Question about Ford Escape

1 Answer

2006 ford escape wont move when put in any gear till i rev motor

Fluid looks good and is full

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Filmmaker:

    Uploaded 5 video answers.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 73 Answers

Needs transmission fluid or may need to flush and change the filter. The worst thing could be the bands are shot in the transmission.

Posted on Nov 27, 2013

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Ford taurus 1995 will not move when started

i have a 2001 ford taurus and it did the same thing a while back, call the dealer and ask them for the sensor that is behind the brake pedal. It is not the transmission .. cost less that 25 bucks to fix and takes about 20 min

Posted on Mar 15, 2009

  • 155 Answers

SOURCE: 2006 ford escape brake lights don't work. the

Replace the brake switch located on the brake pedal shaft.

Posted on Jun 08, 2009

  • 21 Answers

SOURCE: How do you replace a power steering fluid pump on

it is directly under the upper engine mount on the passenger side. simply block up the engine from underneath and remove the upper engine mount (5 - 18mm bolts)

Posted on Jul 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

When i start my car and go to put it in gear it wont move.


When you say rocky spot, what do you mean? If you mean there were rocks in the roadway, you could have put a small hole in the transmission pan which leaked all the fluid out of it. First thing I would do is check the fluid level on the transmission dipstick and look for leaks on the ground under the car.

May 01, 2015 | 2002 Ford Taurus

1 Answer

06 ford escape wont move in gear, it has moved in reverse and in drive on last wee sundy after I put in a new mass air flow sensor but now I'm back where I was with no movement. Transmission works fine so...


With the engine running an transmission in a gear ,any gear an it doesn't move ? How in the heII can you say the transmission is OK ? Do yourself a favor an take it to a quailfied repair shop . You have no clue.

Jul 01, 2017 | 2006 Ford Escape XLT

1 Answer

Ford Escape will barely move when put in gear. (D or R) Floored to get to 10 MPH


If it smells of raw fuel look for a shorted injector dumping fuel into the engine

Dec 27, 2013 | 2002 Ford Escape

1 Answer

Ford e-250 transmission problems


My Econoline 250 with 4.2 lost fluid from hose leak, fixed leak everything was normal for 3 days till I drove it on highway. When it went into overdrive lost forward power. Turned off OD and did ok for a while. Lost forward gears slowly, put in fluid, hard to tell when full. Reverse is fine but have to rev up engine to get forward to engage, then everything is fine at lights and such till take out of drive, then have to rev engine to about 2500rpm to engage drive. Help?

Nov 05, 2013 | 1990 Ford F250

1 Answer

2004 ford escape has no power when give it gas and wont turn the transmission very much when in gear i can only get it to barley move. just had new plug wires and a coil pack installed was doing 70 on...


most likely your transmittion happened to me but in reverse my mechanic told me it was due to a transmittion flud hose that was too small which if you had your escape dealer serviced they replaced however it was not a recall the smaller hose in cold weather doesnt allow enough trans fluid to circulate which heats up the trans causing the clutch in trans to warp and disentegrate. when mine went it startd slowly engine would rev but car hardly moved then it would no longer move at all had t rebuild trans cost me 3200.00 im taking action against ford as to why a recall was not put into placed a few people i know who have escapes have had to rebuild trans for same issues hope it helps!

Mar 21, 2010 | 2004 Ford Escape

2 Answers

Car starts up shifts in all gears but wont move foward or reverse


The ring gear lined up with the torque converter,and is the trany full of fluid?

Jun 27, 2009 | 2000 Ford Explorer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...