Question about Volkswagen Cars & Trucks

Open Question

Disable automatic door locks

When I turn the car on and open the door the alarm activates. It only happens when the car is on, when it is off it is fine. So close door turn car on then open door and alarm system sets. What should I check

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Alarm haywire, can't override anti-theft system or turn on car

The Alarm on my Mercedes ML320 sounded every night, then it started doing it more often, Showed it to the dealer he says it's the 'Tow Sensor', that needs to be repaced. $700, down the drain. I have already started hating this car, it eats $500-600, every 6 months...

Posted on Jan 27, 2009

Ad
  • 63 Answers

SOURCE: 2004 Honda Accord: Key will not disable alarm (not a key problem)

try pulling your negative terminal lose from the battery for a few minutes and allow the system to zero out then try it if tht don't work then visit your local honda dealership

Posted on Mar 15, 2009

  • 20 Answers

SOURCE: 2002 MB ML320 car alarm problem

it would be great if you can specify if you have a factory or aftermarket alarm.

Posted on Sep 03, 2009

dttech
  • 4803 Answers

SOURCE: Power door locks do not work with keyless remote control

There are two multiplex control units - one on the driver side and one onthe passenger side - which one did you unplug? The one on the driver side is the main "Brain" while the other one is the one that houses the keyless reciever. According to the service manual, any troubleshooting of this system must begin with the one on the driver side. It can get quite involved because Honda does not provide actual troubleshooting (symptom) charts, just descriptions of the electrical connectors and what conditions should be present at each conector pin under what system condition. (each pin has to be tested to determine what is malfunctioning) The system is not capable of outputting fault codes of any kind.

Posted on Nov 08, 2009

alicantecoli
  • 22219 Answers

SOURCE: 2006 kia spectra. The power door locks

security ----encrypted software dealer only

Posted on Dec 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

Tip

How to set & cancel theft deterrent system or how to set & cancel security...


Theft deterrent system (on some models)

Theft deterrent system is designed to deter vehicle theft. The system flashes the turn signal lights and turns on the interior light or the signal lights only (depending on the model), and sounds security horn and vehicle horn when it detects abnormalities such as follows:

• Any door or hood is forcibly opened.
• The batter terminal is disconnected and then reconnected
• The system control is disconnected and then reconnected.
• Abnormal impact is detected when the impact sensor function is on.

The system flashes the turn signal lights and turns the interior light or the signal lights only (depending on the model), and sounds security horn and vehicle horn if someone attempts to damage or break into your car.

Setting the system

You can set the system with or without the impact sensor function. For details, see "Canceling the impact sensor" below.

1. Turn the ignition key to "LOCK" and remove it.
2. Have all passengers get out of the vehicle
3. Push the lock (set) switch on the wireless remote control key once. At this time, the turn signal lights flashes once and the security indicator light comes on.

The system is set after 30 seconds. At this time, the security indicator light start flashing slowly.

Once the system is set, you cannot start the engine until you cancel the system.

The system will not be set in the following cases.

• When any of the door is open; security horn sounds for 1 second, close the door and set the system again.
• When the hood is open; close the hood securely.

Canceling the Impact Sensor

The impact sensor can be cancelled to prevent false alarms from being triggered incase of the following conditions:

• When parked in the noisy area
• The vehicle body or glass is subjected to a strong impact from the (such as in highly pressurized car wash).
• When transporting by a car carrier or ferry.

To cancel the impact sensor;

1. Lock the door by pushing the lock (set) switch on the wireless remote control key once, and turn signal light flash once
2. Then push the lock (set) switch twice within 5 seconds. At this time, the turn signal flash 5 times to indicate the impact sensor function is disable.

The impact sensor is deactivated as long as the system remained armed.

Canceling the system

The system will be cancelled by the following two ways:

• Turn the ignition key from "LOCK" to "ON" position.
• Unlock any of the doors by pushing the unlock (cancel) switch

If the turn signal lights flash 3 times, the system has been alarmed. Check to see if there is any abnormality with your vehicle.

If any of the doors is not opened within 30 seconds, all doors will be automatically locked and the system will be set.

