control valve or for a vacume leak elsewhere near the intake manifold. I hope this helps : )

Jun 03, 2010 | 2000 Ford Ranger SuperCab

1 Answer

I have a 2000 Xterra and driving it. It started


COMPUTER ISSUE.. MY 2000 EXTERRA ALSO DID THIS HAD IT IN THE SHOP FOR 2 MONTHS THEY NEVER FIXED IT SO I HAD TO TRADE IT IN AND TAKE THE LOSS! :( NOW I SEE IT DRIVING AROUND TOWN!

GOOD LUCK

Jul 13, 2009 | 2000 Nissan Xterra

1 Answer

96 corolla hesitates and jerks


The jerking and shuddering at 45-50 mph seems like it could be a transmission/torque converter problem. Check your transmission fluid. Make sure it is at the right level, and that it is not dark or burnt. It should be a bright red or pink.

Frank
Frank's Friendly Cars Maui Car Rental
www.MauiCarRental.biz

Mar 01, 2009 | 1996 Toyota Corolla

1 Answer

2001 xterra vehcile speed sensor problem


http://www.xterraownersclub.com/cgi-local/ultimatebb.cgi?ubb=get_topic;f=2;t=001342

Jan 02, 2009 | 2001 Nissan Xterra

1 Answer

Loss power suddenly


your in limp mode have the vehicle scanned for trouble codes most auto stores offer this service for free --

Aug 13, 2017 | 2000 Nissan Xterra

Not finding what you are looking for?
2006 Nissan Xterra Logo

Related Topics:

230 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...