Question about 2003 Ford ZX2

Open Question

Where is the shift solenoid on 2002 ZX2 ford escort

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: starting schematic 2002 ford escort zx2

my 02 zx2 did the same when i first got turns out the ground was loose in the fuse box under the hood. it should be on the drivers side.

Posted on Dec 03, 2008

greg_margo
  • 1959 Answers

SOURCE: routing of serpentine belt for ford escort zx2

Click on the link below, Enter the year,make,model, and engine. You will get a page with a link to the diagram you need under the part number.
Greg

http://www.mvreader.com/multiview/dayco/index.php?autoCatalogSearch=0&catalog=auto&l=n&year=2000&year_from=&year_to=&make=FORD

Posted on Jun 17, 2009

SOURCE: how do I change my oil on my 98 ford escort zx2

Try this.

On level ground, jack up the front of the car and support it with axle stands.

Get an open container that will take more than 5 ltrs.

Under the engine block you will find the sump.

On the sump you should find a 13mm nut, this is the drain plug.

Undo the drain plug and have the empty container directly below the sump plug.

Retain the sump plug and clean it with a rag.

When the oil has drained out of the sump, put back the plug making sure the washer is in good condition and the plug is tight.

Now unscrew the oil filter having the old oil container below the filter housing to catch any oil.

Wipe around the the filter housing to remove any and all old oil.

Now offer up the new oil filter but do not tighten.

If the new filter fits the oil filter housing, then remove it and lightly oil the rubber seal on the filter with clean oil.

Now refit the filter and tighten it up. Not too tight, you can do this by hand but get it as tight as you can.

Now lower the car to to the ground.

At the top of the engine you will find an oil filler cap. Undo this cap.

Now put in the new oil to just below the full mark on the dip stick. Let the oil drain through the engine to the sump for a couple of minutes before checking the oil level.

If the level is between 1/2 and full, replace the filler cap and start the engine.

Now look at the oil filter and the sump plug for any leaks. Also check around the oil filler cap for oil leaks and spillage.

With the engine turned off. Clean any oil spillages and tighten up the oil filter, sump and oil filler cap as required.

Now leave the oil to drain back to the sump for a few minutes.

Check the oil level and top up as required.

I find that it is best to top the oil up to just below the Max mark.

This should solve the problem.

Ray



Posted on Aug 28, 2009

moparownr
  • 667 Answers

SOURCE: 2002 Ford Escort ZX2 serpinten belt routing & tensioner pulley

go to www.gates.com on the lower right hand side under popular topics, click on timing belts, then on the left hand side click Parts Locator and Interchange, enter your cars info and the first page that comes up will show you a camera icon for a pic of how your belt is routed. The tensioner pulley is the one mounted on a silver arm, usually at the top. Hope this helps let me know.

Posted on Sep 22, 2009

  • 34 Answers

SOURCE: 2002 Ford Escort ZX2 where is the map sensor

the map sensor is located on the intake manifold usually on the back of it to the right

Posted on Nov 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Serpentine belt diagram 2002 Ford escort zx2


The picture is for a zetec. Let me know if wrong diagram?
26017169-0d1su300qx55v1h5u01lpo5r-3-0.jpg

Dec 21, 2015 | Ford Cars & Trucks

1 Answer

2002 ford zx2 - dash and park lights out, where do i find the fuse for both to replace.


this 2002 Ford Escort ZX2 should have an owners manual in your glovebox

if not, here's a link in pdf form for it!

http://www.fordservicecontent.com/Ford_Content/catalog/owner_guides/02estog3e.pdf

now scroll to page 123 to see the diagram

look at TAIL ~ 15 amp blue fuse

this is inside the passenger compartment, not the one in the underhood bay

Fuse box location in 1998 Ford Escort

mark as helpful since i do this for fun only (not for profit) thanks!

1997 2003 Ford Escort Interior Fuse Check 2002 Ford Escort ZX2 2 0L 4 Cyl

Apr 18, 2015 | 2002 Ford ZX2

1 Answer

My car goes forward in reverse why?


adjust shifter to correct

Apr 20, 2013 | 2002 Ford ZX2

1 Answer

I need a 2002 ford zx2 4 cylinder engines serpentine belt diagram so i can find the tinchner


Check this for Ford Escort ZX2 2.0L (click image for zoom)...

zjlimited_1697.jpg


Additional details and other diagrams could find in THIS LINK: diagrams/ford/escort/2002

Hope helps.

Aug 08, 2011 | 2002 Ford ZX2

1 Answer

Approx How much should I expect to pay to repair a shift solenoid for a 2001 Escort ZX2? It shifts fine once use a ballpoint pen to get it out of park. Thank you,


Should'nt be over 1 hr,Labor Most shops charge a 1 hr. min. Good luck to you, As for price it depends on the hourly rate your shop charges,

Apr 01, 2011 | 2001 Ford Escort ZX2

1 Answer

P0751 ford escort zx2 2001


Shift solenoid A performance or stuck off.

Have you lost a gear or gotten stuck in a gear? The shift solenoids are inside the valve body. You'll have to remove the transmission pan and take the filter out. Inside you'll see several bolts and a flat pan. Remove the bolts and please remember their locations as they are not all the same. It may be helpful to draw a patter onto a box and put the bolts in the same pattern. Once you have the valve body out you can see all of the solenoids, they have electrical connectors. Test the terminals between each one for its' resistance and let me know what it is and I'll let you know which one is bad. The fun part is finding one.

Nov 22, 2010 | 2001 Ford Escort ZX2

1 Answer

2001 Escort ZX2: it wont go out of park...


There is a safety lock-out that keeps you from taking the car out of gear if you don't push the brake. If your brake lights still work then the switch is good. Also, some people have reported that if the high mount brake light is bad it will keep the car from being shifted out of park. If all of your brake lights work then the solenoid is bad. Remove the center console to get to the solenoid. Since the solenoid is expensive most people just zip-tie the solenoid open so that you don't have to push the brake to shift it from park.

May 16, 2010 | 2001 Ford Escort ZX2

1 Answer

What would cause the switch in the center console to not allow the car to be put in gear


A shift solenoid is in the console. That solenoid operates upon when your foot depresses the brake pedal to shift

Mar 19, 2010 | 2001 Ford Escort ZX2

1 Answer

2002 ford escort zx2 camshaft sensor fit a 99 zx2?


Yes, All the years of the ZX2 utilize the same engine. 1998-2003 are all the same except for ECU programing and the MAF wiring. You should not have a problem.

Apr 07, 2009 | 2002 Ford ZX2

1 Answer

Manual Transmission fluid for Ford Escort ZX2


I know this sounds crazy according to Ford:

You can use-
Motorcraft MERCON Multi-Purpose (ATF) Transmission Fluid XT-2-QDX MERCON® Alternative Transaxle Fluid - SAE 75W90 Gear Oil F32Z-19C547-MA API GL-4
You are seeing that right, one instance they call for 75W90 and the other it is ATF. It is ok to run either, 75W90 will give you smoother shifts and less noise.

This transmission is filled through the VSS (Vehicle Speed Sensor) hole.

Mar 28, 2009 | 2001 Ford Escort ZX2

Not finding what you are looking for?
2003 Ford ZX2 Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...