Question about 2001 Ford F250 Super Duty Super Cab

1 Answer

Oil leak front upper driver side off engine

Oil leak from driver side upper section off engine 7.3 diesel 2001 f250

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

There's a galley plug behind the accessory mounting bracket in the head this plug has a large O-ring that goes bad needs to be replaced. This galley supply's oil to the injectors and is under high pressure when running. It will make a mess when you replace it and it is a lot of work to get all the stuff off to get to it probably should do the one on the other side while your at it. Also this will make the truck hard to start (gas on a rag will make it start easier either is too unpredictable) after the repair and run rough for a little while as you will be introducing air into the system it will work itself out after a good drive. I believe the plug has a 1/2 inch square drive hole in it.

Posted on Dec 08, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: 2000 ford f250 super duty 4x4 7.3L diesel oil leak

The HPOP (high pressure oil pump) is right under the filter housing. There are 2 lines that distribute the oil to the cylinder heads. The o-rings on those fittings go out. Kit is available from Ford or International. You will need a special wrench to get to the fittings though.

Posted on Jun 23, 2008

  • 497 Answers

SOURCE: water in fuel system of a Ford F250 diesel engine.

there is an additive at most auto parts stores and even some gas stations, i forget the name but if you read the bottle it will say something about removing water from the fuel system, they are generally located next to the "octane booster" or "fuel system cleaners"

Posted on Aug 09, 2009

  • 64 Answers

SOURCE: oil leak on top front of 2002 f350 super duty diesel engine

if it's a diesiel the it's coming from your oil line to your turbo. if it is gas then it could be a leak coming from a leaking valve cover gasket.

Posted on Aug 23, 2009

  • 142 Answers

SOURCE: 2001 Ford f250 supper duty diesel Problems

head gasket

Posted on Sep 23, 2009

  • 180 Answers

SOURCE: F250 Diesel engine won't start in cold weather

check your glow plug relay! located on the right side head

Posted on Mar 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cylinder 5 placement?


if you have the V8 gas engine, the cylinders on the passenger side from front to back are #1 #2 #3 #4 the cylinders on the driver side are from front to back #5 #6 #7 #8. if you have a V6 gas engine the cylinder placement is passenger side from front to back #1 #3 #5 the cylinders on the drivers side are from front to back #2 #4 #6. if you have a diesel V8 engine the cylinder placement is passenger side from front to back #1 #3 #5 #7 drivers side from front to back #2 #4 #6 #8 and last but not least if you have the V10 the cylinder placement is passenger side from front to back #1 #2 #3 #4 #5 and driver side from front to back #6 #7 #8 #9 #10.

Dec 24, 2010 | 2001 Lincoln Town Car

2 Answers

93 FORD TAURUS SHO 3.2 ENG WHERE IS THE OIL PRESSURE SENSOR?


If you're in front of the car facing the engine, it's on the front upper right side of the engine just to the
right of the temp. sensor. Hope this helps.

Nov 20, 2010 | Ford Taurus Cars & Trucks

2 Answers

I have a 2002 Ford F-250 Diesel 7.3 litre Super Duty truck. It is leaking oil from an area beneath the fuel filter. What part would I need to repair this leak?


there are 2 high pressure lines that attach to the high pressure pump near the front of the engine left side. the o rings leak. I would get them from the dealer, or a shop that does a lot of Diesel work. Its not a easy job.

Aug 31, 2010 | 2002 Ford F250 Super Duty SuperCab

1 Answer

I have a 2001 f250 7.3L turbo diesel. The truck starts and runs for about 100 to 200 feet and then starts to rough idle and dies, after turning the engine over for about 10 to 15 seconds it will start and...


Sounds like you may have a high pressure oil leak, if you check the oil resevoir level before you start the truck you may find it low or empty. Its located at the front of the engine in front of the fuel filter housing, there should be a threaded plug you can remove to look in, if its empty or looks low, fill it up with the proper oil and put the plug back and try it then, if its ok now, you likely have an oil leak, typically failed o-rings on one or more injectors. You can buy injector o-ring kits but its a fairly involved job, I am a Ford Diesel tech and it usually takes me about 3 hours to replace all the o-rings on all 8 injectors, first time for someone who's never done it will probly be closer to 5 or 6 hours.

Aug 15, 2010 | 2002 Ford F250 Super Duty SuperCab

1 Answer

Ford f250 stalls when driving down the road,


What year... What engine? need info..... If it is a diesel with 7.3 L engine it is most likely the cam sensor. When it cranks does the tack work? that is another sign of a cam sensor It is on the front of the engine just to the right of the harmonic balancer top side. Replace it with a black one. Also could be in your IPR if diesel.

May 12, 2010 | 2001 Ford F250 Super Duty Super Cab

1 Answer

Leak under truck looks like diesel fluid. it looks like a straw it comming out of,but it metal.it located at the front bottom of the engine


is this a diesel engine? and did you have the filter changed recently because the fuel filter is located at top of engine in the front.in any case open hood and look you will find a black plastic round filter case check it for leakage.its right on top in eye sight.

Jan 07, 2010 | 2001 Ford F250 Super Duty Super Cab

1 Answer

2001 dodge 2500 diesel oil leak in front of power


The power steering pump is piggie backed to the vacuum pump. The seal in the back of the vacuum pump has engin oil under presure behind it cousing a leak that gets worse over time. Cummins make a seal kit to fix this leak.

Dec 26, 2009 | 2001 Dodge Ram 3500 Truck

1 Answer

Oil leak on a 2001 7.3 liter powerstroke


my 7.3 f-250 diesel is leaking a lot of oil and in a short time . I cant find where its leaking ? I just washed the motor and waiting for it to dry and look again/. The pan on top by filter was full of oil before i washed it.

Oct 05, 2009 | 2001 Ford F250 Super Duty Super Cab

1 Answer

04 f250 diesel cranks but won't start


this is an oil pressure problem, either a sensor is not sensing enough oil pressure, or the high pressure pump is not building enough pressure(possibly leaking or head is leaking). this engine requires 450 psi minimum oil pressure at the injectors to actuate the injectors.

Mar 22, 2009 | 2004 Ford F250

1 Answer

Oil leaking from oil cooler line


Check the o-rings in the female side.

Dec 18, 2008 | 1995 Ford F250

Not finding what you are looking for?
2001 Ford F250 Super Duty Super Cab Logo

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...