When the system is set

Activating the system; When the system detects abnormalities such as follows, it flashes the turn signal lights and turns on the interior light or the turn lights only (depending on the model) and sounds the security horn and vehicle horn of 30 seconds.

• Unlocking any door without using wireless control
• Any door or hood is forcibly opened.
• The battery terminal is disconnected and then reconnected.
• The system control assembly is disconnected and then reconnected
• Abnormal impact is detected when the impact sensor function is on.

Reactivating the alarm;

Once set, the system automatically resets the alarm after the alarm stops.

The alarm will activate again under the same circumstances described in "Activating the system".

Stopping the Alarm

The alarm will be stopped by the following two ways;

• Turn the ignition key from the "LOCK" to "ON" position.
• Unlock any of the doors by pushing the unlock (cancel) switch.

The system can be cancelled by these ways at the same time.

If the battery becomes discharged due to the vehicle being unused, for a long time etc., when the battery is recharged or replaced, the system will activate the alarm. If this happens, immediately unlock any of the doors by pushing the unlock (cancel) switch, and the alarm will stop.

Testing the system

1. Set the system
2. Insert a wireless remote control key into the key hole on the driver's door handle, and unlock the door.
3. Open the door, and an alarm will sound.
4. Stop the alarm by pushing the unlock (cancel) switch.
5. Repeat this operation for the front passenger's door.

Good luck.

on Nov 08, 2010 | Toyota Pickup Cars & Trucks

1 Answer

My 98 kia sportage wont start


It sounds like the key sensor in the drivers door is malfunctioning, the drivers door is the only door that can enable/disable the alarm, if you try to unlock any of the others it will trigger the alarm.

Sometimes with my Kia I have to (without opening the door), cycle lock and unlock several times before the alarm is disarmed.

Have you tried this is succession, with all the doors locked:-

put the key in the drivers door, turn to lock and then to unlock, the alarm should disarm.

Also, if any of the door locks are jammed, the alarm will still activate when you try to unlock the drivers door.

If that fails and the alarm still activates, then it's a problem with the key sensor in the door.

Mar 30, 2014 | 1998 Kia Sportage

1 Answer

2004 honda accord ex doors lock and alarm sets automatically


does the dome light come on when the drivers door is opened, if not the pin switch is bad

Jan 20, 2013 | Honda Accord Cars & Trucks

2 Answers

Remote won't work, can't start car (alarm system goes off) Also, key won't turn manually in door. FYI` car battery replaced a few months ago. Also tried replacing batteries in remote. When I parked the...


Open the trunk with the key, it will disable the alarm. You probably need a new door lock cylinder, which you should look into. They're easy to replace, but take a while to get, as they have to be coded for your key. You can also remove the door lock cylinder by loosening the t20 torx screw near the door handle until the lock cylinder slides out(DO NOT LOOSEN MORE THAN NECESSARY TO GET THE LOCK CYLINDER OUT), then use a flathead screwdriver through the hole to activate the lock.

Feb 06, 2011 | 1998 Volkswagen Beetle

1 Answer

How do i manually release the rear door on a ssab 9-3 2003 as the door module has failed


Trunk Lock After Closing
--------------------------
Desc.: What happens to the trunk lock when closing it.

Settings:
Yes: Automatically lock Boot on closing
No: Boot can be reopened using micro switch button located on the trunk/boot

* Trunk Lock After Drive Off
----------------------------
Desc.: Should the trunk be locked at drive off or after 30 sec.?

Settings:
Yes: Trunk/Boot will automatically lock when vehicle increases speed
No: Trunk/Boot will remain closed, however will be in the unlocked
condition if No was selected in the previous option.

* Door & Trunk Unlock at Key Out
--------------------------------
Desc.: When the is removed from the center console should door/trunk
be unlocked?

Settings:
Yes: All Doors & Trunk/Boot will Unlock when the Key is removed from
the Ignition Switch If Driver frequently locked all Doors when
driving
this feature would be beneficial.
No: Doors and Boot will remain in the same condition as they were
prior
to Key removal

* TSL Locking Logic (Theft Security Locking/Deadlock)
-------------------
Settings:
TSL at first Press: Default Setting. All Doors will lock in Deadlock
Mode
TSL at Second Press: All Doors will lock in Deadlock mode at the second
press of the Remote.

