Question about Pontiac G6

Open Question

2009 pontiac g6 coolant bleeder where are the located

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1263 Answers

SOURCE: power steering cap location Pontiac G6 3.5L

it is located on the passengerside under the altenator closest to the firewall. make sure the vehicle is turned off reach in under the altenator and you should feel the cap.

Posted on Sep 15, 2008

  • 171 Answers

SOURCE: location of the coolant bleeder plug.

the "bleeder plug" also known as pet **** should be on the bottom of the radiator toward the drivers side it looks almost like a wing nut

Posted on Apr 09, 2009

  • 32 Answers

SOURCE: installing thermostat in 2006 pontiac g6

follow the upper hose to the block

Posted on Aug 01, 2009

  • 303 Answers

SOURCE: how do i bleed the coolant system on a pontiac g6

Most cars will self bleed. You can help the process by running motor for a few minutes turn off add more coolant if needed and restart. Repeat several times. Also with heater on.

Posted on Jan 19, 2010

  • 332 Answers

SOURCE: How to clean O2 sensor on a 2007 Pontiac G6?

O2 sensor are located before and after Catalytic Converter ( exhaust system of your car). If you car's engine is 4 cyl you have 2 O2 sensors and if you car's engine is 6 cyl then you have 4 O2 sensors ( for each bank, 2 for left bank and 2 for right bank). Hope it helps and comment if you need more advice. Please don't forget to rate the answer it helps with my ratings, thanks!

Posted on Apr 28, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the power steering fluid location for a pontiac g6 2009 3.5L

I don't know this vehicle but if it was me I would follow the pipes back from the steering unit and they will cease at the steering pump reservoir and allow you to fill it there.

Sep 25, 2016 | 2009 Pontiac G6

1 Answer

Where is the thermostat located on 2009 Pontiac G6 3500 V6?

Follow your upper radiator hose to wear it connects to the intake manifold...2 13mm bolts hold in place...What is the symptom? Be sure coolant level is full...low can affect the heat...:)

Oct 30, 2015 | Pontiac Cars & Trucks

1 Answer

Where is the coolant drain plug on a 2009 Pontiac G6

the radiator drain plug(If it has one, will be along the bottom of the radiator)
the block drain is more than likely on the back of the engine

Jun 22, 2012 | 2009 Pontiac G6

2 Answers

I need to know where the horn fuse is located for a 2008 pontiac g6

Hello: Check the fuse box under the hood, there should be a diagram on the inside of the cover to show where the fuse is located in the box.

Jul 29, 2011 | 2008 Pontiac G6 Sedan

1 Answer

Where is the intake air temp sensor located on my 2009 pontiac g6 gxp

its located in the hose that runs into the air filter.should have warranty on that car

Aug 30, 2010 | 2009 Pontiac G6

2 Answers

2009 pontiac g6 3.5L ENGINE a/c will only cool after driving

Engine needs to be running with a/c on, hold can upside down and shake can till it feels getting cold, then can is empty.Try that good luck.

Jun 16, 2010 | 2009 Pontiac G6

1 Answer

Pontiac G6 read disk brakes not showing any wear, emergency brake is being used.

Proportioning valve is not centered and the rear brakes are not functioning. To correct..... have someone apply hard brake pressure on pedal and some else crack open the bleeder screw on the a frontwheel. A click can beheard. the bleeder must be oened and clsed quickly. Follow the brake line s from the brake master cyl and you will be led to the proportioning valve. There is a pin sting out of both ends. They must be equally extended out on bot ends. Good Luck, Ned

Sep 25, 2009 | 2009 Pontiac G6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides