Question about 1997 Mitsubishi Galant

Open Question

Where is located the computer on a mitsubishi galant 1997?

Where is located the computer on a Mitsubishi gallant 1997

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017



may be it is the engine that good condition...

Posted on Jul 14, 2008


SOURCE: alarm is defective

need to take it in its got a fault probably cause by the weather

Posted on Jan 09, 2009

  • 1 Answer

SOURCE: reset radio 1997 mitsubishi galant

I had a 1997 Mitsubishi Galant, and I had this problem. My radio had a tape deck. The model type of my Radio was MR238340.
To do this Job you will need a medium sized phillips head screwdriver.

First of all you will need the radio code. To get this you need the model type and serial # of the radio. these are printed on a label on the top of the radio. To get the numbers pop off the cover plate aroung the gear shift. Yo will see 2 screws on the radio side of the gear shift. Remove these. The faceplate around the radio and the ashtray will pop off. There might be wires connected to the rear defog button and the cig lighter. I did not remove these. I just pulled the faceplate back as far as I could to get to the radio. Remove the 4 screws holding the radio to the console. I found a diagram with pictures on how to do this on the internet. I did not have to pull the radio out completely to get the numbers, only about 1&1/2 inches. the label was on the front left side of the top of the radion. Write down the serial # and the model number (usually starts in MR). With these numbers you can call the service dept of your local Mitsu dealer and they will give you the number over the phone.

The second step is to get rid of the off message. If you are like me you tried and failed to enter the wrong code and after the third try you got locked out. To be able to re- enter the code leave the radio on with the off message for 1 hour uninterrupted, and you will be prompted to re-enter the code. Enter the code using the first four numbers (radio station preset buttons). So to enter the first number press the # 1 button until you see the desired # ( the numbers will count up 1, 2, 3 etc.) . The enter the second # by pressing the #2 button. Enter the third with #3 and so on. Once all 4 numbers are entered the manual tells you to hit button #4. THEY DO NOT MEAN THE #4 BUTTON. In the service manual (which may still be in your glove compartment) you will see a diagram of the radio, and they have assigned each button a number. My number 4 button was the top button of 3 vertical buttons on the left hand side of the tape deck. It had a word on it, (tape? maybe). once you have entered the 4 numbers hit this button and the radio should work.

Mitsubishi wanted $98.00 to do this repair when I called. One person I spoke to would not give me the code and said I had to bring the car in. I called the next day and spoke to someone else in the service department who got me the number in 3 minutes for free. There are web sites that will get you your code provided that you have the model type and serial number, but they charge $20 to $40. I'm not cheap, but I am broke, and this fix was not that difficult. I am not a mechanic, I barely have a pulse, and I did this. You can too.

Posted on Mar 27, 2009

  • 1 Answer

SOURCE: transmission filter location,2002 mitsubishi galant?

my 02 galant is leaking but all fluids a full

Posted on Dec 28, 2009

  • 7353 Answers

SOURCE: P0705 Transmission range sensor circuit

The sensor should be located where the shifter cable is attached to the trans. It will have a plug with several wires. Usually there will be a way to align it, like a hole with a pin when it should be in neutral.

Posted on Jan 17, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1997 Mitsubishi Gallant Radio UNLOCK CODE

I have a 1997 mitsubishi galant i have the serial number's off the radio and some other number's i need the code to punch in so radio will work please help

Nov 18, 2010 | 1997 Mitsubishi Galant

2 Answers

2005 gallant with O2 sensor engine light is do I fix it?

have the engine light code scanned, and it'll tell you if it's bank 1 sensor 1, bank 1 sensor 2, bank 2 sensor 1, bank 2 sensor 4.

Bank 1 is on the same side as Cylinder 1
Bank 2 is on the opposite side of Cylinder 1

Sensor 1 is located before the catalytic converter.
Sensor 2 is located after the catalytic converter

Sep 11, 2009 | 2001 Mitsubishi Galant

1 Answer

My 2001 mitsubishi gallant quit running, acts like it is out of gas

try cheapest first; change fuel filter, if that doesn't work try fuel pump, if that doesn't work, it may be the fuel injection system, either the computer part of it or the mechanics of it

Aug 14, 2009 | 2001 Mitsubishi Galant

1 Answer

Location of a sensor

Replacing a CPS can be easy or hard. On the 2002 Gallant 2.4, it is located behind the timing belts. Removal of the main pulley, the covers and the belts is required. This isn't as hard as it sounds and is essentially the same as changing the timing belts.

Apr 20, 2009 | 2002 Mitsubishi Galant

1 Answer

How to change the bank 1 sensor 1 on 2002 mitsubishi gallant

it means the oxygen sensor closest to the exhaust man. is bad , replace

Mar 15, 2009 | 2002 Mitsubishi Galant

2 Answers

What kind of antifreeze for a 2004 Mitsubishi Galant?


Feb 02, 2009 | 2004 Mitsubishi Galant

2 Answers

Mitsubishi Galant Gdi 1.8 1997 Japan Import. Computer and Fuel fl

emc is located on the floor behind the center console. the fuel filter is under the hood near the firewall

Jan 11, 2009 | 1997 Mitsubishi Galant

1 Answer

Belts replacement for Mitsubishi gallant (1997)

Is your engine a 4 or 6 cylinder? Air conditioning or no? Either way, a power steering belt at Auto Zone will run you from $7.99 to $12.99. If replacing that does not help, it may be your pump.
HOWEVER, before anything else, PLEASE CHECK THE FLUID LEVEL IN THE POWER STEERING RESERVOIR. It may be low. If so, just add fluid to the correct level.:)

Dec 24, 2008 | 1997 Mitsubishi Galant

Not finding what you are looking for?
1997 Mitsubishi Galant Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides