Question about Mitsubishi Diamante

Open Question

2001 mitsubishi diamante gear shift removal

How do you remove the gear shift

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Removing Factory Gear Shift Knob for 2001 Jetta

On my 2000 jetta glx, I had to replace both the shift knob and boot as one. It is built as one unit. You have to pull the boot up over the shift knob, break/bend a clip to "unlock" the shift knob then pull up. I hope the new knob you got has the boot built in and comes with a new clip.

Posted on Mar 27, 2009

Ad
  • 5 Answers

SOURCE: atomatic transmission won't only has second gear

Sounds like you have a solonoid out in your transmission. No simple fix for this. You will more than likely have to drop the transmission to replace solonoid.

Posted on May 31, 2009

  • 56 Answers

SOURCE: 2001 mitsubishi diamante alternator removing it?

fi you bend the dipstick and the aircond pipe carfully away from the altenator and remove the washer bottle, that is enough room to get them out of the engine bay

Posted on Jul 01, 2009

Fixitman909
  • 430 Answers

SOURCE: removing starter on 1998 Mitsubishi Diamante

tap it a few timnes with a hammer.....it should loosen up then u decide .................. gl

Posted on Jul 24, 2009

  • 11 Answers

SOURCE: How do you remove the gear shift lever on a 93 ford ranger?

many of these trucks have a mazda trans in them, to remove these shifters you will need to remove the 4 phillips head screws from the corners of the trim around the shifter boot and pull it up out of your way. it's not necessary to remove the boot from the shifter, just lift it up for access to the top of the trans. at the base of the shifter on the top of the trans you will see a plate attached with torx head screws. remove all but 2 of them, now make sure the trans is in neutral and remove the last 2 screws and pull the shifter straight up. the shifter is now out leaving a big hole open on the top of the trans for dirt to fal into so put a wrag in it or screw a piece of cardboard to it. installation is the reverse. good luck

Posted on Oct 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2001 diamante and it will not shift in to any gears.


Yes...

You are absolutely correct.

The Mitsubishi Diamante has the advanced electronic transmission, which MUST only use "special" Mitsubishi transmission fluid.

Contrary to belief, having excess fluid in your transmission can cause havoc, just as not enough fluid can.

So, it's imperative that the fluid level be checked while engine is warm, in park at idel speed.

As the condition of the fluid is critical, you should change the fluid every 30,000 miles/50,000kms, to avoid costly repairs.

Cheers,


"if this has helped you in any way, please rate this solution"

May 18, 2010 | 2001 Mitsubishi Diamante

1 Answer

I have a 2001 diamante, while driving we heard what sounded like a blown tire, pulled over and the car would not shift into any gear? please help


ask a local mechanic to have a look ,think the transmission has blown up but what part?' i wouldnt even hazard a guess ,hence local mechanic

May 16, 2010 | 2001 Mitsubishi Diamante

1 Answer

2001 Mitsubishi Diamante


ya need keys get from radio shack r mitisbishi
they insert in to slots or holes on radio to remove

Mar 28, 2010 | 2001 Mitsubishi Diamante

2 Answers

How do you remove the radio 2001 mitsubishi diamante


Pull out cup holder, remove two screws holding in faceplate, then pop it off. Screws for radio are how visible, remove them and slide the radio out! If you leave it out for more than an hour, you will need 'code' to reset it. (antitheft)

Oct 16, 2009 | 2001 Mitsubishi Diamante

1 Answer

2001 mitsubishi diamante alternator removing it? What's the secret?


fi you bend the dipstick and the aircond pipe carfully away from the altenator and remove the washer bottle, that is enough room to get them out of the engine bay

Jun 27, 2009 | 2002 Mitsubishi Diamante

1 Answer

Transmission in 2001 mitsubish diamante


when transmissions are installed, the torque convertor has to be rotated and pushed ih until no more clicks are heard. if that was done it is possible that the electrical connectors to the transmission are not pluged in well, if all of this was done it is possible that the shift solenoids are not working

May 13, 2009 | 2001 Mitsubishi Diamante

1 Answer

Atomatic transmission won't only has second gear


Sounds like you have a solonoid out in your transmission. No simple fix for this. You will more than likely have to drop the transmission to replace solonoid.

Apr 24, 2009 | 1993 Mitsubishi Diamante

1 Answer

My car doesn't change gears, it's runing in hght gear only.


you need to get a new transmission control module, i had the same problem when i bought my 92 from the auction, i wouldn't shift from 1st to 2nd, so i found a rebuilt unit on the internet and it corrected the problem, you also might want to remove the excess tranny fluid that every one put's in when they have a tranny problem.

Nov 21, 2008 | 1992 Mitsubishi Diamante

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...