Question about 2002 Dodge Durango

Open Question

Front wheels bow out at the top - 2002 Dodge Durango

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What could be wrong with my tire if it bows in


Bows in at top or bottom? More than likely
you need your suspension aligned. The tire just follows the suspension. Misalignment can cause tire wear and handling problems. Front wheel drive cars need 4 wheel alignment to insure the back isn't steering the front. Other causes are shock/strut or control arm bushing wear or failure. Tie rod ends or idler arm wear can cause tire wear as well.
All parts should be tight and serviceable before alignment.

Jan 13, 2016 | Cars & Trucks

1 Answer

2002 chevy S10 wheel problems


If you are talking front wheel the check for a bent steering rod (tie rod ) (rack end and ball joints.)

Jan 15, 2014 | 1998 Chevrolet S-10 Pickup

1 Answer

How can i get bmw 323i convertible top down manualy


If your top is electric then you will need to release the front cowl motors at the center point of the trim in front of the rear view mirror(small access plug needs to be removed and allen key inserted to drive unit.) You also need to pull the release handle under the back seat bottom(driver's side) The release handle detaches the drive units for the storage lid cover and the convertible top drive. Once the motors are released, the front of the top must be lifted approximately 6 inches and the pressure against the rear of the top will relax. raise the rear bow, open the storage lid, lower the rear bow and push the front of the top up and toward the back of the car. The top should fold into the storage area. Once in, close the storage lid until it clicks.

Feb 25, 2012 | 1997 BMW 328

1 Answer

Need proper steps for convertible top operation


The top can be used as a sunroof or taken off completely. For the sunroof, you only have to unclip the two clips by each sun visor, and fold the front bow back so it sits on top of the roll bar. There is a velcro strip that goes through a hole in the front bow, to keep it in place.
To totally take the top off, you again uncleip the 2 clips by the sun visor. When the front bow is moved partway back, the material on the front bow is loose. There are sliding clips on the front of the convertible top that are slid along the front bow, so that the material is removed from the bow itself. Along each of the doors is an elastic clip that needs to be removed. Now the front of the top is pretty loose. Around the rear windows is a metal bar, with fabric snapped around it. Undo the snaps. Then forcefully push the metal bar outwards. The material around the rear window area can then be removed from around the metal bar. At this point, you can probably unzip the rear window. There are 2 pieces of plastic that slide into plastic grooves at the very rear of each corner of the car, that hold the rear of the top down. You just pull the rear of the fabric away from the rear corner of the car. And that's it.

Dec 06, 2010 | 1994 Suzuki Sidekick

1 Answer

THE ROOF OF MY 1998 MUSTANG GOT PUSHED IN PRETTY GOOD.WILL IT BE EASY TO FIX AND HOW MUCH MONEY AM I LOOKING AT?


I'm not sure what you mean by pushed in. The top has rigid bows that support. the top. However i just replaced my top on a 96 mustang the top and rear window cost me under $300.00 (plastic rear window), I installed it myself with my brothers help and although it took about 12 hours to remove the old one and completely install the new one. An aphoulstry shop wanted $1600 to replace with heated glass. However the top I purchased had a heated glass option for an Additional $200. My Bows were still good and did not need to be replaced however it sounds like you may have bent the bow. in which case you would have to partly remove the cover to get to the bow you need to straighten if possible, or replace the bow the company i bought my top from www.convertibletopguys.com made by M&T Manufacturing. I believe they may carry replacement bows and tack strips as well. good luck

Apr 14, 2010 | 1998 Ford Mustang

1 Answer

I HAVE AN 86 FORD BRONCO WITH 6 INCH LIFT KIT THE FRONT RIGHT WHEEL IS BOWED OUT AT THE BOTTOM


sounds like you might have a bad ball joint you might notice a clunk over bumps and the steering might feel strange

Feb 25, 2010 | 1986 Ford Bronco

1 Answer

2000 sable...right front tire bald?


It could be wheel bearings/hub, ball joints, bent a-arms, or a-arm bushings. Good luck 

Dec 03, 2008 | 2000 Mercury Sable

1 Answer

89 ford mustang convertible


This is a professional job for a conv. top shop. has to be sewn in at the bottom.

Removal
NOTE: Mark vinyl to be removed so it can be returned to the same position after disassembly.
  1. Remove sail area panels as outlined.
  1. Remove staples retaining elastic straps at each side of back window glass (42006) to rear tacking strip and folding top rear number 4 bow (51278) and remove elastic straps.
  1. Remove staples retaining rear bow corner pad (537A71) and bottom of folding top back window curtain (52500) to rear tacking strips.
  1. Remove staples retaining top of folding top back window curtain to folding top rear number 4 bow and remove back window glass .
1994 mustang. don't have 89 Window, Rear Installation
NOTE: Transfer markings from the removed assembly.
  1. Mark with grease pencil center point on folding top rear number 4 bow in line with hole on rear of folding top rear number 4 bow .

Oct 07, 2008 | 1989 Ford Mustang

Not finding what you are looking for?
2002 Dodge Durango Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...