Question about 2008 Buick Enclave

Open Question

How do i reset the low tire warning light on a 2008 buick enclave

Tires have good pressure light will no go out

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: LOW TIRE PRESSURE WARNING LIGHT

Turn ignition to run position,go to fuse panel right hand of vehicle,push and hold reset button for 5 seconds,low pressure light will flash 3 times,start car it should turn off the low pressure light.

Posted on Jan 29, 2009

  • 1 Answer

SOURCE: low tire light came on - tire pressure ok

Because of changing outside temps this happens, just hold reset button on left side of dash until it reads tire pressure 100% again, just make sure your pressure is right before you do it. this is the same for oil changes and the like.

Posted on May 21, 2009

KCGTODAD
  • 169 Answers

SOURCE: 1999 buick centry low tire light on. how do you reset?

1. Remove the fuse panel cover, located on the right hand side of the dash (you have to open the front right hand passenger door). It comes off easily, it is held in place by three spring clips. Be careful when pulling this off, that you don't disengage the spring clips from the panel door, because they will fly off into the dash, and you won't be able to get them out. Replacement clips are about 70 cents each at the Buick dealer, but they will only sell them in a bag of 20, so do the math. Lose the clips, it will cost you about $16 with tax to replace them. I know because I did this :( 2. Start your car, and with the engine idling, locate the RESET button on the fuse panel where you've removed the fuse panel cover. It's a red button, the first one on the top row of the fuse block. Press and hold the RESET button for five seconds. The "low tire" light should come on and flash three times, then go out. If it doesn't, you'll have to take your car to the dealer or other repair shop for service. 3. Replace the fuse panel cover, and you're good to go! BTW, this information is on pages 6-42 and 6-43 of your Owner's Manual. :)


Hope this helps and good luck!

-KC GTO Dad

Posted on Sep 18, 2009

Testimonial: "thanks this is what i needed to know"

  • 96 Answers

SOURCE: I have a 99 Buick Regal, my low tire is staying on

open the passenger side door,

There should be a little panel on the dash that covers the fuse panel.

Pull the cover off.

Turn the key to the run posistion.

Press and hold the button in the passenger side fuse panel that says RESET.

The Low tire light should flash 3 times then go out.

It will now have to go thru a re-learn procedure, which will do it's thing while you are driving around. Just make sure all the tire pressures stay at the correct level.

Posted on Jan 29, 2011

Ironfist109
  • 3018 Answers

SOURCE: how do i reset the

  • Follow these steps
  1. Turn the vehicle off while holding the mode button on the information center until it says "Low Tire Pressure Press To Reset"
  2. Then press and hold the "set" button until the chimes go off and you see "Tire Pressure Reset."
  3. The chimes should then sound three times and "Tire Pressure Normal" will display.
  4. That's it.
  • Do this only AFTER you fill the tire so it will recognize the level as being low compared to the pressure after you filled the tire.

regards, Tony

Posted on May 17, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 Lexus ES 350 low tire pressure warning light blinking


It seems to me you may need to replace the low pressure sensor located inside the rim.

Oct 03, 2016 | 2008 Lexus ES 350

1 Answer

How do I reset the tire pressure system manually??


If you are referring to the TPMS light (warning light), there isn't one. The procedure requires the use of a system (computer) called the GDS (Global Diagnostic System). Only the Hyundai Dealerships have this system (proprietary). If you are referring to a 'Low Tire Pressure" warning light, simply raise the pressure in each tire to the manufacturer's recommended minimum pressure (psi - between 30 & 35 psi). The low tire pressure light will turn off after 5 minutes of driving.

Feb 10, 2011 | 2008 Hyundai Elantra

1 Answer

My child away at college, has a Rav4, 2008 with a warning light on that looks like "tire tread?" Just had the oil changed 2 weeks ago, so shouldn't have anything to do with that. Sound familiar?...


That symbol (tire tread) could mean a low tire pressure. The majority of vehicles today have the low tire pressure warning system, which indicates that one or more of the tires are below the minimum tire pressure. Have the tire pressure checked in each tire. As for turning the warning light off, some vehicles the light will go out after tires are inflated properly. Have them check the owner's manual for resetting warning light. Please inform me as to whether or not it was the tires...thanks.

Nov 14, 2010 | 2008 Toyota RAV4

2 Answers

DEASH LIGHT LOOKS LIKE A TIRE WITH ! IN CENTER


Low tire pressure warning. 2007 and up vehicles have a TPMS (Tire Pressure Monitoring System). Refer to your owners manual.

Sep 30, 2009 | 2008 Toyota Tacoma

1 Answer

Changed right front tire now reads zero on dash light is on


Your tire pressure monitor needs to be reset whenever you change or rotate your tires...

1. check and make sure that your tires are inflated to the correct pressure

2. turn the ignition switch to the ON position. If the low tire pressure warning light comes on, push and hold the tire pressure warning reset switch (think the switch is in the glovebox, but not sure) until the warning light turns off and then release the switch.

3. now press and hold the tire pressure warning reset switch until the low tire pressure warning light blinks three times.

4. initialization is *not* completed until driving at the vehicle speed of 19 mph or over for more than one hour. the tire pressure monitoring starts when initialization is completed.

Aug 24, 2009 | 2008 Chevrolet Tahoe

3 Answers

The check tire pressure light and ABS auto traction sensor light keep coming on. Tire pressure is good


The tire pressure monitor detects any changes in the tire inflation pressure. Therefore, it must initialize and store it in its memory if the tires or wheels have been replaced, re-inflated or the tires have been rotated. You should be able to re-initialize the system by following these steps:

1. check and make sure that your tires are inflated to the correct pressure

2. turn the ignition switch to the ON position. If the low tire pressure warning light comes on, push and hold the tire pressure warning reset switch (think the switch is in the glovebox, but not sure) until the warning light turns off and then release the switch.

3. now press and hold the tire pressure warning reset switch until the low tire pressure warning light blinks three times.

4. initialization is *not* completed until driving at the vehicle speed of 19 mph or over for more than one hour. the tire pressure monitoring starts when initialization is completed.

Aug 11, 2009 | 2004 Cadillac Deville

1 Answer

Reset Tire pressure monitor


disable tire pressure monitor 2008 buick enclave

Jul 10, 2009 | 2008 Buick Enclave

1 Answer

How do you reset a low tire pressure warning on a 2008 Jetta?


Reset the tire pressure warning, same as you would any service issue. Insert key in ignition, hold wrench button and min button, then start engine.

Apr 30, 2009 | 2007 Volkswagen Jetta 2.5 Sedan

2 Answers

08 CALIBER ORANGE WARNING LIGHT ON, CANNOT FIND OUT WHAT IT IS


this would be a low tire symbol have you tire pressure check it will come on when one off your tires get a little low. the light will reset itself after the proper tire inflation is put in ..thanks for choosing fixya

Mar 03, 2009 | 2008 Dodge Caliber

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...