Question about 1992 Ford F250

Open Question

No brake lights 1992 f350 power stroke

No brake light on truck or when I hook up my trailer

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1993 F350 ABS light

i had a problem with my abs light one night i had a brake line behind the driver front tire broke and it was leaking out all of the fluid and the abs light came on i replaced the line and filled up the master cylinder and it went away so check your lines and master cylinder

Posted on Mar 30, 2009

Ad
  • 460 Answers

SOURCE: no power to trailer plug at rear of F350

there is a large main fuse box under the hood check fuses to see if any are blown and replace the 1ns that arethen recheck for trailer light power hope this helps...

Posted on Nov 13, 2009

  • 5627 Answers

SOURCE: f350 4x4 extend cab power stroke 107000 miles abs

You can try to disconnect the battery for 10 minutes and see if the ABS light clears. If not Autozone or Oreillys may have another scanner to fit the ABS diagnostic socket, a free test.

When you did the rear brakes, the emergency brakes inside the rear rotors can sometimes crumble. Need to clean sensors because dirt and brake debris will keep sensors from counting wheel revolutions.

You could also have a ABS diverter valve stuck and not centered. Sometimes its necessary to rebleed to center the part and clear the light.

Posted on Jan 01, 2010

Testimonial: "tks i had no idea where to start now i know tks again"

  • 92 Answers

SOURCE: We have a 2003 f250 super duty. We have no power

Check fuse #6 20amp on your interior fuse panel it may be blown. The relays are located in an auxillary relay box located under the hood on the drivers side fender near the firewall. The system uses 2 relays. One relay turns on for left turn signal, other relay turns on for right signal. Both relays turn on for brake lamps. The fuse #6 is more likely the problem. If the fuse is blown, replace it, wiggle the wiring on the trailer while someone steps on brakes to check for shorts.

Posted on Apr 06, 2010

airjer995
  • 5332 Answers

SOURCE: Can't get the trailer running

Check fuse 28 in the fuse block under the left side of the dash. There is also a relay for the trailer park lamps in that same fuse block. The fuse and relay are the trailer parking lamps and run independantly of the vehicles parking lights. You can also try backprobing the other trailer plug (you should have one 7 pin and one 4 pin) to see if there is power at the park light pin. If there is power at the other trailer plug than the fuse and relay are bad and you may have a bad/corroded plug or bad wring to the plug that doesn't work.

Posted on Nov 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No power to trailer turn signals and brake lights. everything else works.


make sure to check the wiring on the trailer and to make sure that there is no damage or loose wireson the hook ups themselves. the wres could have come loose on your truck where they hook into the hook up for the trailer wiring. if any wire has come loose or the ground wire for the lights have come off, they will not work.

Feb 27, 2013 | 2003 Ford F350 Super Duty DRW SuperCab

1 Answer

No running lights on trailer


how many pin connector do you have

Jul 16, 2012 | 2000 Ford F350 Super Duty Super Cab

1 Answer

Have a 2008 f350 with integrated brake controller. with or without a traler connected the message center says no trailer when i use the brake controller manually it says trailer disconnected. when i hook...


Sorry no idea here iam sorry but i sawmy first F350 diesel manual for the first time in a car dealer yesterday ,what a monster and a bigger engine than a transcontinental volvo or scania 40ton truck .Well taken in awe i can tell you you need scaffolding to work on the engine ,no tilt cab .but iam guessing here could their be a sensor on the lift up flap for the plug socket by any chance ?

Oct 15, 2011 | Cars & Trucks

1 Answer

Can't get the trailer running lights to work on my 2006 F350 Diesel 4X4. Tried the trailer on another vehicle with the same plug and they worked perfectly. All other lights work with the trailer when the...


Check fuse 28 in the fuse block under the left side of the dash. There is also a relay for the trailer park lamps in that same fuse block. The fuse and relay are the trailer parking lamps and run independantly of the vehicles parking lights. You can also try backprobing the other trailer plug (you should have one 7 pin and one 4 pin) to see if there is power at the park light pin. If there is power at the other trailer plug than the fuse and relay are bad and you may have a bad/corroded plug or bad wring to the plug that doesn't work.

Nov 04, 2010 | 2006 Ford F 350 Super Duty

2 Answers

What is a tbc fault on a 2006 ford f350 6.0


That is your trailer brake controller that is built into your dash. If you are hooked up to a trailer it could mean you are losing your connection or ground to the trailer. If you are not connected to a trailer it means there is a problem with your brake controller possibly a short in the wiring caising the fault code.

Feb 02, 2010 | 2006 Ford F 350 Super Duty

1 Answer

No power to trailer plug at rear of F350


there is a large main fuse box under the hood check fuses to see if any are blown and replace the 1ns that arethen recheck for trailer light power hope this helps...

Nov 13, 2009 | 1999 Ford F350 Regular Cab

2 Answers

Need fuse list for 2001 ford f350 trailer lights not working


In the fuse box under the hood, fuse in position 20 is a 7.5amp fuse for the trailer left turn circuit, fuse in position 22 is a 7.5 amp fuse for the right turn circuit, if the fuses are good and you have power at them it is going to be wiring, at the back of the truck close to the driver side at the bumper is a gray connector that will take factory wiring to you trailer wiring the yellow wire is left turn/brake light, the green wire is right turn/brake light, and the brown is tail lights, and the orange wire is 12volt feed for if there is a battery on the trailer that needs to be kept charged for break away safty brakes.

Sep 18, 2009 | 2001 Ford F350 Super Duty SuperCab

Not finding what you are looking for?
1992 Ford F250 Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

fordexpert

Level 3 Expert

5626 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...