Question about Honda Odyssey
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
When a cylinder mis-fires there is a reason. The dealer should have told you that. Most likely you have a fouled out spark plug. Which means you need new spark plugs and maybe wires. All this would be covered in a standard tune up. Once the bad spark plug is replaced, the computer will quit registering a mis-fire. Please give good ratings, they meen a lot to us.... Thank you
Posted on Aug 01, 2009
P0420 relates to the catalytic converter. The computer sees little or no improvement in the exhaust before and after going through the converter. Either your oxygen sensors need replacement (3 total) or you need a new catalytic converter.
What is the mileage on the vehicle? Does it run well? Oxygen sensors generally start to fail after 70,000 miles. Catalytic converters usually fail because the engine is runnig rich and the owner ignores that fault for months. This causes the catalytic converter to overheat and fail.
P1456 relates to the evaporative emission system. This system holds the gas fumes in the system so they are not vented to the atmosphere. The most common cause of this code being set is failing to properly tighten the gas cap after refueling. Take the cap off and clean the sealing O-ring. Put it back on and tighten till it clicks 3 times. Make sure you have the correct gray colored gas cap. Clear the code and see if it resets within a few days. If it does, try replacing the gas cap.
Posted on Jun 26, 2008
The code is either on the inside of your glove box or on a card in your owners manual. if not there then you need to phone the honda dealer that the vehicle was purchased new and ask them to do a search for you on E biz
Posted on Dec 17, 2008
open the rear hatch. Between the tail light housing and the rear hatch opening there is a trim strip with two flush fitted flap doors. Insert a small straight blade screwdriver into the small slot on the tail light side of the flap. Pry gently inboard and the small flap will open (the hinge side of the flap is on the side of the rear hatch opening.) Now you can remove the screws that hold the tail lamp assembly in place. Finally, there is still a "spear point" clip that fits into a socket near the front outboard corner of the assembly. Gently pry with a tape wrapped screwdriver (avoids scratches) and force the assembly straight back. The clip should release and free the assembly so you can change the bulb(s).
Posted on Jan 24, 2009
Tips for a great answer:
Aug 26, 2014 | 2001 Honda Odyssey
Apr 08, 2014 | 1999 Honda Odyssey
Apr 16, 2013 | 1995 Honda Odyssey
Nov 17, 2012 | 2002 Honda Odyssey
Mar 17, 2011 | 2001 Honda Odyssey
Aug 03, 2009 | 2001 Honda Odyssey
Jun 21, 2009 | 2001 Honda Odyssey
Jun 14, 2009 | 2001 Honda Odyssey
May 12, 2009 | 2001 Honda Odyssey
210 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: