Question about Cars & Trucks

Open Question

Wiring diagram for vr holden aeb295 sprint gas

Fuel gauge always on empty

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

MikenAsh
  • 32 Answers

SOURCE: gas gauge

The float that moves the gas hand is possibly stuck in the tank. If there's isn't an access hole in the rear of the vehicle you'll have to drop the tank. Unless it becomes free on it's own. Hope this is helpful. Please rate. Thanks

Posted on Sep 28, 2008

gameslayer
  • 6 Answers

SOURCE: 96 Dodge Ram Gas Gauge always on empty

The fuel pump and the sensor is altogether as one assembly. So if you buy the pump you would also be buying the sensor. Just for your information the pump is located in the gas tank under the bed, so you have two ways to change it. One is take the bed off (which is a lot easier if you have a full gas tank). But if its empty than use a jack to lower the tank down from underneath the truck. I hope this helps.

Posted on Jan 12, 2009

gregr_41018
  • 43 Answers

SOURCE: Fuel gauge goes to empty when I know there is still a 1/2 tank of fuel.

sounds like a faulty float on the fuel pump not sending the correct signal to the guage. if helpful please rate

Posted on Apr 19, 2009

  • 1 Answer

SOURCE: 2006 Chevy Trailblazer fuel gauge stays on empty

It requires a new fuel tank sensor that is $600 for the part.

Posted on Aug 28, 2009

  • 1 Answer

SOURCE: 2005 kia sorento Fuel Gauge says empty with 1/2 tank of gas.

Fuel sensor is not working well. Just changed mine today for the same problem.

Posted on Jun 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Renault master 2001,fuel light always on and fuel gauge always on empty regardless how much fuel I put in, the needle does flicker when I turn the engine on. presume its the fuel sensor, does any one have...


usually on top of gas tank wires going to it test by disconnecting wires ground a test lite and probing wires one by one and one will pulse glow this is the one you need to watch the gauge should start going up when probed

Sep 21, 2013 | Renault Cars & Trucks

2 Answers

Gas gauge


see the diagram attached and fix it. God bless you
2c862184-4cb0-43d1-9ad7-a77186c44a5d.jpg

Jul 24, 2013 | 1999 Dodge Stratus

1 Answer

Gas hand reads full all the time


Fuel gauge may be the problem, but may also be a short in wires going to fuel gauge
Battery power goes to gauge in dash then to resistor in tank to ground. If the wire going to tank is shorted to frame it will always read full. Test this by disconnecting the wire going to the tank. If it goes to empty then you know the reason, either resistor in tank is bad or wire shorted.
.

Feb 23, 2013 | 1991 Cadillac Fleetwood

1 Answer

1984 Ford F150 Fuel gauge reads empty


I would bet the sending unit is bad but lets check it, a good test i use is that i have a used sending unit i connect to wiring to test the gauge and wiring, if the gauge moves when i move the testing unit then i know the gauge is good and the wiring to, locte the connector at fuel tank, and unplug it, this will be the one the leads to top of the tank and the connector will be on the side be the frame on drivers side, the way you know you have the right connector will be the truck will not run as this connector has the sending unit and pump wires in it, if the gauge goes to full then you know the wiring is good and the gauge is good, you can jump the two wires and gauge should go to full also. the problem is you must get the right wires for sending unit or you may pop fuse, let me see if i can get you a wiring diagram or just do the full test by unplugging connector.

Okay, your sending unit has a yellow and white wire, thats the sending unit wire, the other is a ground and we wont worry about that. so if you want to see if gauge will go to empty or full just unplug connector and gauge will move to full then if you take a wire and jump the yellow wire with white stripe to a good ground the gauge will go to empty, the thing is your gauge is on empty so sending unit may be grounded out, good day10_21_2012_4_15_34_pm.gif

Oct 21, 2012 | 1984 Ford F 150

2 Answers

2004 Ford Taurus, Tach and fuel gauge going crazy


Ford 150 Van No Start No Crank Same problem aftermarket remote start problem !
Watch the second part too . Do you know what a wiring diagram is ? Look under dash or the hood an see where the remote start is hooked up , what wires ! You can find a wiring diagram here at http://www.bbbind.com/free_tsb.html Enter the vehicle info. year , make , model an engine size . Under system click on engine , then under subsystem click on starting . Click the search button , then on blue link . You'll see all the componets in the starter circuit .

Apr 11, 2017 | 2004 Ford Taurus

1 Answer

2003 chevy malibu gas gauge always on empty, replaced the fuel pump


Need to replace the sensor inside the gas tank. I have a 2008 Malibu with the same problem. It was a faulty fuel gauge sensor.

Jan 31, 2012 | 2003 Chevrolet Malibu

1 Answer

My gas gauge is always on "empty." Even after I


Fuel level sending unit. that is the most common problem with these vehicles that cause the gauge to quit working

Jun 03, 2011 | 1992 Ford Taurus

2 Answers

Gas Gauge not working all the time.


SOUND LIKE FUEL LEVEL SENDING UNIT FAULTY.

Jun 15, 2010 | 1997 Chevrolet S-10 Pickup

2 Answers

Trying to find a diagram for 1985 grand marquis fuel wiring. My gauge isn't working know and reading Empty.


u don't need a diagram, just replace the gas tank fuel gauge sending unit, that is always the problem in your model.

Mar 17, 2009 | 1985 Mercury Marquis

1 Answer

1999 Monte Carlo fuel gauge stopped working


Hi there. If the fuel gauge is the only one acting up, its probably a loose or corroded wire on top of the gas tank where the fuel pump sets in. It could also be a loose wire on the back of the gauge, which is easier to get to so you could always check that first by popping off the dash pannel and pulling out the instrument cluster and looking for a broke wire on the back of the fuel gauge. But if I had to bet I would guess its on the other end by the fuel pump. Worse case sinario, maybe a bad sending unit.

Mar 14, 2009 | 1999 Chevrolet Monte Carlo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...