Question about 2007 Lincoln MKX AWD

1 Answer

Positive cable needs to be replaced - 2007 Lincoln MKX AWD

Posted by on

  • Brock Hand
    Brock Hand Nov 27, 2013

    but how to put it on !

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 74 Answers

Not familiar with ur vehicle but usually it simply runs from battery directly to starter...

Posted on Nov 27, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine cables


First take the negative cable off the battery. Then the positive cable. Now the positive cable will attach to the starter with a large eyelet, so take off the nut for the cable, then remove the positive cable, the other wires that attach here simply pick up battery power at that point. Put them all back on with the positive cable in the order they were pulled off. Tighten the nut down. Clamp the positive onto the battery, then the negative.
To make the job the easiest, don't buy a generic positive cable, but buy the one specifically designed for your car. If Nissan is too expensive, buy a generic one that is the same length with the same connectors at each end. Doesn't have to be exactly the same length, but within 3 or 4 inches. The length of a wire or cable is important when considering how much power is to be applied to the starter-a considerably longer cable will just have less power available at its end.

Dec 07, 2013 | 1999 Nissan Maxima

1 Answer

Positive battery cable replacement


Use a battery wrench usually 8mm to open the terminal bolts. Undo both of them and disconnect both the cables (positive and negative). Disconnect the other end of the positive cable by following it along its length. Undo the bolt that holds it. And now you can replace the cable. Follow the same process in reverse for reinstallation.

Jun 23, 2013 | Toyota Avalon Cars & Trucks

1 Answer

How to replace positive cabel on 1996 Mercury Sable


Remove negative cable from battery than remove positive cable from battery. jack car on passenger side make car safe by putting jack stands under car . remove positive cable from starter solonid. to do this you will need an open end wrench set usually five sixteenths on battery and nine sixteenths or five eights wrench on solonid. please leave positive feedback if you find this helpful.

Dec 21, 2010 | 1996 Mercury Sable

2 Answers

Car drags when trying to start. had battery checked and it was good, cleaned negative post and replaced terminal, and worked better, but still drags sometimes. the positive terminal is corroded, but looks...


disconnect and clean with baking soda and water solution, cable could be corroded inside, must be replaced, start early sat morning with new cable in hand 

Sep 13, 2009 | 2000 Nissan Xterra

2 Answers

Replace positive battery cable 97 montero


A lot of cars have two cables on the positive post.
Do you need to replace the cables or is the battery post clamp broken. You can buy a replacement post clamp if you have the type of cables that are bolted to the clamp.
If you need the cable, a oem replacement from your dealer parts counter will match. You can get after market replacements, just look for one that matches your original as close as possible. The parts counter guy should be able to help.

Sep 06, 2009 | 1997 Mitsubishi Montero

1 Answer

A month ago I bought A used 2000 elantra it used to start fpr the first try In the same time I changed the engine oil and Trying to put a good battery when I finished it did not start.


Verify (test) the battery is good/charged. Verify good, clean cable connections (positive & negative, correct polarity). Inspect positive and negative cables for loosness (positive cable condition to starter connection - clean/tight) negative cable condition to ground connection clean/tight). Replace/repair/clean/tighten cable(s) as needed. Did you remove/disconnect any components from the engine when you replaced the battery? If so, did you remember to put/reconnect them back?

Apr 22, 2009 | 2000 Hyundai Elantra

2 Answers

Positive battery cable


i think that one goes to the starter. how bout cutting off the end and putting an after market cable end?

Sep 19, 2008 | 1998 Ford Contour

Not finding what you are looking for?
2007 Lincoln MKX AWD Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

fordexpert

Level 3 Expert

5579 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...