Question about 2008 Dodge Avenger

Open Question

How to change starter on 2008 dodge avenger

It do not want to start

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Battery changing

Ok, trust me on this one, take the drivers side tire off and remove the forward inner fender panel. If you try it without removing the tire, it is just a royal pain.

Posted on Jun 10, 2009

  • 2 Answers

SOURCE: How do I get the "Change Oil " light to go off after change .

Turn key to the run posistion and pump the gas peadle 3 times under 5 seconds.

Posted on Jul 18, 2009

  • 63 Answers

SOURCE: 2008 Dodge Avenger check engine light

Not sure if this will work for you but worth a shot. I own a 2005 dodge neon. I know the ecu's are different but maybe dodge was smart and made all the cars this way. Insert you key into ignition. Turn key forward until you are at the last position right before the car starts to crank over. Repeat this for a total of three times then on your digital odometer display, you will see a set of numbers displayed. this will be your code for the malfanction(s) that set your check engine light. Like I said, it might not work on your car but give it a shot. If not, rent an obdII scanner and get your codes. Then you know where to start looking to fix your problem.

Posted on Dec 17, 2009

sandman357
  • 236 Answers

SOURCE: Brake Fluid for 2008 Avenger

it's DOT 4 or DOT 5 check with your manual and sometimes it's even in the fluid fill cap.

Posted on Feb 22, 2010

Testimonial: "Quick response, guided me in the right direction. Thanks!"

  • 1 Answer

SOURCE: 2008 dodge avenger spark plug location and socket size.

  • 2008+ Dodge Avenger 2.4L 4cyl.
  • Remove plastic cover on top of engine, just pull on each corner for it is friction fit.
  • Once removed you will see 4 black spark plug covers with one hex type screw holding each.
  • Remove Hex screw and place aside, pull upward to remove plug boot from plug.
  • To remove the plug, use a 5/8 socket with a 6" extension. Once plug has been turned out all the way and you cannot get the plug up and out of the hole, just press the plug boot back on the plug and pull it back up.
  • Gap and replace 4 plugs with the same or equavalent type,. Drop plug down the hole and use socket to align and tighten until just snug, then torque to manufactures specifications.

Posted on Feb 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the alternator fuse in a 2008 dodge avenger?


What size engine ? Could have came with three different one's ! 2.4 , 2.7 , 3.5 L Has a fusible link , do you know what that is ? The heavier gage wire on the back of the alternator should have battery voltage . Check it with a volt meter , easier then checking at the starter , because the wire comes from the main power feed from starter . This charging system is computer controlled , your best bet , take it to a qualified repair . How to test an alternator Chrysler Dodge Jeep

Mar 08, 2017 | 2008 Dodge Avenger

1 Answer

I need to find the exact location of the starter motor relay for a 2008 dodge avenger


Starter Activation Is Controlled By Totally Integrated Power Module--Left Side Of Engine Compartment.
Can Be Checked With Scanner (buss lines) Has Solinoid On Starter

Feb 18, 2015 | 2008 Dodge Avenger

1 Answer

2008 dodge avenger will not stare


Did you do a load test on the battery? If so, check the starter.

Feb 11, 2015 | 2008 Dodge Avenger

1 Answer

Where the starter located on 2008 dodge avenger


Location of 2008 Dodger Avenger starter 4 cyl

Jan 07, 2013 | Cars & Trucks

1 Answer

What do i do if my 2008 dodge avenger message says key ignition and does not start


Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.


To confirm the problem, the basic troubleshooting is required.


Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

This will help.

Thanks.

Feb 13, 2012 | 2008 Dodge Avenger

1 Answer

How do you shut change oil display after changing oil on dodge avenger


turn key to on position but don't start, then pump gas pedal slowly 3 times and light should go off and stay off just did it on my 08 avenger

Mar 18, 2010 | 2008 Dodge Avenger

2 Answers

Reset oil change for a 2008 dodge aveneger


To reset your maintenance reminder system (even if the light hasn’t come on yet), you’ll need to turn your key to on (but don’t start!) and make sure your odometer is on TRIP A. Then key off. Press and hold the Odometer/Trip button. While holding down on the button, key the ignition to on (Don’t start the engine!) The display panel will count down from “------“ to “-“Continue pressing the button until the Trip A is displayed. After this step, you are done.

Oct 21, 2009 | 2008 Dodge Avenger

1 Answer

Dodge avenger 2008


It depends on who you go to and if you want it done right. I went to the Dealership and had them put front brakes on my 2008 Dodge Avenger and it has been in the shop every 2-4 months since then for front brakes. They replaced the entire front brake system and my 08 Avenger is still eating brakes. I finally took it to a friend who owns a auto repair shop he replace the rotors which are total about 115.00 for each from AutoZone and replaced the brake pads for 50.00 so it cost me just parts 155.00 and my Avenger is running smoothly since haven't had problems with the brakes since. Go to Midas and let them change it for roughly 89.00 avoid the dealership at all cost they can run 200.00-500.00 depending on if it is just the brakes pads or if it is the rotors and pads.

Oct 14, 2008 | 2008 Dodge Avenger

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...