Question about 2006 Chevrolet Cobalt

Open Question

How to change my thermometer back from celcius to fahrenheit on 2006 chevy cobalt

2.2 engine

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: 2006 chevy cobalt woulnt start lock light is on

Are you using the original key that came with the car? The chip in that key may have gone bad. Try using the spare key that should have come with the purchase of the car. You may also be having battery issues. If all else fails....call the people who really know how to rape you...DUM Dum dummmmm....the dealer

Posted on Dec 31, 2008

Ad
emissionwiz
  • 78936 Answers

SOURCE: How do I change transmission fluid in 2006 Chevy

jack the car up and remove the trans pan (12 bolts I think), inside you will find the filter replace it, after u finish refill with the exact same amount of fluid (about 3-4 quarts of Dexron 6 ATF) and then recheck hot, don't overfill...

Posted on Jun 13, 2009

SOURCE: how do i change the car battery for 2006 cobalt?

the battery is located in the trunk under the carpet where the spare tire is located, loosen the 10 mm nuts on the terminals and pull them off, gently pull the vent hose from the battery, loosen the bolt for the battery hold down, usually a 13mm or 15mm, remove battery and reverse the process to install

Posted on Jun 19, 2009

  • 98 Answers

SOURCE: 2006 chevy cobalt - door won't open

Start with the basics. Check the fuses (all of them) with a test light and be sure you have power to each and that they are good. Then be sure that the power lock relay is good by swapping it with another relay in the fuse block. If the fuses are good and the relay is swapped and the locks still aren't functioning, you may have an issue with the BCM. The BCM can be programmed to change the behavior, but if the car has had water damage, or other stress to the BCM (voltage, heat, etc.), it can sometimes damage the BCM and you will need to replace it and reprogram it at a GM dealership.

Posted on Jul 25, 2009

  • 124 Answers

SOURCE: Fan switch does not work in the 1, 2, 3, position 2006 Cobalt

You have a problem with the blower motor resistor. This is a very commen problem on all gm cars and light trucks. The part is not to pricey. You can find the resistor under the glove box buy the blower motor. Two bolts and out it comes.

Posted on Sep 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Remove and replace an outside door handle on a 2006 Chevy colbalt?


the following quote is taken from the web site from a chevy cobalt forum. if you have any more questions they might be able to help you directly.
(all it is is 2 bolts. Just take off your door panel and pull back the protective plastic and look for 2 bolts that line up with the door handle.)

How Do You Replace The Outside Door Handle Chevy Cobalt Forum Cobalt...

Jan 30, 2015 | 2006 Chevrolet Cobalt

1 Answer

How to switch from fahrenheit to celcius?


Best to just keep a conversion chart nearby...or label your gauge with Celcius...

Aug 23, 2014 | 1991 Buick Park Avenue

1 Answer

No crank signal


Change the ECM too if they can exchange. Your car controlled by ECM so see this work.

Dec 19, 2013 | 2006 Saturn Vue

2 Answers

How do i fix the check engine light code p0128 on my 2006 chevy cobalt ss


engine light came on once before plugs changed went away now back on steady this time not blinking has loss of power with pedal to floorboard then comes in but when comea to a stop idles like going to die

Mar 02, 2010 | 2006 Chevrolet Cobalt

3 Answers

Engine light came on on 06 chevy cobalt erased with scanner but there is again and again


THE CHECK ENGINE LIGHT COMES ON BECAUSE THE CAR RUNS A SYSTEM CHECK AND SOMETHING IS FAILING. UNTIL YOU ADDRESS THE PROBLEM IT WILL KEEP COMING BACK ON( HINT) REPLACE THE GAS CAP IT IS THE MOST COMMON CAUSE

Feb 14, 2010 | 2006 Chevrolet Cobalt

1 Answer

How to change the temperature from fahrenheit tot


just push and hold button and it should ask you what you want to do if that does not work refer to manual or call a toyota dealer and ask

Dec 21, 2009 | 2006 Toyota 4Runner

2 Answers

I cant figure out how to change my thermometer back from celcius to fahrenheit


Make sure that the odometer is set to miles and not kilometers. Hold the button down (while in the regular odometer setting, not the "trip odometer" setting) until it changes to miles. The temperature display will automatically change to fahrenheit. We just figured this out today.

Aug 23, 2008 | 2006 Ford Freestar

1 Answer

Inside temp


Go to mechanic shop oreven your local library you'll find it there.

Jun 23, 2008 | 2006 Mazda 6

Not finding what you are looking for?
2006 Chevrolet Cobalt Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

78936 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...