Question about Ford Cars & Trucks

Open Question

2005 Ford Ranger Vapor canister Bracket

Rear vapor canister location and bracket

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
customcan
  • 113 Answers

SOURCE: location of a vapor canister on a 2001 pontiac

do you mean evap canister it should be around the gas tank.

Posted on Jul 25, 2009

Ad
  • 1 Answer

SOURCE: 2000 Honda Odyssey Fuel Vapour Canister location

It is located at the top of the gas tank. You are going to have to drop the tank in order to check it, so it is best to do this when there is not a lot of gas in the tank. Hope this helps you out.

Posted on Aug 21, 2009

c17hydro
  • 2984 Answers

SOURCE: a shop diagnosed my 99 lexus es300 and said my

Take a look at the two photos:


5af7201.gif



The second photo, the part is under the arrows:


125f173.gif

Posted on May 24, 2010

  • 540 Answers

SOURCE: 2005 Chevrolet Equinox Vapor Canister

locate the fuel tank under the rear of the vehicle, just ahead of it you will see a rectangular plastic box with a few lines connected to it. it is the vapor canister. Remove the canister, the two wire plug that you will have to disconnect is attached to the vent valve which is what i believe you are referring to. grasp the valve and rotate it counter clockwise and pull up to realease it, and reverse procedure to install the new one..

Posted on Oct 14, 2010

c_dyer01905
  • 27 Answers

SOURCE: need location of vapor canister and purge valve in

The Canister Is located on the rear drivers side under the car (Big black box with 3 rubber lines). And the purge valve is located on the in the center on the back of the intake manifold (2 rubber lines and 1 plug).

Posted on Nov 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the Vapor Canister Vent Solenoid located on a 2003 Chevy Silverado 1500, 4.3L engine? And do you ave to remove the pick-up bed to access it, if it is on top of the tank?


No you don't have to remove the pick up bed to get at it. It's on the left frame rail along side of fuel tank !
Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle . Disconnect the evaporative emission (EVAP) canister vent electrical connector, if equipped. Disengage the 2 vent valve pipe clips securing the pipe to the underbody.
Remove the clips from the underbody and discard.
Disconnect the vent valve pipe at the EVAP canister. Remove and retain the EVAP canister vent valve bracket mounting bolt. Remove the complete EVAP canister vent valve assembly with bracket attached and discard.
Notice: Refer to Fastener Notice in the Preface section.
Video on youtube !

Dec 31, 2015 | Cars & Trucks

1 Answer

What should I check with code 0455 for 99 Ford Ranger


The Evaporative emission system has a large leak allowing fuel vapors to escape to the atmosphere . There are hoses an a purge solenoid ,a vent solenoid ,charcoal canister to store fuel vapors in . The charcoal canister is located under the vehicle near the fuel tank an has vapor lines running to the front of the vehicle to where the engine draws in the vapors by the engine computer opening the purge solenoid ! Any of this vapor hose could have a hole (leak) ,the gas cap could be lose or bad . The fuel filler neck could be rusted through ! At the repair shop we hook up a smoke machine to the system an look for a leak like that ! easy !

Aug 11, 2015 | Ford Cars & Trucks

1 Answer

VAPOR COMING FROM OR NEAR RADIATOR


my vapor canister nex to radiator came off bracket and altenator pully rubbed a hole in it.

Mar 10, 2014 | 2002 Dodge Grand Caravan

2 Answers

Locate fuel filter on 2005 ford focus tdti


Ford Focus 2000-05
Removal & Installation

Print

  1. Before servicing the vehicle, refer to the Precautions Section.
    NOTE The fuel filter is located underneath the vehicle in the area of the rear suspension.
  2. Relieve the fuel system pressure.
  3. Raise the vehicle.
    NOTE To remove the lines, press the quick-release tabs on the connectors.
  4. Remove or disconnect the following:

    Evaporative Emissions (EVAP) vapor line Fuel filter lines Fuel filter and bracket assembly Fuel filter

    0996b43f80205162.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Location of fuel filter and lines.


