Question about 1999 Chevrolet Blazer

2 Answers

99 chevy blazer lt front passenger window will not work up or down. from either driver switch or passenger switch

Posted by on

  • rlkidd58 May 08, 2009

    I found a corroded conector, thanks for theinput.

  • rlkidd58 May 21, 2009

    Beretta01 thanks for the input , I fixed the window , but your instructions for removing the door handle was very helpful

    Thank you

×

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 45 Answers

Hi: If other windows work then it can't be FUSE. I would take off the door panel and use a 12 volt test light to see if power is getting to the front passenger door motor (make sure power control switches are attached, key on position). If power... then hot wire the window motor using a 12 volt battery to see if it works. Hook + and - wires from battery directly to the motor, reverse them to make motor go up or down. To remove door panel pop electrical control up for the front and lift out then disconnect plugs. Use 7 MM socket to remove 2 screws under where handle is located. A Phillips screw driver removes the door handle cover. Pull on door panel to pop off, whole process takes under 5 minutes. If motor works and no power to motor from drivers door then there is a broken wire in circuit or the drivers control unit is not working. NEXT... disconnect drivers door control unit and check to see which brass terminals have power (key on position), note them... then put 12 volt power from battery to a terminal from plug that was attached to the passenger door motor, using your test light check drivers door plug to see if there is power to any terminals you DID NOT MARK as having power, if power then you know the circuit is good, do this with both wires from passenger door motor plug. (A circuit tester can be used as well). If continuity then the problem is in the drivers door control unit. If no continuity then a break in the wires to the passenger door, breaks usually occur between the body A pillar and where the wires go to the door as it flexes there every time the door opens or closes. Hope this helps, rate so I know if it is worth my while helping out on here.. thanks...

Posted on May 21, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 147 Answers

Check the fuses ... first ..next get a voltmeter and probe the connections at the motor in the window while pushing up and down ... look for the voltage to change .if it changes when your opening and closing and the motor does not turn then check the connections to the motor. check all connections in this circuit

Posted on May 08, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why doesn't my 2000 chevy blazer power windows and door locks and remote mirror doesnt work. Power window on passenger side does work


well, the first thing is to check the fuses and or relay for power windows.should be listed in your owners manual. if ok, then remove switch from drivers side window and check for power. if power to the switch then use a jumper wire from power side to motor side of switch. if window works then its the switch causing the problem. Good-day!

May 04, 2014 | 2000 Chevrolet Blazer

1 Answer

Front power windows stopped working


its usely the switches on the drivers door get a switch bundle from the auto wreckers .i dont deal with this enough to know why when the drivers switch wears out it affects both front windows .very common on chevy canyons. < japanease switches. new switches are insanely priced thats why suggest a auto wrecker switch bundle.

Nov 21, 2013 | 2006 Mazda 3

1 Answer

What color is the neg and pos wires to the passanger side speaker in a 99 chevy blazer


Hello, I am assuming it is the rear passenger speaker. Please refer to the list below for the wiring of your aftermarket speaker.

Radio Constant 12v+ Wire: Orange
Radio Switched 12v+ Wire: Dark Green
Radio Ground Wire: Black
Radio Illumination Wire: Gray
Stereo Dimmer Wire: Violet/White
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue

Feb 13, 2013 | 1999 Chevrolet Blazer

1 Answer

Driver side power window won't go up on 99 chevy blazer


bad switch or motor
To check the motor the motor has two connections. One for up and one for down. Try hot wiring the connections to check. If it works the drivers switch is bad

Apr 30, 2010 | 1999 Chevrolet Blazer

1 Answer

Passenger front /rear windows will not work 99 jeep gr cherokee


ill suggest theres a broken wire between the drivers door and the body in that accordian looking thing.

Sep 06, 2017 | 1999 Jeep Grand Cherokee

1 Answer

2006 Chevy Impala power windows won't work


It does sound like you have a short in the master switch on the drivers side. If the passengers switch does not work, check the left master switch and the window lock switch.

Jul 19, 2009 | 1994 Chevrolet S-10 Blazer

1 Answer

98 chevy blazer power window issue


sugest fuse ck 1st thing. Master bypasses individual controls. Power supply to rear windows is interupted. Ck for connevtor under front seats. Fuse may be labrled accessory or per win.

May 12, 2009 | 1998 Chevrolet Blazer

1 Answer

Driver Side Window won't work- Chevy Blazer 2003


If it does not make any noise, or sound like its getting any power, most likely its the switch.

Feb 20, 2009 | 2003 Chevrolet Blazer

2 Answers

All 4 power windows on 1999 Chevy S-10 Blazer started moving slow and then stopped working.


they have a relay for the windows i would start there check with dealer for location or your parts store as they are located all different places

Oct 26, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
1999 Chevrolet Blazer Logo

860 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...