Question about 2005 Buick LaCrosse
When you turn the nob to heat it wont blow warm or hot air
Blend door actuator stuck or vaccume came dissconected. Could also be low on coolant
Posted on Nov 26, 2013
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: heater core replacement
OK, Ifound the problem with mine. Dont unplug your air dryer. I checked the 2 hoses coming out from the heater core and still one was hot and the other not hot. The top one comes from the radiator fill tank and the bottom one comes out of the core and goes around to the front and into the water pump. I disconnected both close to the core and could runwater through both directions so upon further examination, I disconnected the hose at the water pump and no water flow. The hose was plugged up with something. Once I cleared it with a hanger and reconnected it I had water flowing through the core and great heat. Hope this is your problem too as it is aneasy fix
Posted on Oct 23, 2008
SOURCE: blowing cold air via the heater
Assuming that none of the Electrical/Electronic controls were disturbed when changing the Thermostat it seems to me that you have an "Air Lock" within the heater. One must purge all the air out of the cooling system as close to the highest point as possible after the system has been partially or fully drained. Most of the time one will find small BRASS Bleeder Valves located somewhere near the highest point. Open each one while the system is pressurized and let Air escape until some Coolant escapes. Sometimes it may be necessary to loosen a Heater Hose and bleed the air at that point. Remember that the system MUST BE PRESSURIZED to accomplish the Bleeding of Air. Many auto parts stores sell hand pumps with a pressure gauge for this purpose and leak testing. These pumps typically replace the Radiator Pressure Cap temporarily. The system does not have to be at normal operating temperature to bleed the air out. Once the Air has been bled you will have to refill the radiator to normal full and make sure that the Coolant Recovery Tank level is also brought up to recommended level. A quick check is to remove the Radiator Pressure Cap, Start the Engine, Rev the engine suddenly (A short Jab) and see if the coolant level falls rapidly in the radiator. If it does it is definitely an AIR LOCK situation.
Posted on Nov 19, 2009
Testimonial: "Thank you, I'll do the quick jab test to determine the air lock and proceed with bleeding"
Tips for a great answer:
Jan 28, 2016 | 2005 Hyundai Tucson
Jan 27, 2016 | 2000 Chrysler 300M
Nov 22, 2012 | Cars & Trucks
troubleshoot this types of problem,click the link below :---
Car heater blowing warm, but not hot air?http://schematicsdiagram.blogspot.com/2011/12/car-heater-blowing-warm-but-not-hot-air.html
Engine Overheats and heater blowing cold?
Heat blows cold on drivers side and hot on passenger side?
No heat on car? http://technoanswers.blogspot.in/2012/02/no-heat-on-oldsmobile-silhouette.html
Heater blows intermittently and temp gauge goes erratic?
Heater blows cold?
Heater/AC blower motor not working?
A/C, heater, defroster fan, not working? http://technoanswers.blogspot.in/2012/02/ac-heater-defroster-fan-not-working.html Heater problem?
This will help.Thanks.
Mar 27, 2012 | 1994 Volvo 960
Sep 05, 2011 | 2007 Suzuki SX4
Dec 15, 2009 | Dodge Ram 2500 Cars & Trucks
Oct 22, 2009 | 1998 Ford Taurus
Oct 17, 2009 | 1998 Ford Taurus
Mar 20, 2009 | 2003 Chrysler Town & Country
380 people viewed this question
Usually answered in minutes!