* Lock /Unlock Acknowledge
--------------------------
Settings:
None : No acknowledge will be visible
Indicators: Indicators will blink as acknowledge

* Follow Me Home Function
-------------------------
Settings:
Tail Light: When selected Tail Lights will be illuminated
Back Up Light: When Selected Reverse Light will be activated


Tech 2 Body Exterior Lighting & Horn
====================================

* High Beam Follow me home Active Time
--------------------------------------
Desc.: Follow Me Home Active Time can be adjusted between 0- 10 minutes

Settings:
This Feature can be turned on or Off .Yes / No can be selected.
Low Beam Automatic / Low Beam also in Position 0 (light switch)
Yes / No
Follow Me Home Active Time
- Daytime Driving Lights can be activated

* Parking Lights
----------------

Settings:
Act as Lead Me To the Car Light.

* Park Light On Reminder
------------------------
Settings:
On / Off
If Ignition is turned Off and the parking lights are active, Driver will
be warned if set to on.

* Show Trailer Light Outage
Desc.: REC will detect blown trailer light and display on SID

Settings:
Yes or No

* Trailer Light / Fog Light off
-------------------------------

Settings:
Yes: Fog Light Rear will be disabled When Trailer is connected Yes
No

* Horn Lock Unlock Acknowledge
------------------------------
Settings:
On: Horn will honk when car is locked
Off: Horn will not honk if car is locked


Tech 2 Body Locking
===================

* Panic Alarm Activation (Vehicles fitted with /Alarm only)
-----------------------------------------------------------
- Panic Button / Locking Switch
Central Locking Switch Driver /Passenger

Settings:
- Panic Button on Remote and locking switch inside vehicle will
activate alarm
- Panic Button will activate Alarm only
- Locking Switch inside vehicle (driver /passenger will activate
alarm only
- No Panic Alarm function required.

* Unlock Logic
--------------
Settings:
All at first press : All Doors will open & Fuel Lid will unlock if the
Driver or Passenger Door Switch is activated
Driver Door & Fuel Lid at first press : Only the drivers Door will unlock
& Fuel Lid will unlock when door
switch is activated

* Remote unlocking One Press
----------------------------
Settings:
All at first press: All Doors will open & Fuel Lid will unlock if the
Remote is pressed
Driver door & Fuel Lid at first press: Only the drivers Door will unlock &
Fuel Lid will unlock when the Remote
is pressed

Dec 17, 2010 | 2003 Saab 9-3

1 Answer

My automatic door locks are locking without me activating them and they will not open when I do activate them or as soon as I unlock them they will immediately lock again and it will happen repeatily until...


There is a personal settings that you might disable. It lock when you came speed came over 24km. Write to me to my email jck14 @ hotmail . com I will tell you

Sam

Nov 17, 2010 | 2005 Chrysler 300

1 Answer

Vehicle inoperable due to security system lockup, engine will not engage because alarm cannot be disabled


Try this: open the driver's door (or whatever you have to do) to get the alarm to go off (activate) . Then, while it is honking the horn or doing whatever it does , walk around the car to the front passenger door and using your door key turn the lock cylinder to the lock and then unlock position . I believe this will disable the alarm system if it is a factory installed OEM alarm .

Sep 05, 2010 | 1995 Cadillac DeVille

2 Answers

CAR ALARM


put your key in the drivers side from the outside door and turn the key one time to the right to lock your car and two times to unlock it and if your having trouble with the alarm going off open the trunk with the key to disable the alarm if it turned on.

Aug 04, 2008 | 2000 Volkswagen Jetta TDI

1 Answer

Car Alarm/Door lock


This happened to me too...It turned out to be that my door was out of adjustment, which caused the door position sensor to not know whether the door is closed or open. Sometimes my light on the inside of the door would flash (because the car thought that the door was open). Once the alarm did activate, the car would sometimes think that the door had opened, thus causing the alarm to activate. It was cheap to have fixed...I think it was less than $100 at the dealership.

Jul 08, 2008 | Hyundai Motor 2004 Sonata

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76682 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...