Question about GMC Cars & Trucks
You will have to unplug the in-tank unit's connector,and figure out which wire is the fuel level sender.If you ground it,the gauge will go to full or empty(can't remember which)and it will go to the opposite extreme when you unground it.(Most likely the sender is bad,and if you are pulling out the in-tank unit,do yourself a favor and replace the fuel pump at the same time).
Posted on Nov 26, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
had same problem on my XUV. changed the blower motor resistor, located under passenger side dash. easy to change, works no problem.
Posted on Feb 17, 2009
If I remember correctly if you look at the back side of the fuse cover, it should tell you what the fuses are. Also in the owners manual in the index, under fuses, it should give you a diagram of the fuse location for the acc. outlets. Good luck. The fuse should be a 20 or 25A fuse.
Posted on May 26, 2009
Relay in fuse box under hood on driver side wheel well labeled HDM, #46 on 2004 Envoy XUV. Swap with relay #45 labeled "Fan" to test. That was my problem.
Posted on Sep 13, 2010
There are two fuse boxes/block One fuse block is located under the hood in the engine compartment on the driver's side of the vehicle. Remove the primary cover by pressing the two locking tabs. Remove the secondary cover by snapping off while lifting. To reinstall the fuse panel cover, reverse
The 2nd fuse box is located under the rear seat cushion
There are two fuse boxes/block
One fuse block is located under the hood in the engine
compartment on the driver's side of the vehicle.
Remove the primary cover by pressing the two locking
tabs. Remove the secondary cover by snapping off
while lifting. To reinstall the fuse panel cover, reverse
Posted on Oct 06, 2010
Tips for a great answer:
Apr 11, 2014 | 2007 Chrysler Sebring Sedan
Nov 26, 2013 | GMC Cars & Trucks
Mar 25, 2011 | 1989 GMC Sierra
Feb 09, 2011 | 2003 GMC Envoy
Mar 19, 2009 | 2003 GMC Envoy
Jan 20, 2009 | 2003 GMC Envoy
65 people viewed this question
Usually answered in minutes!