Question about 1997 Buick Century

1 Answer

Replace blower motor 97 century limited - 1997 Buick Century

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 818 Answers

This is under the glove box area-you'll need to take it out to get to it and you probably need to got upside down to get at it-also there is a part called blower motor resistor that is down there that I would also replace- cheers Denny

Posted on Nov 27, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Big Poppa Ma
  • 302 Answers

SOURCE: Blower on 1997 Buick century quit working

check your blower fuse

Posted on Dec 06, 2008

  • 3 Answers

SOURCE: A/C Heater blower fan does not cycle through all speeds

Yes it is the blower Motors Resistor board. It is up behind the blower motor, just under the glove box. You have to remove the black KICK panel with its two "Push Pins" that will break too. There are 3 screws holding that resistor board in, the back two are a bear to get to. Good luck.

Posted on Feb 26, 2010

jturcotte
  • 8141 Answers

SOURCE: where is the blower motor and how is it replaced

First make sure the blower is bad. Please see my tip at http://www.fixya.com/cars/r6234839-doesn_t_heater_or_air_conditioner_blow .
Below are instructions from autozone.com for replacing your blower.


REMOVAL & INSTALLATION See Figures 1, 2 and 3
This procedure is applicable for vehicles, with or without air conditioning.

  1. Disconnect the negative cable at the battery.
  2. On the 3.1L (VIN M) you will need to remove the serpentine belt and move the alternator aside. See Engine & Engine Overhaul for removal and installation.
  3. For the 2.2L (VIN 4), disconnect the air inlet resonator, then remove the torque strut from the engine. Rotate the engine slightly forward.
  4. Working inside the engine compartment, disconnect the blower motor electrical leads.
  5. Remove the motor retaining bolts. If there is a hose disconnect it, then remove the blower motor.
051b335.gif

Fig. Fig. 1: Remove the blower motor retaining bolts ...
ab5f5fc.gif

Fig. Fig. 2: ... then disconnect the hose
5204077.gif

Fig. Fig. 3: The blower motor can now be removed


To install:

  1. Position the blower motor on it

    Posted on Oct 03, 2010

airjer995
  • 5332 Answers

SOURCE: 98 century heater blower motor resistor location

look under the passenger side of the dash. There will be a plastic trim panel that will need to be removed. Once its out of the way you will see the blower motor. The resistor will be just to the drivers side of the blower motor.

Posted on Nov 15, 2011

SOURCE: How to replace the alc blower motor on 2000 Buick

Refer to the factory repair manual.

Posted on Apr 17, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace blower motor 97 buick century 3.1


under the dash passenger side , you have to get upside down, be sure the squirrel cage is the same depth on the new piece as one to deep will bind up and could burn up the motor befor you figure out why it is not turning

Nov 27, 2013 | Buick Century Cars & Trucks

1 Answer

1998 buick century when air or heat is on I hear a squilling noise , what is it?


Replace the heater blower motor or the caged fan attached to the blower motor, or both.

Oct 28, 2013 | 1998 Buick Century

2 Answers

98 century heater blower motor resistor location


look under the passenger side of the dash. There will be a plastic trim panel that will need to be removed. Once its out of the way you will see the blower motor. The resistor will be just to the drivers side of the blower motor.

Nov 15, 2011 | 1998 Buick Century

1 Answer

My 97 buick lesabre limited heater/ac blower quit, it has the climate control,I checked all fuses.


REMOVE HEATER BLOWER MOTOR HOT WIRE BLOWER MOTOR IT.IF IT WORKS.YOUR AC AND HEATER CONTROL SWITCH IS FAULTY.CHECK HVAC FUSES AND CHECK BLOWER MOTOR RELAY.IF BLOWER MOTOR DONT WORK WHEN HOT WIRE REPLACE IT.IF ALL CHECK OUT GOOD.HAVE DEALERSHIP DO A DIAGNOSTIC TEST ON YOUR CLIMATE CONTROL SYSTEM.

Dec 02, 2010 | 1997 Buick LeSabre

1 Answer

Where is the blower motor and how is it replaced on a 1988 Buick Century?


First make sure the blower is bad. Please see my tip at http://www.fixya.com/cars/r6234839-doesn_t_heater_or_air_conditioner_blow .
Below are instructions from autozone.com for replacing your blower.


REMOVAL & INSTALLATION See Figures 1, 2 and 3
This procedure is applicable for vehicles, with or without air conditioning.

  1. Disconnect the negative cable at the battery.
  2. On the 3.1L (VIN M) you will need to remove the serpentine belt and move the alternator aside. See Engine & Engine Overhaul for removal and installation.
  3. For the 2.2L (VIN 4), disconnect the air inlet resonator, then remove the torque strut from the engine. Rotate the engine slightly forward.
  4. Working inside the engine compartment, disconnect the blower motor electrical leads.
  5. Remove the motor retaining bolts. If there is a hose disconnect it, then remove the blower motor.
051b335.gif

Fig. Fig. 1: Remove the blower motor retaining bolts ...
ab5f5fc.gif

Fig. Fig. 2: ... then disconnect the hose
5204077.gif

Fig. Fig. 3: The blower motor can now be removed


To install:

  1. Position the blower motor on it

Oct 03, 2010 | 1988 Buick Century

1 Answer

I have a 97 buick century limited and the air flow settings switch wont change how do I fix this? Example if I set it on vent and switch it to defrost it stays the same.


The "air / heat " door is either run by vacuum or motor.
The "defalt setting" is always on either defrost or heat.
I would say you may have lost vacuum to the control, or the control may be bad or a vaccum line is off.

Feb 05, 2010 | 1997 Buick Century

1 Answer

Will blower/fan motor from 1995 century fit into a 1997 parkavenue


the chances of this is slim I checked the Part numbers of the 2 motors and they are different possibly the plastic fans attach differently, and can cause problems with the depth or width the mounting holes may not even match up ...sorry I dont have better news..97 park ave motor GM part # 88960339 and AC delco # 15-8959 And the 95 century numbers are GM #52498870 AC delco # 15-8535 Hope these help...

Dec 07, 2009 | 1997 Buick Park Avenue

Not finding what you are looking for?
1997 Buick Century Logo

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...