Question about 2002 Jeep Grand Cherokee Limited

1 Answer

Changed flasher relay in grand cherokee, had flashers before and turn signals worked occasionally, now nothing

Turn signals working intermittently, worked most of the time in warm weather. changed the relay which worked and now no turn signals or flashers

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 20,706 Answers

Test the combo switch,
get the schematic,
then with a voltemeter probe the input to combo and output.
if imput is good, and output is bad the switch is bad.
alldata.com has the schematic.
the FSM even walks you step by step to each test.

Posted on Nov 25, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: turn signals

replaced turn signal flashers and muti switch turn signal still won't work Why?

Posted on Nov 11, 2008

emissionwiz
  • 76164 Answers

SOURCE: Turn signals not working on 2001 Jeep Grand Cherokee

replace the turns signals flasher unit.

Posted on Mar 02, 2009

wikkidd420
  • 96 Answers

SOURCE: 1995 Jeep Grand Cherokee Limited - flasher relay location

More than likely you have a bad ground. Under the rear of the vehicle, behind the rear bumper there will be a few wires running to a bolt in the frame (left side i think) Check that no wires are loose or boken. Also if you have a trailer wiring harness, check to see if it has not been damaged. Let me know if this helps :)

Posted on Apr 30, 2009

  • 1 Answer

SOURCE: my signals and flasher quit working 2002, Jeep

in your vehicles owner manual, look up fuses, and flasher units or flasher relay. Fuses are normally located under the dash, but when both turn signals quit working it is usually the relay. The relay is located under the hood yours owners manual should show you the location.

Posted on Oct 27, 2009

  • 1 Answer

SOURCE: turn signals hazards flasher don't work jeep

I NEED TO LOCATE THE SWITCH WHERE IS IT ?
MY INDICATORS NOR HAZARD LIGHTS ARE WORKING I DONT KNOW WHAT IS WRONG WITH IT CHANGED BULBS BUT NOTHIGN THEY ALL WENT OUT AT THE SAME TIME
SO THERE MUST BE A RELAY SWITCH SOMEWHER BUT DONT KNOW WHERE ?
THANKS FOR HELPING

Posted on Apr 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why are my blinkers working i changed the flasher and the switch on steering column i have a1987 nissan v-6 se 4x4 trvuck?


See troubleshooting basic turn signal and flasher problems

www.procarcare.com/includes/content/.../ch14/14TSTurnSignals.html
Most problems in the turn signal or flasher systems can be reduced to ... Occasionally, problems in the turn signals are traced to the switch in the steering column, which ... One turn signal light on one side doesn't work Check and/or replace bulb. ... Often the filaments have been reversed In systems combining stoplights with ...

where is the flasher(turn signal relay)located ... - CarGurus

www.cargurus.com > Questions > Chevrolet > Cavalier

CarGurusApr 17, 2007 - Emg. flashers work but L/h and R/h signals dont. ... How do I get that cover. off my steering wheel? ... How to change Flasher Fuse 4 answers.

Turn Signal Switch Replacement - YourMechanic


Dec 15, 2015 | Nissan Cars & Trucks

1 Answer

Turn signals do not work but flashers do


There should be a flasher for the hazards and another for the turn signals.

Sep 04, 2012 | 1996 Jeep Grand Cherokee

1 Answer

1999 jeep grand cherokee - rear driver turn signal and brake light don't work. flasher, back up and running light works. everything works when lens assembly is plugged into the passenger side. can...


Check this diagram (click over pic for zoom)...

zjlimited_1040.jpg

Check the postion F4 / 15 Amp ( Lt. Blue ) Flasher, hazard switch (see Junction Block diagram above for location of turn signal Flasher relay - Mopar p/n 4686094)

Repair tip: WJ flasher repair.

Hope helps.

Apr 16, 2011 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Turn signals dont work most of the time. i cant find the flasher module


your Flasher/turn signal relay are malfunction,it suppose to have a regular clicking sound everytime you use the flasher/turn signal switch, you need to replace with a new one,but you need first to check your bulbs, the RELAY located on the left driver side under the dashboard, or turn your flasher so that you can here the clicking sound....

Feb 05, 2011 | 2002 Jeep Grand Cherokee

1 Answer

My signals and flasher quit working 2002, Jeep Grand Cherokee


in your vehicles owner manual, look up fuses, and flasher units or flasher relay. Fuses are normally located under the dash, but when both turn signals quit working it is usually the relay. The relay is located under the hood yours owners manual should show you the location.

Oct 27, 2009 | 2002 Jeep Grand Cherokee

2 Answers

Turn signals hazards flasher don't work jeep cherokee replaced combination flasher relay, turn signal switch and still no signals


I NEED TO LOCATE THE SWITCH WHERE IS IT ?
MY INDICATORS NOR HAZARD LIGHTS ARE WORKING I DONT KNOW WHAT IS WRONG WITH IT CHANGED BULBS BUT NOTHIGN THEY ALL WENT OUT AT THE SAME TIME
SO THERE MUST BE A RELAY SWITCH SOMEWHER BUT DONT KNOW WHERE ?
THANKS FOR HELPING

Sep 27, 2009 | 1999 Jeep Cherokee

2 Answers

Turn signal and flasher wont work


locate the silver flasher and replace it.most of the time it can be found on the fuse box or under the dash around the steering wheel area.

Jul 24, 2009 | 1999 Jeep Grand Cherokee

Not finding what you are looking for?
2002 Jeep Grand Cherokee Limited Logo

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...