Question about Ford F-350

Open Question

Turn signal/hazard flasher location 1986 e350

Need location of flashers both turn and hazard

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
fixincars
  • 335 Answers

SOURCE: Turn Signal Flasher

58940048Its behind the center of the dash under the Ashtray U need TORX screwdrivers to take out the screws got to take off nearly all over the under dash plastic trim.
Contact me if you need more help Thanks

Posted on Jul 31, 2008

Ad
  • 20 Answers

SOURCE: location of flasher for turn signal

  1. Access the COMBINATION Turn Signal and Hazard INDICATOR FLASHER on the Left-Hand (drivers) side of the instrument panel in the fuse junction panel.
  1. Remove turn signal flasher/hazard indicator flasher by pulling indicator flasher straight out.
  1. To install, align the terminals of the flasher and press into place.
How about a picture--

388df46.gif

Posted on Nov 23, 2008

  • 1 Answer

SOURCE: 1994 devilles flasher location

Turn signal flasher module is behind dash left of steering column near chime module. I have a 94 Seville and I had that same problem you need a Turn Signal Flasher Moduel, I forgot the proper term for it but I had to get mine replaced too. When I hit the signals to turn the side light would come on but the signal light wouldn't. Its a little box you get from Cadillac it only cost like $20 - $25 and you get it installed and trust. It'll work again. I just got mine done this week and my car now has turn signals again.

Posted on Dec 15, 2008

  • 272 Answers

SOURCE: 1997 sonoma turn signal flasher

The flashers are located behind the instrument panel trim, roughly between the base of the steering wheel and the ashtray, just to the left of the car lighter. To access the flashers, you need to at least loosen the lower instrument panel trim. Just under the steering column there are two screws with star heads. One to the left of the column and one to the right. You need to remove both of these screws. You will need to remove your ashtray. On the upper left corner of the hole left by removing the ashtray is a 9/32 hex head screw. You need to remove it. Once these three screws are removed you should be able to pull down on this portion of trim under your instrument cluster. When you do this it may cause trim around your instrument cluster to loosen that you can just pop back into place with your hand. You won't need to pull down to far on this trim piece as there are still some screws holding the bottom. You should be able to pull it down far enough to see the flasher units behind and just to the left of the cigarette lighter. There are two flasher units and I found that the one on the right is for the turn signals.On the left the other is for the hazard flashers. It may be a hand scraping experience to replace the flasher but it beats paying someone to do it for you. They are easy to recognize because the are silver and round metallic plug ins. The flasher unit on the left is for the emergency flashers and the one on the right is for turn signals. You can place the emergency flasher unit into the slot the turn signal unit belongs until you get a replacement. These flasher units are pretty cheap.

Posted on Jun 02, 2009

  • 4369 Answers

SOURCE: where is the turn signal\hazard flasher located?

it's in the auxiliary relay box behind the glove box.

13350 is base part number on flasher

Posted on Feb 03, 2010

Testimonial: "Actually found it located behind the radio mounted on a brace. Removed cover and relay pulls out. About 1" cube with 5 terminals on it."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can you please tell me where is the turn signal flasher on a 1986 oldsmobile cutlass supreme brougham


On 1980 and later models, both the turn signal flasher and the hazard flasher are located at the lower left hand and the upper right hand corners of the fuse block respectively. Remove these by pulling them from their connectors.
The lower dash panel may have to be removed to gain access to the unit.


26295825-zph2pj5z4kfac3kr23sxzldg-4-0.gif

Sep 29, 2016 | 1986 Oldsmobile Cutlass Supreme

1 Answer

1985 LeSabre flashers work turn signals don't need location of turn signal switch or are they one of the same


You mean turn signal flasher? No, the hazard flasher and turn flasher on older cars were separate. Often, the hazard flasher was right of the steering column (under the dash), and the turn flasher was left of the column. Look for two similar canisters. Turn the hazard lights on and locate the hazard flasher by feel or hearing. The turn flasher will be the other one. They both may be retained by metal clips.