To install:
  1. Install or connect the following:

    Fuel filter Fuel filter and bracket assembly Fuel filter lines EVAP vapor line
  2. Start the engine and check for leaks.

  1. Before servicing the vehicle, refer to the Precautions Section.
    NOTE The fuel filter is located underneath the vehicle in the area of the rear suspension.
  2. Relieve the fuel system pressure.
  3. Raise the vehicle.
    NOTE To remove the lines, press the quick-release tabs on the connectors.
  4. Remove the fuel filter bolt and remove it from the bracket.

    0996b43f80202b3d.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Location of fuel filter and lines.


To install:
  1. Position the fuel filter into the bracket. Ensure the fuel flow direction is properly aligned.
  2. Install and tighten the fuel pump bracket bolt.
  3. Lubricate the fuel tube fittings with clean engine oil. Align the fuel tube fittings and press together until a click is heard and then pull on the fittings to make sure they are fully engaged.
  4. Start the engine and check for leaks

May 09, 2012 | 2005 Ford Focus

1 Answer

P0446 ford escort 98


This Pinpoint Test is intended to diagnose the following:
  • Canister vent (CV) solenoid (9F945) (electrical concern only)
  • Fuel filler cap (9030)
  • Fuel tank pressure (FTP) sensor (9C052)
  • EVAP canister tube (fuel tank to EVAP canister)(9A228)
  • Fuel canister purge outlet tube (EVAP canister to EVAP canister purge valve) (9D661)
  • EVAP return tube (EVAP canister purge valve to intake manifold) (9G271)
  • EVAP canister purge valve (9C915)
  • Vacuum source line (input port vacuum to intake manifold)
  • Harness circuits: CV, FLI, FTP, EVAP Canister Purge Valve, SIG RTN, vehicle power (VPWR), reference voltage (VREF) and power ground (PWR GND)
  • Powertrain control module (PCM) (12A650)
This Pinpoint Test is used as an assistance in diagnosing the following EVAP components:
  • EVAP canister and bracket assembly (9E857)
    • EVAP canister sleeve assembly (fitting)(9D925)
    • Canister vent (CV) solenoid - hose assembly (9F976 or 9K318)
    • EVAP canister (9D653)
    • Canister vent (CV) solenoid (9F945)(mechanical concern only)
  • Fill limit valve assembly (9A086)
  • Fuel filler pipe flapper valve (9B085)
  • Fuel filler pipe check valve (9189), assembly (9285)
  • Fuel tank filler pipe (9034)
  • Fuel tank assembly (with fuel vapor vent valve) (9K007)
  • Fuel tank assembly (without fuel vapor vent valve) (9002)
  • Fuel vapor control valve (9B190)
  • Fuel vapor vent valve (9B593)
  • Liquid/vapor fuel discriminator (9G332)
  • On-board refueling vapor recovery (ORVR) T - connector assembly (9S314)
Description For additional information on the Evaporative Emission (EVAP) System, refer to Section 1A .
For additional information on the Evaporative Emission System Monitor, refer to Section 1A .
Pinpoint Test Schematics Escort/Tracer (2V)
aa3060b.gif

May 28, 2011 | 1998 Ford Escort

4 Answers

2000 ford focus in line fuel filter where is it located


Hi, it's back by the fuel tank.

NOTE: The fuel filter is located underneath the vehicle in the area of the rear suspension.
  1. Relieve the fuel system pressure by removing the fuel pump fuse from the battery junction box, starting the engine, and allowing the engine to idle until it stalls.
  2. Raise the vehicle.
    NOTE To remove the lines, press the quick-release tabs on the connectors.
  3. Remove or disconnect the following:

    Evaporative Emissions (EVAP) vapor line Fuel filter lines Fuel filter and bracket assembly Fuel filter
  4. jturcotte_375.jpg
  5. Fig. Location of fuel filter and lines.

