Question about 2000 Toyota Celica

1 Answer

Air blower stop on AC , unable to locate fuses Please help

Air blower stop celica 2000 unable to locate fuses please help

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Toyota Master
  • 75,807 Answers

I really doubt it is the fuse, more likely the blower rmotor speed dropping resistor or the motor itself is defective, the motor is under the dash on the passenger/ right side, the blower motor resistor is near it in the air ducting, see photo below.
air blower stop on AC , unable to locate fuses Ple - 3af0822.jpg

Posted on May 08, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 pontiac grand prix the ac blower stopped working we replaced it and still doesn't work it just comes on one in awhile. after replacing blower motor, then power door locks stop working replace


All these problems do sound as electrical of course but ecerything that you have mentioned is all on separate circuits which is odd. More than likely the blower motor situation is the resister. The window problem could be a number of things but I can tell you that all the wiring goes through the main drivers swtich so it could be just that switch but of course you would need to test before you just go out and but one but it is a common problem. The lights could be several things as we;; but would check the ambient light sensor which is located up in the center dash near the light that flashes for you security. You car didn't happen to get wet on the inside ? In any case I hope this helps.

Oct 24, 2012 | 2000 Pontiac Grand Prix

1 Answer

Heater and air stopped working on my 2000 Ford Focus zx3


CHECK BLOWER MOTOR FUSE AND RELAY.SEE IF POWER GOING TO BLOWER MOTOR YOU HAVE FAULTY BLOWER MOTOR.IF BLOWER MOTOR FUSE AND RELAY OKAY.IF NO POWER GOING TO BLOWER MOTOR BUT POWER AT AC AND HEATER CONTROL SWITCH. BLOWER MOTOR HAS POOR GROUND OR AC AND HEATER CONTROL SWITCH IS BAD.

Jun 12, 2011 | 2000 Ford Focus

1 Answer

My tail lights and illumination in the ac controls and gear selector stopped working. i own a 2000 celica gts


check the fuse.
Unless you just had something done in the dash, it is easiest to check the fuse first.
Instrament lights and tail lights are on the same circuit .

Feb 19, 2011 | 2000 Toyota Celica

1 Answer

Am trying to recharge the air conditioner on 2000 Ford Taurus and cannot locate the low service pressure port


I have 2000 Ford Taurus. The ac just stop working. I checked all the fuses and relay and all are ok. The clutch is not coming on. Please help Bob P

Jun 29, 2010 | 2000 Ford Taurus

2 Answers

My ac/heater fan stopped blowing, where is the fan located? The air is still cold just not blowing out.


verify the fuse first!! the blower is located behind glove box, see it under it and only need to remove 4 phillips screws!

Jun 01, 2010 | 2001 Isuzu Trooper

2 Answers

My heater and AC blower not working. Please help


In the fuse block,under the hood on top of the fender. Locate fuse #35 it's 40amp fuse for the blower moter. If the fuse is ok,there is another
common problem you can check. The blower moter resistor assembly,
located under the dash on right side. With a 12v test light check for
power to the blower moter from the resistor. If you have no power to the
moter, replace the resistor assembly. If niether of these works, I'll need
to know if you have climate control or manual control hvac. And for some reason, the wheel base. long wb or short wb. to dig any deeper.
But I hope one of the causes I've mentioned will cure the problem.
Good luck.

Feb 26, 2010 | 2005 GMC Envoy

1 Answer

94 Celica Heater not blowing


Could be a blown fuse for the blower motor or the blower motor itself is worn out. There is also a blower motor resister pack that could be at fault--it has three resisters in it that vary the blower speed--but it would be unusual for it to fail in such a way that the blower stops. Usually it just gets stuck on one speed. However, the resister is located down near your feet on one side (I forget which for that model) and if the wiring connector becomes unplugged (from an accidental kick), then the blower won't work.

Feb 21, 2009 | 1994 Toyota Celica

2 Answers

Air stopped blowing on ac/heater


Check your fuses.If you have a test light, unplug the blower motor, start the car, turn the fan on, if you have power to the blower plug, the blower motor is bad. If no power, if it's not a fuse, check the blower motor resistor. Should be mounted right next to the blower motor. It is inserted into the evaporator box

Nov 22, 2008 | 2002 Dodge Durango

1 Answer

1985 convertible celica fuse location


Check the harness connections located inside r-rear trunk panel. You will find power top motor & wire harness there.

Jul 12, 2008 | 1985 Toyota Celica

2 Answers

Blower for AC/Heater stopped working


if you can reach the blower motor, it could be a worn out carbon brush of the blower motor. if they are, buy a set of carbon brush, learn how to replace them and it would be back running in no time. by the way, when you pull out the carbon brush holder, make sure you dont interchange the position. you can put them back wards and what would happen is the rotation will be reversed. either you reversed the carbon brush holder or just simply interchange the wires that are coming to the motor. i hope i was able to help...

Jul 07, 2008 | 2000 Ford Focus

Not finding what you are looking for?
2000 Toyota Celica Logo

Related Topics:

479 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...