Question about Cars & Trucks

Open Question

Engine turns but no spark mazda astina 1800se

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 166 Answers

SOURCE: mazda astina water pump

remove rocker cover, harmonic balancer and belts, remove timing cover and you will find the water pump on the left side of the timing belt set up good luck mate it is a little tite in there

Posted on Dec 14, 2008

Peterpetreli
  • 6 Answers

SOURCE: mazda astina pop up lights wont go back down

Try to check if there is something stuck to the motor of the pop-up lights mechanism. You can see it below the fenders. The fender liner should be removed.

Posted on May 27, 2009

  • 100 Answers

SOURCE: 1989 mazda astina 323 5 spd manual clutch fluid??

Check the brake fluid resovoir, on the side there could be a hose coming off it part way down the side sharing the brake fluid to the clutch master cylinder

Posted on Sep 09, 2009

  • 104 Answers

SOURCE: 1991 mazda astina 323 wont

Check your timing, belt may have slipped a tooth.

Posted on Jan 27, 2011

  • 1 Answer

SOURCE: I have a 1994 Mazda Astina 323 BA series V6 2.0L

check ur engine starting fuse

Posted on Nov 11, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cannot find spark plugs in 2003 323 1.8 litre mazda astina


If you follow the wires to the top of the engine from the distributor, they are under the boots when you remove them. Plugs are about 4-6" down inside. f2c5d262-e131-42d7-8496-0946d38b78c6.jpg

Apr 20, 2014 | 2003 Mazda 323

1 Answer

I have a Mazda astina 323 94 model it cranks but won't start doesn't seem to be any spark from the leads I have recently changed the leads , Im guessing it's the coil and distributor cap please help


1 remove the cable from the coil to the distributor.
check this agains earth, when you turn the engine over.

if spark, suspect rotor arm is not setting spark to each spark plug lead.
open distributor and clean the rotor arm with a cloth or wire wool
not sand paper as this will take off too much and cause a problem

2 check inside distributor for moisture. spray inside with WD40 or equiventy water repelent.

3 if not spark at coil open distriutor cap and with ignition on, open and close points in distributor with a screw driver and check coil again against earth again if you get sparh, problem is points not opening and closing.

4 turn over engine with distributor cover removed to see if rotor arm is moving if not then cam drive to distributor is defective. this controls points and rotor arm.

if rotor arm turning and spark at points but no spark at coil suspect Low tension wiring or coil needs replacement.

i hope this was helpful

Dec 12, 2010 | Mazda 323 Cars & Trucks

1 Answer

My mazda astina 323 wont start. it is getting fuel and wants to start but wont???


Are you getting spark to the plugs? If not, the iginition coil or ignition module may be bad

Nov 24, 2010 | 1991 Mazda 323

1 Answer

Mazda astina pop up lights wont go back down


Try to check if there is something stuck to the motor of the pop-up lights mechanism. You can see it below the fenders. The fender liner should be removed.

May 27, 2009 | 1990 Mazda 323

1 Answer

Mazda Astina BG Import 1992 1.6 litre normally aspirated engine


if you get a after market workshop manual for a kf/kh laser (also have mazda wiring diagrames in them).best look on ebay.the motor in the earier laser and mazdas is very similar.i am a laser /mazda fan.i own at least 3 of these cars love them..check to see if you are getting power to coil first.this would be no 1 to check.if all is okay at this point then the dissy.a good auto elect should be able to test for you.when you get a manual just follow instructions on removeing the dissy.put on top dead centre 1st before removing.this makes it easer to replace.i live in nsw

Jun 17, 2008 | 1992 Mazda 323

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...