Question about 2007 Acura TL Sedan New Cars

1 Answer

No sound from speakers - 2007 Acura TL Sedan New Cars

Posted by on

  • victor
    victor Nov 26, 2013

    My 2007 acura tl had low battery, i jump astarted the car. when the car was on the radio asked me for a coad, i imputed the coad but there was no sound coming from the speakers, I checked the fuses (under the hood and driver side) but all seemed to be ok .Any idea what might be?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Acura Master
  • 20,706 Answers

All newer hondas, and acura. (works the same way)
open glove box take put operators guide, read radio page.
here is the quote. (posted many times)

quote
2008 opr.guide.(lost it, huh?) Accord. non satellite Rad.

Quotes:
Your vehicle's audio system may disable itself if it is disconnected from electrical power for any reason.
To make it work again, you must enter a specific five-digit code with the preset buttons.
Because thereare hundreds of number combinations possible from the five
digits, making the system work without knowing the exact code is nearly impossible.

You should have received a radio code card that lists your audio system's code and serial numbers. {glove box find}
It is best to store this card in a safe place at home. In addition, youshould write the audio system's serial number in this owner's manual.

If you lose the card, you must obtain the code number from your dealer.
To do this, you will need the audio system's serial number.

If your vehicle's battery is disconnected or goes dead, or the radio
fuse is removed, the audio system will disable itself. If this happens,
you will see ''ENTER CODE'' in the frequency display (on the screen on models with navigation system) the next time you turn on the system.
Use the preset buttons to enter the five-digit code. The code is on the radio code card included in your owner's manual kit.
When it is entered correctly, the radio will start playing.

If you make a mistake entering the code, do not start over; complete the
five-digit sequence, then enter the correct code. You have 10 tries toenter the correct code.
If you are unsuccessful in 10 attempts, you
must then leave the system on for 1 hour before trying again.

The system will retain your AM and FM presets even if power is disconnected. {only on newer cars'

General information on Honda and DIY:

{the code can be obtained from any Honda dealership (you must give him/her your radio serial number (sticker off radio)"}
or any locksmith with a license from..NASTIF

Honda1 ServiceExpress (Same info as ISIS)

Acura ISIS (Dealer version w/ advanced search)

http://nastf.org/i4a/pages/index.cfm?pageid=3462

Posted on Nov 28, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2012 maxima rear speakers not working


Go to the dealer and have the unlock code reapplied. You are probably locked out, if you get no sound at all. If you get sound from some speakers, but not all... it's a wiring or blown speaker issue. Remove the unit from the dash and check the wires. If you suspect a blow speaker(s), remove one from the mounting location and move it to a known location where a speaker works and plug it in. Crutchfield makes replacements that fit your car in many price ranges.

Feb 25, 2015 | 2012 Nissan Maxima 3.5 S Sedan 3.5L V6 CVT...

2 Answers

I have a pioneer 2din deck and it sounds bad. it sounds like the speakers are blown and makes a crackling sound. I have replaced the speakers and it still sounds bad. I don't even have a amp


Make sure the positive and negative wires for the speakers are correctly(not reversed) and securely attached to the mounted speakers and the speaker outlet wires on the deck

Jan 16, 2015 | 2000 Ford Ranger SuperCab

1 Answer

Rear speakers have no sound


No speakers are not fused.. It is most likely a speaker wire that has gone to ground so they would have to be traced to each speaker to see if you can find the short

Jan 10, 2014 | 2007 Toyota Camry

1 Answer

Hooked the stereo up and got power to but no sound coming out speakers but i try home speaker it work so what did i do wrong ?


if im understanding correctly what you wrote. you hooked up the headunit to the car and no sound from speakers, then you hooked up a single house speaker up and that speaker works fine. the Ohms on the car speakers might be too high, but most likely sounds like the wires to the speakers are bad.

Nov 21, 2013 | Cars & Trucks

2 Answers

What would cause the driver side front door speaker and the passenger side rear deck speakers not to work. When if fade the sound all the way to the front with no sound in rear and with the balance turned...


Check the speakers if they work. Connect the speaker terminals using a short wire to a 1.5 volt battery (AA or any dry cell batter) and listen if there's a thumping sound when the wires are connected to the battery terminals. If there's no sound, your speakers are busted. If there's a sound, check if the wires are okay. Use the same method with the battery with the wires from the back of your stereo. Make a small cut on the wire and attach the short wires you used earlier.

Nov 04, 2013 | Cars & Trucks

2 Answers

1998 bravada has six radio speakers; two dash speakers and two in the front doors speakers plus two rear doors speakers. the front doors speakers work good but no sound come from the dash speakers or the...


Did it fail while you had vehicle, or like this when you bought it? Could be bad radio or wiring harness was chopped up when previous owners had an aftermarket radio installed. They probably just slapped the OEM radio back in when selling car. And didn't put all the OEM wiring back in.

Nov 07, 2009 | 1998 Oldsmobile Bravada

1 Answer

RADIO SHOWS STATIONS BUT NO SOUND FROM SPEAKERS


if no sound from both speakers check fuse,
if some hissing or humming on full volume then its a fault in oscilator section
if there is no hiss or hum at full volume its a breakage in the wires of speakers, if one speaker is ok its aagain a wire open problem in out put section
open up the speakers and just apply 1.5 volts dc for fraction of second to the speaker leads , if theres crackling the speaker is ok
also see for torn out cones or stuck cone or speaker coil open.

Jan 16, 2009 | 1992 Mercedes-Benz 190

3 Answers

Rear speakers don't work


Sir,
I do not want to insult you in any way, but I must ask just in case it was overlooked! First check to be sure that the speaker settings on the stereo were not set all the way to the front. If that is not the problem, you can hook another speaker you know works to the wireing to the rear speakers to check to see if it is the speaker or the wireing. If you hear sound from the speaker you know works, then your speakers in the car are bad. If you do not hear sound, then it will be from the wireing. Next is the more difficult part. You will have to pull the stereo out and can splice into the wires. Hook the good speakers up to the splice and check for sound. make sure you know for sure the wires you splice into are for the rear speakers. If you still hear no sound, then it is more then likely a problem in the stereo itself. If you do hear sound then there is a problem in the wireing somewhere and may be easier to just run new wires to the rear speakers.

Nov 16, 2008 | 2000 Pontiac Grand Prix

1 Answer

Cracking sound from Radio Speakers


I disconnected the amp and ran jumper wires for the proper speakers (two wires per speaker eight total) . Basically I bypassed the amp now all speakers work and sound fine.

Jul 10, 2008 | 2006 Chevrolet HHR

Not finding what you are looking for?
2007 Acura TL Sedan New Cars Logo

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...