2004 jeep liberty resistor replacement - 2004 Jeep Liberty

you did not say GRAND so assume it is not.
Tell the country, no such car here in USA
my wild guess in Europe, where they do exist.?go to your jeep dealer, and ask for the manual.

Jeep Cherokee (KJ) (Model years 2002-07), also known as the Jeep Liberty in North America

so your 2004 really is not real Cherokee, it is re-badged Liberty.
if the blower motor false on high , that is not caused by the resistor block , bad blower./relay./2 fuses ;/or controller. bad.



liberty 04 usa 1 of 3 pages in the book, buy it?

Check fuse and relay as mentions in the link. Also the BCM is involved with climate control in which case you will need an auto electrician with a pro grade scan tool computer.

https://www.google.com/search?q=2003+liberty+heater+fan+does+not+work


Relay 33 in the Power Distribution Centre

Fuse Box Diagram Jeep Liberty / Cherokee (KJ; 2002-2007)

https://fuse-box.info > jeep > jeep-liberty-kj-2002-2007...
Here you will find fuse box diagrams of Jeep Liberty 2002, 2003, 2004, 2005, 2006 and 2007, get information about the location of the fuse panels inside the ...

since blower only works on high, I would only replace the resistor. 99.9% of the time this is the problem.

sounds to me like your blower resistor is bad.it happened to a friend of mine,but his would only work on high.i replaced it for him and now all speeds work like new.hope this info helps.good luck and take care, manny

Your heater motor speed selector only working on a couple levels is caused by a faulting blower motor resistor.This part is located on the evaporator case next to the blower motor itself.Two bolts remove the resistor and an electrical pigtail finishes it off.The location of this is underneath the dash on the pass front side.Happy Holidays!!

No this shouldn't be a big problem. It sounds like it is just the blower motor relay.

It is the blower motor resistor. Look under the passanger side dash and locate the fan housing (looks round and black in color. Then locate the resistor it will be in that housing usually withtwo ten millimeter nuts or two simple screws holding it in. unplug the harness to the resistor and remove the resistor. Part store price is approx. 50.00. Note: on aftermarket (not Jeep) resistor sometimes you have to modify the housing a little to get it in. Hope this helps.

What do you mean you "went through a car"??? Did you crash???
Generally one speed being "out" is caused by a burned out relay or resistor pack. Check those!!!

You have to take the glove box off and it is right behind it, need a #20 Torx to take it replace it. The glove box is the hardest part of the job, I just replaced mine on an 05 Grand Cherokee but it didn't fix it for me, was well worth the $8.60 to try though.

You need to replace your blower switch.