Question about Chrysler Cars & Trucks

1 Answer

2002 chrysler sebring transmission wont shift

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    A rookie expert who has answered 20 questions on their first day.


    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 101 Answers

Need to check the speed sensors

Posted on Nov 26, 2013

4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 15 Answers

SOURCE: 08 Chrysler Sebring Transmission

I assume that you have to press the brake pedal in order to shift from park (ie:safety switch) you might first check to see if you have brake lights as they should be on the same circut and operated by the same switch. If the lights dont work, check the fuses could be a simple fix. Hope this helps

Posted on Jun 25, 2009

  • 10 Answers

SOURCE: My Chrysler Sebring won't shift out of park

there is a spring on the left side of the shifter which has probably broken off it a common problem with a no cost fix as long you can find the spring. the spring attachs to the black case of the shifter and the other end goes to a pink plastic pivot to the interlock. drill a small hole in the pink upper pivot to reattach the spring. your spring would have shot off toward the back of the car inside the console check at the carpet's edge.the spring has a green protective band and is about an inch long ---to get the console out 4-- 10mm bolts at rear inside the back console compartment and 2--10mm bolts behind the a/c controls. the a/c control bezel and the upper bezel do not have screws but push in place--top bezel pulls straight out while the lower has to be pulled down and out to remove

Posted on Aug 10, 2009

  • 1986 Answers

SOURCE: my 2002 Chrysler Sebring LX Convertible had the

The check engine light came on probably because it detected an error with your car. In this case, it sounds like the error is with your transmission. Most likely a bad solenoid. Bring the car to a place like Autozone where they will scan your car for free to retrieve the code(s) that will point to where the issue is.

Posted on Sep 15, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 01 chrysler sebring wont shift into any gears

Check that the shift linkage is connected at the trans, if it is, put some transmission fluid in it after checking the dipstick while running in neutral with brake on.

Oct 12, 2014 | 2001 Chrysler Sebring

1 Answer

2002 Chrysler Concorde does not move for 15-20 seconds after shifting from reverse to forward. Primarily after vehicle has been sitting for several hours. What is and how do I fix the problem? Fluid is...

possibly transmission filter clogged and when hot and sediment loosens it gets easier for fluid to flow for valves(in transmission)to work better??. Also, I used to have a Chrysler product van and I found out it was a vacuum activated valve by the transmission.

Dec 21, 2013 | 2002 Chrysler Sebring

2 Answers

2001 Chrysler Sebring does not shift. I can put it in reverse and drive and it runs, but it does not shift out of first gear. Speedometer still works. Transmission fluid shows that levels are fine.

might be a pluged filter in the transmission check that and it could not hurt to take it to a transmission shop to have them run a trouble code on the tranny

Aug 31, 2009 | 2001 Chrysler Sebring

2 Answers

1999 chrysler sebring, transmission doesnt shift

find out why the light is on and fix it. This will most likely be a trans wiring issue that the light is on for.

Jul 11, 2009 | 2004 Chrysler Sebring

1 Answer


if you dont have some kind of warranty try to put and aditif in the trasmission it will lub the body valve of trasmission and hopefully it gonna solve our problem if not$$$$$$$$$$$$$$$$$$$ thank you pierre from montreal

Jun 23, 2008 | 2002 Chrysler Sebring

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides