Question about 2002 Mazda Tribute

Open Question

Where is the heater control valve 2002 mazda tribute

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Where is the ignition coil pack located on 2002

The ignition power pack and (aka ignition coil) is located on the 2004 Mazda MPV at the end of each spark plug wire on top of the spark plug. The front ones are easy to replace and all 3 can be done in about 30 min. The back ones are another issue. I had to take off the intake manifold on the top of the engine to get to them. This was about a 5 hour job. The installation of the new unit is pretty simple once you gain access to them. you simply disconnect a clip on wire and take out one screw and reverse the process to put in the new ones. Factory units run about $80 each. You can get them at other locations in after markets for as low as $55. Good Luck.

Posted on Jul 23, 2009

Hrnsly
  • 154 Answers

SOURCE: the cruise control is not working 2002 Mazda Tribute

you have a bad cruise cable, this is a very common problem with the tribute. just go to your local dealer and have them replace it for you, it only takes about 30 minutes to do

Posted on Aug 13, 2009

  • 1146 Answers

SOURCE: how to remove radio

Hi:
You need a pair of U shaped unlocking tools. They are available at stereo installer stores, or even best buy, I fabricated a set out of a coat hanger! You pop the bezel off around the radio, and the release tools get inserted on the left and right sides of the radio deck

Posted on Nov 19, 2009

teemossinmia
  • 265 Answers

SOURCE: 2001 Mazda Tribute (3.0 L) Heater motor functions on high only

Its the Blower Resistor....If it was the switch, it probably wouldn't work at all....But the Resistor will give you those symptoms, of working on high med or low

Posted on Jan 19, 2010

  • 60 Answers

SOURCE: how to change spark plugs on 2002 mazda tribute

See the tips section of my profile. I have complete instructions for the V6.

Posted on May 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

EGR valve Mazda 2002 V-6 Tribute replacement


25348714-wbcquewu0r2lyixgzwrhmelx-3-0.gif

  1. Remove the EGR valve.
  1. Disconnect the vacuum line.
  2. Disconnect the EGR tube.
  3. Remove the EGR valve and discard the gasket.
NOTE: The EGR valve sealing surfaces are soft metals.

  1. To install, reverse the removal procedure.
  1. Carefully clean all sealing surfaces and install a new EGR valve gasket.

Jan 01, 2015 | 2002 Mazda Tribute

1 Answer

Washed the engine on a 2002 mazda tribute 3.0l it melted the egr and will only idle no power


You probably will have to take your Mazda to a mechanic and have everything replaced that you ruined by power washing the engine.

Oct 23, 2014 | 2002 Mazda Tribute

1 Answer

Where would the pvc valve be located in my 2002 mazda tribute or is there one?


It will be located on your valve cover, if yours is equipped with one.

Feb 18, 2010 | 2002 Mazda Tribute

3 Answers

My daughter's 2003 Mazda Tribute sometimes won't stay running. It will start but when you take your foot off the gas it stalls. She's had it towed home and then it starts right up!


if when running it runs well apart from idle problem i would suggest you have the throttle body and idle speed control valve cleaned out and add a fuel system cleaner to fuel tank also check wireing to idle speed control valve

Dec 23, 2009 | 2003 Mazda Tribute

1 Answer

The cruise control is not working 2002 Mazda Tribute


you have a bad cruise cable, this is a very common problem with the tribute. just go to your local dealer and have them replace it for you, it only takes about 30 minutes to do

Jul 13, 2009 | 2002 Mazda Tribute

2 Answers

Mazda Tribute - 2002


sounds like your idle air control valve, I had the same problem. pretty common for mazda tributes and ford escapes I'm told.. part runs about 90 bucks

Jul 04, 2009 | 2002 Mazda Tribute

1 Answer

2002 Mazda Tribute V6 difficult to start.


IT SOUNDS LIKE THE IAC VALE OR IDLE AIR CONTROL VALVE IS BAD, WHAT YOU CAN DO IS TAP ON THE VALVE. IT IS LOCATED ON THE INTAKE RIGHT BEHIND THE THROTTLE BODY, JUST TAP ON THE SILVER PART WITH THE BACK OF A SCREW DRIVER A COUPLE OF TIMES. THIS SHOULD UNSTICK THE VALVE AND YOUR TRIBUTE SHOULD RUN. THEN IT IS JUST A MATTER OF REPLACING THE VALVE. YOU CAN GET THEM FROM ANY AUTO PARTS HOUSE.

Jun 29, 2009 | 2002 Mazda Tribute

1 Answer

Mazda tribute 2002 stalling


1. will it stay running if you foot is sligtly on the gas.
if so common problem it the IAC valve located on top of the throttle body. it controls ait into the engine when throttle is closed.
2. do you hear loud fog horn like sound or hissing. this could indicate a vaccum leak.
3. are there any performance problems while driving.

my best guess would be the IAC (idle air control) valve

Jun 23, 2009 | 2002 Mazda Tribute

2 Answers

HELP!!! 2002 Mazda Tribute ES No Start


If you give it gas and it starts it is the control valve. Misfire # 6 probably coil pack

Feb 21, 2009 | 2002 Mazda Tribute

Not finding what you are looking for?
2002 Mazda Tribute Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...