Question about 2000 Mercury Grand Marquis
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
My name is Dennis and I can assist you to finding your parking brake adjustment location.
1) the adjustment is located so that you have to remove your center console floor finish panel (this is the drink holder).
2) raise your parking brake lever and gently pry the plastic tabs from the center console.
3) Once you can see the park brake lever you will see a nut that is turned to adjust the lever so that it has 5 clicks when it is applied.
Glad to be of assistance and thank you for using FixYa. Please rate the solution because I can learn from your rating (and it keeps my rating up to date). Thank you, Dennis
Posted on Nov 16, 2008
It is in the trunk I can remember which side on a 92 but it will be behind the side trim panel almost straight down from the trunk hindge.
Posted on Feb 21, 2009
There are eight COPs (coil-on-plugs) to remove. Using a 7mm or 9/32" socket, remove each bolt securing each COP to the intake manifold on top of the engine. Remove all eight COPs, and the spark plugs are underneath. When replacing the spark plugs, use only the proper Ford/Motorcraft plugs, even if they cost twice as much as the aftermarket ones. You will avoid further headaches this way. Hope this helps.
Posted on Mar 30, 2010
SOURCE: 1994 mercury grand marquis.
Hello, These controls are very simple. You need to have the switch adjusted in the holder under the dash or more slack in the adjustment cable.
The way this works is the contact switch needs to extended far enough to activate the bulb. If the Emergency brake is too tight, the contact switch does not get enough room to extend. There is adjustment in the holder for this. What usually happens is the contact switch has extended for a worn system.
When new Emergency brakes are installed or the brake cable is adjusted, someone should have reset the Emergency brake holder. Now the Emergency brake switch does not have room to work. The cable does not move far enough to allow the plunger to move under the dash. You need to either adjust the holder or loosen the cable.
Posted on Jun 19, 2011
Tips for a great answer:
Feb 09, 2015 | 2000 Mercury Grand Marquis
Oct 28, 2011 | 2000 Mercury Sable
Jun 18, 2011 | 1994 Mercury Grand Marquis
Dec 17, 2010 | 2007 Mercury Grand Marquis GS Sedan
Aug 10, 2010 | 1995 Mercury Grand Marquis
Jun 14, 2010 | 1993 Mercury Grand Marquis
Dec 07, 2009 | 2003 Mercury Grand Marquis
Nov 05, 2009 | 2000 Mercury Grand Marquis
May 12, 2009 | 2003 Mercury Grand Marquis
Apr 04, 2009 | 2003 Mercury Grand Marquis
23 people viewed this question
Usually answered in minutes!