Question about Cars & Trucks

1 Answer

93 Chevy suburban 1500 would die when put into drive now it won't start at all. Replaced fuel filter and distributer cap and rotar. Still no luck. Any ideas?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

You could have a bad fuel pump have somebody to crank the engine and check bleader valve in the engine see if fuel comes out of it.

Posted on Nov 25, 2013

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
GM Elec
  • 1000 Answers

SOURCE: 92 Chevy Suburban Electrical Fuel System

I assume the fuel pump fuse is good?
The only time voltage will be sent to the fuel pump will be the first 2 to 3 seconds if the starter is not engaged. You will want to crank the engine over and check for voltage on the load side of the relay, circuit #30 at the relay.
Let me know after you check.
Regards,

Posted on Feb 23, 2009

  • 15 Answers

SOURCE: 93 accord stalled while driving....

pull one of the plugs out leave the plug wire on it and rest it on something metal on the car and have someone try to turn it over.if no spark can be seen try changing your crankshaft sensor

Posted on Mar 25, 2009

moparownr
  • 667 Answers

SOURCE: 93 ford probe no spark,gets gas,checked compression replaced cap

you should check power at each one to verify that they have power, which engine do you have 4 or 6 cyl? the 4cyl the coil is seperate from the distributor and the module is located on the side of the distributor, the 6cyl it is all inside the distributor, but to replace parts without verifing power is not cost effective. The most common ignition failure is the ignition module, but you still need to verify that it receives power.

Posted on May 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

DODGE RAM 1500 FEELS LIKE IT HOLDING BACK AND FEELS LIKE IT GONNA DIE OUT


check your fuel filter it may be blocked . If you havent replaced it in a year or so its probably due to be replaced . youll find it under the car if this is helpful please leave good feed back

May 25, 2013 | 2000 Dodge Ram 1500 Truck

1 Answer

1990 chevy suburban fuel problem just put a new fuel pump and filter in this summer last week i put new wires cap and rotar and plugs started up drove it it worked much better parked it on my hill went...


When you replaced the fuel pump, did you notice if the pick-up line was in good condition or not? I have been told by a mechanic that has over 35 yearsof experience that this was a common problem, and especially now with Ethanol being mixed in with fuel.

Dec 05, 2010 | 1990 Chevrolet Suburban

2 Answers

1997 chevy silverado 1500 350 vortech, new fule pump not working


before you drop tank again, check fuses & relay.then disconnect fuel line @ filter turn key to on position should hear fuel pump run and get gas stream out of line. if no flow from line new pump faulty be sure & remove negative battery cable first good luck.

Jun 04, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

No fuel to motor


fuel pump or fuel filter. have someone kneel near fuel tank and listen for buzzing noise when ignition is turn on if you hear the sound i would change filter

May 14, 2009 | 2003 Chevrolet Suburban 1500

1 Answer

92 Chevy Suburban Electrical Fuel System


Check fuel flter at fuel pick-up intank (looks like a small wire sock). Remove fuel filter and fitting at fuel rail. Blow out fuel lines w/about 35lbs air press. Ck electrical @ relay - should be 4 connectors - one is key on hot/one is always hot/one is ground and last is hot to fuel pump. Good Luck

May 03, 2009 | 2002 Chevrolet Suburban

2 Answers

2003 chevy suburban keeps dying


fuel filter. it sounds like it is clogged.

Jan 08, 2009 | 2003 Chevrolet Suburban 1500

1 Answer

2003 Chevy suburban dies while driving


eather it is the alatanoter over heating or the coil probly the coil i would beleave

Dec 14, 2008 | 2003 Chevrolet Suburban 1500

2 Answers

93 celica won't start


On my 89 gt it would die going down the highway at 75, it ended up being the throttle position switch. As for not starting I'd look into the ignition. Mine went out and Ive bypassed a push-to-start button through the firewall because I don't even want to deal with the steering coloumn.

Sep 06, 2008 | 1993 Toyota Celica

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...