Question about Ford Tempo

1 Answer

How can I remove the headrest

How to remove the headrest on a 93 ford tempo?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 19 Answers

I've removed the headrest on my mustang before. Some seats have a zipper or a way to snap the seat cover at the bottom rear. If you open it you can put your arm up the back of the seat. With the headresat down you can feel the locking piece that retracts when you lift the headrest. If you take a long shaft flat blade screwdriver and place it in between and lift up the headrest it will slide out. Yes, getting the screwdriver in place can be tricky but, it was the only way to remove the headrest without having the correct tool. I hope this can work on your vehicle as well.

Posted on May 13, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse box in a 93 tempo


under the dash left side may have to remove plastic cover

Jan 02, 2014 | 1993 Ford Tempo

1 Answer

93 ford tempo need rear bumber


your best bet is a junk yard ,to replace jack rear of car chock front wheels for safety ,i believe is about eight bolts holding it against a flat plate you cannot miss it four on each side put w-40 if needed to remove

Mar 07, 2011 | 1993 Ford Tempo

1 Answer

Where is the fuel pump located on a 93 ford tempo


Your fuel pump is mounted inside of your fuel tank. The tank needs to be removed from the car to access it.

Oct 21, 2010 | 1993 Ford Tempo

1 Answer

How do i replace the fuel tank on my 93 tempo?


remove gas tank straps and make sure to unplug the fuel pump harness and remove filler tube from tank it is usually screwed down where you put gas in to fill it up

Jan 10, 2010 | 1993 Ford Tempo

1 Answer

DESCRIBE HOW TO REMOVE A STARTER FROM A 93 FORD TEMPO


First disconnect the battery. After that, find the starter (should be bottom right). Remove the wires from the starter making sure you remember where they go. Remove the two bolts that hold it in place (one on top, one on bottom). Reverse all of this to put the new one in.

Oct 24, 2009 | 1993 Ford Tempo

2 Answers

93 Tempo power steering leak under car


Own one of these and had to replace both the hi pressure and return lines for the hydrulic rack and pinoin steering unit. The hoses are cramed directly under the motor towards the rear. It was a challenge!

Jul 09, 2009 | 1992 Ford Tempo

2 Answers

Need to replace broke window on 93 ford tempo.Pass. side


Door Glass, Front Removal
  1. Remove door trim panel and watershield. Refer to Section 01-05. ani_caut.gif CAUTION: Prior to removing center pins from the rivet, it is recommended that a suitable block support be inserted between door outer panel and glass bracket to stabilize glass during rivet removal. Remove center pin from each rivet with a drift punch. Using a 1/4-inch diameter drill, drill out remaining rivets as damage to plastic glass retainer and spacer could result.
  1. Remove two rivets attaching glass to run and bracket assembly.
  1. Remove glass.
  1. Remove drillings and pins from bottom of door.
Installation
  1. Snap plastic retainer and spacer into two glass retainer holes. Make certain that metal washer in the retainer assembly is on outboard side of glass.
  1. Insert glass into door.
  1. Position glass to glass bracket. Install two rivets to secure glass to glass bracket. NOTE: Two 1/4-inch-20 x 1-inch bolts and two 1/4-inch-20 nut and washer assemblies may be used as alternates for glass retention. However, torque must not exceed 4-7 Nm (36-61 lb-in). Equivalent metric retainers (6mm) may be used.
  1. Install door trim panel and watershield. Refer to Section 01-05.


2-Door Vehicles


n5878h.gif



4-Door Vehicles


n5879g.gif

May 29, 2009 | 1993 Ford Tempo

1 Answer

Wiring harness cut 93 tempo radio need wiring colors


a quick and easy solution would be to run your own power leads and just use the speaker ...i would suggest using a multimeter

Aug 31, 2008 | 1993 Ford Tempo

1 Answer

93 tempo


I had the same problem a few months back with my 93 Tempo. After fiddling with the battery, checking for spark, and messing with my distributor cap, I found the emergency fuel shut off reset button in the trunk. If you haven't already, open the trunk, and on the left hand side there is a recess with a largish red button. Press it. If it clicks, then your fuel injector shut off because it though it had been in an accident (mine happened right after pulling into my driveway, where I had bottomed out a little bit, so it doesn't take much to set it off). If it clicks, your car should start immediately
Hope it helps!

Jul 12, 2008 | 1993 Ford Tempo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

531 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...