Question about 2007 Pontiac G6

1 Answer

Where is the blower resistor on the blower motor in a 2007 Pontiac G6? I can't locate the blower motor.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 113 Answers

Under the dash.

Posted on Dec 30, 2013

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
burkholder
  • 25 Answers

SOURCE: where is blower motor resistor

There is a resistor pack for the fan speed in the ductwork near the fan.. It is very easy to replace once it is located. Ussually there are either one or two 5.5mm screws holding it in place. Once you get it out you will notice the resistors that are burnt.

Posted on Jul 27, 2008

omaromid
  • 332 Answers

SOURCE: How to clean O2 sensor on a 2007 Pontiac G6?

O2 sensor are located before and after Catalytic Converter ( exhaust system of your car). If you car's engine is 4 cyl you have 2 O2 sensors and if you car's engine is 6 cyl then you have 4 O2 sensors ( for each bank, 2 for left bank and 2 for right bank). Hope it helps and comment if you need more advice. Please don't forget to rate the answer it helps with my ratings, thanks!

Posted on Apr 28, 2010

  • 1140 Answers

SOURCE: location of oil filter on a 2007 pontiac g6

Oil filter location for a 2007 Pontiac G6. First open and lift the front hood of car. Its some what right from center on the engine about 9 inches from the radiator. All you will see is a black cap with black plastic nut in the center. You will have to buy a special tool to attach to your socket wrench to remove the cap. Turn it counter clockwise to remove it. Inside is a filter attached to a plastic part and rubber o - ring. The filter is NOT enclosed in a metal casing. Remember how it is positioned as you take it out. Pull off the old filter. Remove the old o - ring. Place new o - ring in place. Place new filter on plastic part and place it back inside the engine. Make sure it is placed in the same way it came out. Screw on plastic cap by hand most of the way. The tighten with special tool and socket wrench clockwise, but not too tight. This is now complete. Now you can drain out the old oil from the oil pan underneath the car. Remove hex screw with long wrench for more leverage. One to 2 hours later place hex screw back in by hand and tighten with wrench. Now add about 4 1/2 quarts of 5W30 oil only. Check oil level on dip stick. Add more oil if necessary. Job complete!!!

Posted on Nov 29, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why dose my heater only run on the 4th speed of my 2005 pontiac g6 ?


You will need to replace the "Blower Motor Resistor", which is not difficult for the average person to do. Here's a video demonstrating how to do it:
2005 Pontiac G6 Blower Motor Resistor

Aug 04, 2014 | 2005 Pontiac G6

1 Answer

Blower motor for pontiac 2007 g5 not working


blower control module ( blower resistor) goes bad on all gm models it is located inside the car on passenger side of hvac case.

Nov 24, 2013 | 2007 Pontiac G5 Gt Coupe

2 Answers

Pontiac G-6 blower on my heat will not turn off when I cut off engine. Light that displays internal temperature will not cut off either.


You may have two problems, the check engine light , you will need to have the computer scanned for codes . get me the codes and i can help you with that, you may need to go to a shop or an auto parts store that can scan codes.

As far as the blower staying on that may be a bad blower motor resistor , it may be back feeding power also. locate the resistor, the best way is to look under passenger side of dash.
locate the blower and then follow wires from the blower and to the side of it you will find the resistor it slides into heater box and plug sits out side box , the wires from blower will go to resistor, unplug resistor connector and see if blower cuts off. if it does then replace the resistor, here is a picture of it. good day.11_18_2012_6_22_48_pm.jpg

Nov 18, 2012 | 2007 Pontiac G6 GT Convertible

1 Answer

HOW TO REPLACE BLOWER MOTOR RESISTOR ON PONTIAC G6


where can i find the block resistor of my 2005 pontiac g6?

Jul 24, 2012 | 2005 Pontiac G6

1 Answer

How to replace a blower motor on a 2006 G6


For this replacement procedure,click this link below :---How to replace blower motor and blower motor resistor on Pontiac G6?http://technoanswers.blogspot.in/2012/02/how-to-replace-blower-motor-and-blower.html
---------Also more help solutions recommended.Click the link below :---Blower motor replacing for all vehicles?http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html----------This will help.Thanks.

Feb 01, 2012 | 2006 Pontiac G6

1 Answer

Where is heater blower resistor located on 2006 g6 v6


It is located on the passenger side under the dash by the blower motor. This may not be a blower resistor on this vehicle but possibly an blower module. In either case location is the same.

Feb 18, 2011 | Pontiac G6 Cars & Trucks

2 Answers

My blower motor on my 2005 g6 only has one speed...hi....could it be a fuse and if so where is the panel located....thanks.


I have the same problem with my Pontiac GT6. It is not the fuse, it is a circuit board. It is a board that has 4 connectors your low-high. The 1st 3 burn out so you are left with your high heat.....which eventually is going to burn out too!

Sep 25, 2010 | 2005 Pontiac G6

1 Answer

2007 Pontiac Vibe - Fan only works on high. I removed the cabin filter and checked the fan blower. It seemed not to be bound up.


The blower resistor has failed.It is located right next to the fan blower motor. It is located passenger side under dash.Check the pigtails to make sure no wires appear damaged.

Sep 17, 2010 | 2005 Pontiac Vibe

2 Answers

G6 GT2007 Blower fan does not work at all. All


check relay HVAC relay.if all is good.blower motor is bad or HVAC control switch is bad.

Nov 22, 2009 | 2007 Pontiac G6 GT Convertible

2 Answers

The heater/AC in my '05 G6 only blows on high. Do I have to take it in to a dealer or can I reset it myself?


Your blower motor speed is controlled by a Blower Motor Control Processor and a HVAC control module.You should take your car to a Dealership.

Oct 26, 2009 | 2006 Pontiac G6

Not finding what you are looking for?
2007 Pontiac G6 Logo

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...