Sep 16, 2015 | Cars & Trucks

1 Answer

Location of flasher on a 2006 ford e350 ecoline wheelchair van


Under the steering column on driver side by the fuse box you will see a round metal or plastic button like device when you turn the blinker on should make the blinking sound once? Keep turning it on and off until you locate the flasher? Note: there are two flashers one is hazard and the other is turn signal! Make sure your hazard flasher blinks after you unplug the turn flasher so you know you have the right one located?

Mar 29, 2014 | 2003 Ford Crown Victoria

1 Answer

Cant find flasher for turn lightswhereis it


1986 Mercury Grand Marquis 5.0L FI 8cyl. the Flasher is located in front seating area, driver side, under dash, driver side of steering column, mounted in fuse panel (turn signal) and front seating area, driver side, under dash, driver side of steering column, mounted in rear of fuse block (Hazard flasher).

Jun 13, 2011 | 1986 Mercury Marquis

1 Answer

My turn signals went out and i cannot locate the flasher, i located my hazards flasher, but i need to locate the turn signal flasher


they both use the same flasher ,try changing the hazard light switch as they do go wrong and then the flashers stop working

Jan 05, 2011 | 1992 Chevrolet Lumina

1 Answer

1986 Grand Marquis..........can not find the location of the fuse panel to change the signal flashers


1986 Mercury Grand Marquis 5.0L FI 8cyl. the Flasher is located in front seating area, driver side, under dash, driver side of steering column, mounted in fuse panel (turn signal) and front seating area, driver side, under dash, driver side of steering column, mounted in rear of fuse block (Hazard flasher).

Hope helps (remember to rate and comment this).

Sep 23, 2010 | Mercury Grand Marquis Cars & Trucks

1 Answer

When the blinker is flipped up or down on the column the tail lights dont respond. But the brake lights and the hazards still work fine. Whats the problem?


The turn signal flasher relay may have a problem.Turn on the hazards and follow the clicking sound to the source and usually the hazard flasher and turn signal flasher are very close to each other.Remove the one that is clicking and put it in place of the turn signal flasher.If the Turn signals then work you will need to purchase a new turn signal flasher relay.They are usually just a few dollars.

Jul 29, 2010 | 1986 Ford F 250

1 Answer

Fix a flasher


Replacement The turn signal flasher is located under the dash either to the left or right of the steering column on most models. The lower dash panel may have to be removed to gain access to the unit. The hazard flasher is located in the fuse block.On 1980 and later models, both the turn signal flasher and the hazard flasher are located at the lower left hand and the upper right hand corners of the fuse block respectively. Remove these by pulling them from their connectors.


Mar 06, 2010 | 1986 Oldsmobile Cutlass Supreme

3 Answers

Where does the flasher go on a 98 chevy malibu


Replacement The turn and hazard flashers are integrated into one flasher on these models. The flasher is located in the hazard warning switch and the hazard warning switch is located on the trim plate. Replace the flasher by unplugging the old one, removing it from the panel, and plugging in the new one.
  1. Remove the bezel from the ignition switch.
7f58edd.gif
Remove the bezel from the ignition switch

Carefully remove the instrument panel accessory trim plate.

9f5c3cc.gif
To remove the trim plate, use a suitable prytool to carefully apply pressure at the retaining clip points . . .

bd28884.gif
. . . then gently pull the accessory trim plate away

Detach the electrical connector from the hazard warning switch.

daa6205.gif
Unplug the electrical connector from the hazard warning switch . . .

Unfasten the screw securing the hazard warning switch and remove the switch.

c506713.gif
. . . then unfasten the screw securing the hazard warning switch and remove the switch from the vehicle


Installation is the reverse of removal.

Dec 01, 2009 | 1998 Chevrolet Malibu

1 Answer

2002 e350 7.3 power stroke i have no signals or hazards


There is s flasher that controls the signals and 4-ways. You need to replace the flasher.

Jul 29, 2009 | 2002 Ford E350

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

153 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...