Question about 1994 Ford Ranger Supercab
What are the torque setting for the valve covers?
40" pounds not 40' lbs
i would do them at 25" lbs. followed by the 40 in. lbs also do every other bolt studer step so it will seat the gasket evenly.
Posted on Nov 25, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Oil Leak Valve Cover
If it is leaking around the valve cover then that is the problem. Just remove the bolts from the valve cover in a cross pattern (ex. back right - front left and go back and foward and work till you make it to the middle. Go purcahse a valve gasket for both right and left and replace them. Tighten in the same cross pattern and be careful no to pinch the gasket.
Posted on Feb 15, 2009
SOURCE: torque specs for valve cover
not sure there is such a thing. I've never seen anybody use a torque wrench on valve cover bolts. Just use a nut driver (screwdriver type) or a 1/4 inch drive ratchet, and tighten as much as you can. They don't need to be very tight.
Posted on May 04, 2009
SOURCE: Torque settings on a 1999
There are 2 different tranmissions in this vehicle. Make sure you know which one you have when selecting the torque settings. Do notice the 5R55E pan bolts are tightened in inch pounds. 4R70W Torque convert drain plug. 21-22 ftlb Pan bolts 9-11 ftlb 5R55E Pan bolts 115-133 inlb Ford Rear end Pan bolts 33 ftlb
Posted on Jun 05, 2009
Here is the spec for 1977 through 1984 on
the Ford 300 or so called now the 4.9 engine:
Cylinder head bolts: 70-75 lbs. The sequence is driver's side starting on bolt one (fifth bolt in line of bolts or center of line of bolts) and going straight across to bolt 2 on passengers' side and then to the side of bolt 2 is bolt 3 and back across to bolt four to the right of bolt 1. This is done in a zig -zag pattern until all bolts are torqued to recommended torque.
segon s version
13 9 5 1 4 8 12 torque specs are in three steps
11 7 3 2 6 10 14 1) 55lbs 2) 65lbs 3) 85 lbs
all info from the book
Posted on Sep 25, 2010
Tips for a great answer:
Apr 24, 2017 | Dodge Cars & Trucks
Nov 06, 2015 | Cars & Trucks
Jul 24, 2015 | Dodge Cars & Trucks
Jul 14, 2015 | Cars & Trucks
Sep 14, 2014 | 2001 Mazda Protege
Aug 11, 2012 | Cars & Trucks
Nov 13, 2011 | Cars & Trucks
Feb 12, 2011 | 1997 Dodge Stratus
Jul 22, 2010 | 1983 Chevrolet Impala
Apr 11, 2010 | 2002 Dodge Stratus
86 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: