Question about Cars & Trucks
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
The question you asked me to clarify was really quite simple..... I needed a diagram of rear wheel bearing assembly for a 2000 Dodge Grand Caravan 3.38 litre, 6 cylinder, 2 wheel drive vehicle. You couldn't provide me with a diagram so I took the wheel off looked at the old one then the new one and just did it myself. Thanks for not helping.
Posted on Nov 13, 2008
I have a 2000 grand caravan with 234000 miles i have had since new. I have had no major problems with it. My best suggestion is if it acts up get it checked. Do not wait until it breaks it should last a while for you. I plan on driving it until it hits 300000. I average maybe 500 a year on general maintence type things. Between, tires, oil changes and things that have never gone bad so it is a very reliable vehicle. Good luck
Posted on Nov 18, 2008
the cooling fan relay is not in the fuse box.
it is a solid state relay bolted to the radiator core support just behind the bumper
Posted on Jun 16, 2009
For the 2.8L there is no sequence. Torque for the bolts are 105 in.lbs.
For the 3.0L torque is 50 in.lbs. in sequence:
For the 3.3L and the 3.8L, no sequence but torque each bolt to 105 in.lbs.
Please don't forget to rate!
Posted on Jul 12, 2009
Make sure it's cool, pop the radiator cap, Remove the shield on the passenger side between the tire and front of engine. Relieve the tension on the serp belt,draw yourself a diagram of the pulleys and belt routing in case the sticker is gone on the strut tower, remove the serp belt. Take the bolts out of the pulley on the front of the water pump (3). Remove the lower radiator hose at the front cover to drain the coolant. Remove the 6 mm bolts holding the water pump to the front cover housing. tap on the pump with a rubber hammer. Install a new gasket on the new pump, and a weap hole diverter in the pump (round black about hte size of a quarter), use old one if there's no new one. Install pupm and tighten bolts snug with a 1/4" ratchet. Install pulley and 3 bolts. Install belt, top off radiator with 50/50 mix green coolant. start engine and run to operating temperature,make sure the belt is seated in all of the pulleys and is running true, radiator fans should come on. Shut engine down and let cool overnight. Check level in radiator and overflow bottle, top off as necessary.
Posted on Aug 26, 2009
Tips for a great answer:
Jan 22, 2017 | Dodge Caliber Cars & Trucks
Nov 07, 2015 | 2008 Dodge Grand Caravan
Feb 24, 2011 | 2000 Pontiac Grand Prix
Sep 08, 2010 | 2006 Dodge Grand Caravan
Jan 26, 2010 | 2003 Dodge Grand Caravan AWD
Jan 22, 2009 | 2000 Dodge Grand Caravan
Dec 21, 2008 | 2000 Dodge Grand Caravan
32 people viewed this question
Usually answered in minutes!