Question about Cars & Trucks

Open Question

Awa sound system model HT-520A USER MANUAL - Cars & Trucks

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why after changing plugs wires car won't start it turns over but then does nothing and when turning over it drains the battery battery was unhooked when this was all done. Any one got any Ideas


did you go plug for plug and HT lead for HT lead or did you just pull the lot and then replaced the HT leads
If you did this it is very possible that the firing order is messed up
next when you pull a battery you energize the immobilizer system
you will probably have to use a scan tool to reset the system
make sure battery terminals and posts are shiny clean and tight

Nov 14, 2015 | Cars & Trucks

1 Answer

I have misfire on number 3 cyl that is intermittant and a total nonfire on 4


SOUNDS LIKE THE COIL PACK OR THE WIRING CONNECTIONS ON OR TO THE COIL PACK .aLSO CHECK THE HT LEADS ON EARLIER MODELS ,LATER MODELS HAVE A COIL PACK ON EACH SPARK PLUG .MODERN TECHNOLOGY

Nov 17, 2012 | 1998 Volvo V70

1 Answer

I need a Mercedes clk 240 reg 05 user manual


If you are looking for user info to operate properly, you can likely get the info from a service like "All Data" ( alldatadyi.com ) They are an on-line service/repair manual supplier.
If you're looking for the factory manuals, I'd look on Ebay or similar sites, check salvage yards, used book stores (maybe find a store who specializes in car and truck literature) and car swap-meets are a GREAT source for manuals. Good luck!

Jan 16, 2012 | 2005 Mercedes-Benz CLK 240

1 Answer

No spark at spark plugs


The absence of spark or HT on the spark plugs is due to a failed IGNITION SYSTEM. Now this can be traced very easily. All you need is a 12 Volt park lamp, or a multimeter to check the voltage on the HT coil. you need 12 volt on the + side when the igntion is switched. if not check the fuse. Now on the other side of the coil you must have the voltage grounded ( switched by the igntion system) to produce the spark. If there is no spark the HT coil is a suspect. If not the ignition system is not switching and must be checked. failure of the electronic unit can be the reason , or lack of pulses from the pick up can be the other reason . You must be able to easily find this out by simulating the device to confirm, (feed a pulse) .

Nov 12, 2011 | Cars & Trucks

1 Answer

Car turns over but wont fire through coils


This can be failure of the ignition system You will need to check the HT coils,the activation trigger voltage to the HT coils , the HT wires and the spark plugs.

Mar 29, 2011 | 1994 Chevrolet Cavalier

2 Answers

I need a user manual for a Nissan Serena 1.6 van.


You can download the English version from the Nissan Website.

Jul 13, 2010 | 2000 Nissan Sentra

1 Answer

I just bought a two-way car alarm system but dont have the wiring manuel for it.ITS a Huatai model no:ht-800,FCC ID:st9ht-800 i wanted to know if you have the wiring manual for it or kno where could i get...


Most every aftermarket alarm is manufactured by DEI. If you go on the DEI website ( www.directed.com ) you should be able to find some wiring diagrams that will help you out.

May 17, 2010 | Honda Accord Cars & Trucks

1 Answer

1995 c-220 that seems to not hold it's rpms when it rains or gets wet. When the car is warm or dry it idles at 750 and is fine. When it gets wet it drops to 100 and stalls allot.I have to put it in n to...


Hi, sounds like you have a spark tracking problem caused by damp etc, worth spraying all HT system with something like WD40, if that stops it going on to three cylinder it will prove you need to renew parts of your HT circuit etc, good luck.

Feb 24, 2010 | 1995 Mercedes-Benz C-Class

2 Answers

What is the battery group size for 2004 Volvo xc90 2.5T?


Group Size 48 / 12V / 520A (CCA) / 90min(RC)
---
Costco – Kirkland Signature - Part # 10
Sears - DieHard international - Model# 33348
WalMart – EverStart – Model# Maxx-48
AutoZone – Duralast – Model# 48-DL
Napa – Legend – Model# BAT 7548, BAT 8448 , BAT 9848

Dec 02, 2009 | 2004 Volvo XC90

2 Answers

Start engine won't go . Romeve Ht wire attach to


To do accurate testing you will need to get a chiltons or haynes manual and follow the procedures listed. The system is not terribly complex but guessing will cost you money. Before testing, check coil wire and harness connections to make sure they are OK. If you need advice concerning any part you tested just ask.

Sep 28, 2009 | 1991 Pontiac Grand Am

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...