To install:
  1. Install or connect the following:

    Fuel filter Fuel filter and bracket assembly Fuel filter lines EVAP vapor line
  2. Start the engine and check for leaks.

Mar 31, 2011 | 2000 Ford Focus

1 Answer

1996 Ford Aerostar 3.0 L V-6 Constant check engine light ON Ran codes. Code says vacuum leak on fuel canister. I'd like to change all the vacuum lines. Don't have a good schematic. Haynes manual only...


what codes?

The vacuum lines run from the canister to the intake manifold. One is the purge hose to deliver stored fuel vapor to the intake to be burnd when engine is warm and you are crusing at part throttle. The other line is the vacuum line to operate it.

Fuel Vapor Valve, Aerostar (4.0L Engine) The evaporative emission valve (9B593) uses a small orifice, 1.83mm (0.072 inch), that allows vapors to pass into the vapor line running forward to the evaporative emissions canister (EVAP canister) (9D653). This evaporative emission valve mounts directly into the fuel tank (9002) using a fuel vapor separator seal. Fuel vapors trapped in the sealed fuel tank are vented through the orificed evaporative emission valve. The vapors from the fuel tank leave the evaporative emission valve through a single vapor line and continue to the evaporative emissions canister in the engine compartment for storage.
-----------------------------------------------------
Fuel Vapor Canister Purge Regulator Valve, Aerostar, Ranger Removal and Installation
  1. Disconnect wire harness from evaporative emission canister purge valve (EVAP canister purge valve) (9C915).
  1. Disconnect wire harness from thermistor.
  1. Disconnect evaporative emission canister purge valve assembly from fuel vapor canister and throttle body.
  1. To install, reverse removal procedure.
-----------------------------------------------------------------

snorkelbobby_48.gif

Mar 25, 2011 | Ford Aerostar Cars & Trucks

1 Answer

I need to change the vapor canister on my 01 s10 and do not know where it is


I have am looking for a vapor canister ( Bracket ) for a chevy 2001 S10 i look all out and no one have one can some one help me find one.

thank you

Jan 06, 2011 | 2001 Chevrolet S-10

2 Answers

2005 Chevrolet Equinox Vapor Canister Check Valve location


locate the fuel tank under the rear of the vehicle, just ahead of it you will see a rectangular plastic box with a few lines connected to it. it is the vapor canister. Remove the canister, the two wire plug that you will have to disconnect is attached to the vent valve which is what i believe you are referring to. grasp the valve and rotate it counter clockwise and pull up to realease it, and reverse procedure to install the new one..

Oct 14, 2010 | 2005 Chevrolet Equinox

1 Answer

1995 Ford Ranger ( engine light ) and stuff need help plz


if your obd2 scanner fits the connection you have obd2, obd1 connector is way differnt.

your code p1443
Control System
Canister Purge
Valve (Mechanical)
Malfunction
Monitors the fuel vapor
flow between the
engine intake manifold
and the EVAP
canister. The system
failure occurs when a
leak or blockage
between the intake
manifold, the EVAP
canister purge valve
and the EVAP canister
is detected by the
PCM.
l Pinched, blocked or
plugged fuel vapor
tubes/hoses (except
between fuel tank and
EVAP canister)
l Damaged EVAP
canister
l Disconnected, cracked
or cut fuel vapor
tubes/hoses (except
between fuel tank and
EVAP canister)
l Damaged EVAP
canister purge valve
Check for audible vacuum
noise in the engine
compartment or significant
fuel odor in the engine
compartment or near the
EVAP canister.

This link has all the codes you need.
http://rockledge.home.comcast.net/~rockledge/RangerPictureGallery/DTCs.pdf

Jul 17, 2008 | 1995 Ford Ranger Supercab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

405 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

fordexpert

Level 3 Expert

5626 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...