Question about Chrysler Crossfire

Open Question

Chrysler crossfire srt6 engine oil pressure warning light

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 57 Answers

SOURCE: Audi 80 oil pressure light

i think from memory that the oil pressure switch is at the back of the cylinder head, if its not there it will be located just above the oil filter, these switches are very cheep to buy and can be bought from any good motor factors. You are right to suspect the switch, its the first thing to eliminate before bogging your self down with more complicated and expensive problems.

Posted on May 14, 2008

Ad
short shadey
  • 421 Answers

SOURCE: 6 Cyl 1998 Toyota Camry Oil Pressure Light

these cars have problems with bad oil pressure warning switches you may have someone put an oil pressure gauge on the car and make sure your pressure is within spec and go ahead and change the sender if it checks out please rate -jeff

Posted on Sep 01, 2008

  • 49 Answers

SOURCE: OIl pressure light flickers

change the oil pressure switch or the wrong oil

Posted on Jan 18, 2009

  • 202 Answers

SOURCE: 2002 Chrysler Sebring Oil pressure light

Could be a bad oil pressure switch, or a bad oil pump. Both will cause this issue. Hope it is the switch b/c the oil pump is a costly repair.

Posted on Mar 26, 2009

  • 297 Answers

SOURCE: OIL PRESSURE WARNING LIGHT SHOWN UP ON AUDI A4 1.8 T SPORT

Is a pressure converting element on the block. Can be leak or shot. Or wire harnes problem worst case. If leak you see dripping oil mostly. Had that 2 times on a car.

Posted on Apr 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Chrysler crossfire fault code p0410 Engine warning light on


Secondary air injection system P0410
First check the fuses and relays for the secondary air
Pump, if blown, replace them...otherwise, replace the pump..

Jan 24, 2018 | Chrysler Cars & Trucks

1 Answer

Pt pt crusuier oil light wont turn off


If you mean the oil pressure warning light, it could be the pressure switch, or the engine could have low oil pressure.

Mar 27, 2015 | Chrysler PT Cruiser Cars & Trucks

1 Answer

2008 Chrysler 300 5.7L. Oil warning light is on. Did reset. Still comes on. Much noise as if oil is not getting to engine.


The warning light is probably for low oil pressure, which is likely the problem if you are hearing engine noise.
Don't drive it until you get a mechanic to check the oil pressure.

Jun 12, 2013 | Cars & Trucks

1 Answer

Oil light is still on after the oil change and reset the mile


Is it the red warning light for low oil pressure ?

Mar 05, 2013 | 2005 Chrysler Crossfire

1 Answer

Why does the oil pressure light comes on


The oil pressure warning light comes on to warn the driver the oil pressure in the engine has dropped below 10psi.
The reason could be the engine is low on oil, or there is a problem with the oil pump or other internal engine component.
The oil pressure switch could also be faulty.

Jan 27, 2013 | 2004 Chrysler PT Cruiser

2 Answers

Oil light flickers when in idle. Oil on dip stick measures fine.


install a mechanical guage to test the actual pressure, if its fine the sending unit is faulty, if nor remove the oil pan and check the oil pickup for blockage,

May 24, 2010 | 1999 Chrysler Concorde

2 Answers

2005 Chrysler Crossfire Can too much oil and resulting HIGH OIL PRESSURE indication result in a ''bad oxygen sensor'' reading on the diagnostics?


yes cos the engine is blowing oil out of the exhaust manifold onto the lambda probe(oxygen sensor)which
is reading unburnt fuel/sensor fault.drain oil ASAP.

Apr 06, 2010 | 2005 Chrysler Crossfire

1 Answer

HI OIL PRESSURE INDICATOR COMES ON FOR ABOUT 10 SECONDS


do you hahe the correct oil in the engine? An oil that is too heavy will cause high oil pressure, especially when it is cold. If the oil is correct than you need to check the hi oil pressure sending unit.

Mar 11, 2010 | 2004 Chrysler Crossfire

1 Answer

2004 Chrysler Crossfire (not SRT6)


I got my manual on ebay for around $25. I wouldn't try injector maintenance. Leave to a professional. You don't want to take your car apart that much. The injector cleaners are also a scam so don't waste your money buying them to ad to your fuel tank.

Jul 04, 2008 | 2004 Chrysler Crossfire

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...