Question about 1995 Chevrolet Blazer

2 Answers

Wont pick up speed on take off

My 95,s10 blazer wont pick up speed on take off. It feels like its dragging and its burning alot of gas. I already cleaned the EGR. Got a new distributor and a new position sensor.. I have not done the fuel filter yet. but I still dont think thats it. Its very frustrating

Posted by on

  • Abraham Castillo
    Abraham Castillo Dec 12, 2013

    Well everyone i got it fixed it was the intake manifold gasket and my fuel injection.. hahaahaha runs way better, now I just need a air intake... would a cold air intake fit?? .



2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert who has answered 20 or more questions within one hour.


    An expert who has answered 20 questions.

  • Expert
  • 73 Answers

Take the fuel filter off for fun and see if ya can blow through it at least fast and not cost but a few min s...
If burning a lot of gas ,,timing ?...bad plugs ..wires
you can check wire out by just unplugging one and seeing if that changes idle at all until ya find one that does not ...wooot bad plug or wire...

Posted on Nov 26, 2013

Testimonial: "my fuel filter was dirty as hell lol.. I had to get another one .. thanks :)"

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Try plugs and some injection cleaner..

Posted on Nov 26, 2013


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 195 Answers

SOURCE: 95 Blazer Vortec starting problem.

The TPS has three wires that go to it in general. You have a power lead (constant 12 volt source) , a ground, and a variable lead of 1-5 volts. If you do not have a 12v constant source check for an open or short in the sensor harness. Now you had the TPS replaced, and no start. What is your fuel pressure? If you check your fuel pressure and it is on the low side of range it will not start, nor if it does start run well.
I have to run for parts but will be back shortly. I will get back on line and be available for chat if you wish so we can figure this out further.
RPM Northwest

Posted on Jan 29, 2009

  • 98 Answers

SOURCE: 95 S10 blazer won't start

check the EGR valve. it might be dirty in side with carbon. DONT GRINE OFF GASKET SCRAP IT OFF.

Posted on Apr 22, 2009

  • 2559 Answers

SOURCE: S10 blazer speed sensor where's location for replacement

On the rear axle.

Posted on May 06, 2009

  • 532 Answers

SOURCE: 1994 chevy s10 blazer turns over, won't start

try replacing the fuel regulator,or is the oil cap on tight?the fuel regulator works on base vacumm

Posted on Sep 07, 2009

  • 134 Answers

SOURCE: 1986 corvette running rich at idle, give it gas

have you tried checking the map sensor this can sometimes cause the engine to run oddly. also check for good spark check wires when its pitch black out check for wire arching. also check fuel pressure with a pressure guage.make sure cap and rotor are clean of deposits. keep searching and you will find the weak link.

Posted on Oct 08, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


The temperature gauge sensor for a 1995 Chevy Lumina is located in the sending unit. --------------------------------------------------------------------------------
PSA BSI tool

Mar 20, 2013 | 1994 Chevrolet S-10 Blazer

1 Answer

My blazer lacks acceration and I lose speed climbing

try changing the egr valve and if that doesnt work try the tps sensor. i had the same problem with my 94 s10 pick up and i changed many things

Mar 30, 2012 | 1996 Chevrolet Blazer

1 Answer

I have a 95 blazer 4.3 engine comes up with a random mutltiple missfire.It idels rough and runs rough going slower speeds 25-35 mph,but at the speed limit or faster it runs alot better,what could be the...

Sounds like needs a tune up, New spark plugs-wires, could be running on 5 cil. put a new fuel filter on, this helps sometimes. Buy gas treatment at Autozone, you may have water in your gas, run all the gas out and buy gas at a different place than before. Try and get 91 oct. better fuel may help.

Feb 15, 2010 | 1995 Chevrolet Blazer

1 Answer

93 s10 blazer, 4.3 engine code w...cranks and runs acdelco fuel pump in january. new plugs,cap and rotor button,new wires and coil. engine has a ''miss'' for lack of better word under load from...

I don' know if this could be your problem or not, but i had a simmiler problem on a 95 blazer i had,first i thought it was the egr valve, so i took it off cleaned it real good both valve and intake, put it back on it helped but it was still there, my friend a cert. michanic said it was in the injection system just a little skip in the engine when you were just crusing down the road at a steady speed like a gust of wind would hit you, at that time my friend witch is a certified michanic at a chevy dealer advised me to trade it off so i did, at that time it would cost me around 800 to 1000 bucks to fix, but i'am sure its a lot cheaper now, as this was 7 or 8 years ago. Thies injection systems were put on the 4.3 vortex engines, if yours is not a vortex i would say its still a problem with the throutle body.

Dec 31, 2009 | 1993 Chevrolet S-10

2 Answers

Engin runnig ruff. enjecters dupping alot of fuel. gas is burning rich.takeoff is dragging. no power at all. i already replced the egr valve,and altenator, and checked all vacum lines for leaks.i did a...

If it is the throttle body type you will have to replace the injectors, the alchol in gas kills th plastic parts in the injectors, be sure to buy from the dealer and get the new ones that will work with ethnoal, also costs $105.00 each there are two of them.

Jul 28, 2009 | 1995 GMC Sierra C1500

3 Answers

I have a chevy blazer 94 S10 still quit on the road.

How is it running before it quits onyou. This could be the culprit of an egr valve. How many miles on thevehicle. The egr seems to die on a certain mileage pattern. Also youcould start by cleaning the egr valve before replacing it. This couldvery well help the situation, but this is just a guess. Hope thishelps!!

Apr 30, 2009 | 1994 Chevrolet S-10 Blazer

2 Answers

My 95 chevy blazer fuel preoblem i think

Check the Fuel pump with a presure guage.

Apr 21, 2009 | 1995 Chevrolet Blazer

2 Answers

1994 chevy blazer 4.3l feels like miss at idle only new cpi,egr, vac leaks comp good tsb 4 crank sensor w/ spacer shim?

Just some quick checks: I'll assume you haven't received any error codes.
fuel filter,bad gas(water in the gas), indication of failing fuel pump(the 4.3 is notorious for its pump problems),dirty spark plugs, clogged fuel injectors, failed fuel injectors, MAF malfuntion(mass airflow sensor), I could go on...


Oct 11, 2008 | 1994 Chevrolet S-10 Blazer

Not finding what you are looking for?
Cars & Trucks Logo

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides